Benutzeranleitung / Produktwartung T96695IH des Produzenten AEG
Zur Seite of 28
LAVATHERM 96695IH EN User Manual.
CONTENTS 1. SAFETY INFORMATION................................................................................................. 3 2. SAFETY INSTRUCTIONS................................................................................................ 5 3.
1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
• If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. • Obey the maximum load volume of 9kg (refer to the “Programme chart” chapter). • Do not use the appliance if industrial chemicals have been used for cleaning.
1.2 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability. • This appliance can be used by children aged from 8 years and above and persons with reduced .
• Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • Do not touch the mains cable or the mains plug with wet hands. • Only for UK and Ireland. The appliance has a 13 amp mains plug. If it is necessary to change the fuse in the mains plug, use a 13 amp ASTA (BS 1362) fuse.
3. PRODUCT DESCRIPTION 1 2 7 3 4 5 6 9 10 1 1 12 8 1 Water container 2 Control panel 3 Internal light 4 Appliance door 5 Filter 6 The button to open the heat exchanger door 7 Airflow slots 8 Adjustabl.
4. ACCESSORIES 4.1 Stacking kit Accessory name: SKP11, STA8, STA9 Available from your authorized vendor. Stacking kit can be used only with the washing machines specified in the leaflet. See the leaflet attached. Read carefully the instructions supplied with the accessory.
It is available from your authorized vendor (can be attached to some types of the tumble dryers). Do the check with the vendor or on the web site if the accessory is compatible with your appliance.
For accurate selection touch the centre point of the area between the vertical marks. Do not wear gloves when you touch the panel to set the function. Make sure the panel is always clean and dry.
Symbol on the display Symbol description , - anti-crease phase duration: default, interval (30min. - 120min.) - - - - laundry was spun at: 800 — 1800 rpm default Symbol on the display Symbol descrip.
Programmes Load 1) Properties / Fabric mark Jeans 9 kg Leisure clothing such as jeans, sweat-shirts of different material thicknesses (e.g. at the neck, cuffs and seams). / Bed Linen 3 kg To dry bed linen such as: single and double sheet, pillowcase, bed- spread.
Programmes Load 1) Properties / Fabric mark Wool 4) 1 kg To dry the cloths made of wool . The cloths be- come soft and cosy. We recommend to remove the cloths immediately after the programme end. To increase or to decrease the level of the remaining moisture of the laundry you can use the function Dry Plus.
Options Programmes 1) Dry Plus Anti- crease Spun at RPM Time Drying Extra Silent Extra Quick Mixed Synthetics; Extra Dry Synthetics; Cupboard Dry Synthetics; Iron Dry Easy Iron Active Wear Sports Silk/Lingerie Wool 2) 1) Together with the programme you can set 1 or more options.
- the selection to get the laundry lightly dried. - the selection to get the laundry more dried. 7.2 Anti-crease Extends anti-crease phase (30 minutes) at the end of the drying cycle to 90 minutes. This option prevents laundry from creases. Laundry can be removed during the anti-crease phase.
8.2 Clock The first time you turn on the dryer the default time comes into the view on the display. You can confirm or change it. To set the different time: 1. Turn the programme dial to set new hour. 2. Touch the Start/Pause field. The hour is memorised.
• if the Start/Pause field was not touched in the time of 5 minutes. • after 5 minutes from the programme end. Push the On/Off button to turn on the appliance. If the appliance is on, some indications come in to the view on the display. 9.5 Setting a programme Use the programme dial to set the programme.
S e n s i D r y Memory 1 Memory 2 Extra Silent Start/Pause Delay Start Time Dry Buzzer Spun at RPM Dry Plus Anti- crease If the configuration is saved you see the message on the display. To use your own configuration: 3. Turn on the appliance. 4. Touch the Memory 1 or Memory 2 field.
S e n s i D r y Memory 1 Memory 2 Extra Silent Start/Pause Delay Start Time Dry Buzzer Spun at RPM Dry Plus Anti- crease One of the symbols goes into the view on the display: - the maximum dry laundry - the more dry laundry - the standard dry laundry 5.
11. CARE AND CLEANING 11.1 Cleaning the filter At the end of each cycle the symbol Filter is on the display and you must clean the filter. The filter collects the fluff. The fluff occurs while the cloths are dried in the tumble dryer. 1. Open the door.
2. Move the plastic connection out and drain the water into a basin or equivalent receptacle. 3. Move plastic connection in and install water container.
6. If necessary, remove the fluff from the heat exchanger and its compartment. You can use wet cloth and/or a vacuum cleaner with the brush. 7. Close the heat exchanger cover. 8. Lock the blockage until it snaps. 9. Put the filter back. 11.4 Cleaning the drum WARNING! Disconnect the appliance before you clean it.
12. TROUBLESHOOTING Problem 1) Possible cause Remedy The tumble dry- er does not op- erate. The tumble dryer is not connected to mains supply. Connect in at mains socket. Check fuse in fuse box (domestic installa- tion). The loading door is opened. Close the loading door.
Problem 1) Possible cause Remedy Abnormally elapsing time on the display. The time to end is calculated on the basis of the volume and damp- ness of the laundry. The automatic procedure — this is not the appliance malfunction. Programme in- active. The water container is full.
Necessary fuse 13 A Total power 900 W Energy efficiency class A++ Energy consumption 1) 2,28 kWh Annual energy consumption 2) 259 kWh Left—on mode power absorption 0,50 W Off mode power absorption 0.
> 85 0 mm 60 0 mm 60 0 mm 15. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances.
ENGLISH 27.
www.aeg.com/shop 136931100-A-112014.
Ein wichtiger Punkt beim Kauf des Geräts AEG T96695IH (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie AEG T96695IH noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für AEG T96695IH - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von AEG T96695IH reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über AEG T96695IH erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon AEG T96695IH besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von AEG T96695IH verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit AEG T96695IH. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei AEG T96695IH gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
