Benutzeranleitung / Produktwartung CRD-42 des Produzenten Roberts Radio
Zur Seite of 40
Please read this manual before use ROBER TS Sound for Generations ® DAB / FM RDS digital clock radio with dock for iPod model CRD-42.
Controls ........................................................................... 2-4 Remote handset battery replacement .................................5 Using the clock radio for the first time ................................. 6 Operating your clock radio .
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 2 Controls (T op) 1. Snooze button 2. Play / Pause button 3. Fast-forward button 4. Rewind button 5. Sleep button 1 6. Alarm button 7. Menu button 8. Info button 9.
3 14. LCD display 15. Preset button 16. T uning Down button 17. Select button 18. T uning Up button 19. On / Standby button Controls (front) Controls (rear) 20. Dimmer switch 21. Wire DAB / FM aerial 22. Headphone socket 23. Line in (auxiliary input) socket 24.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 4 1. On / Standby button 2. Alarm button 3. Sleep button 4. Play / Pause button 5. Rewind button 6. Preset button 7. Tuning Up button 8. Select button 9.
5 Remote handset battery replacement 1. Remove the battery cover on the rear of your remote control by rotating the cover approximately 45 degrees in an anti-clockwise direction to align the dot on the cover with the "OPEN" marking on the remote control.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 6 Using the clock radio for the first time 1. Place your clock radio on a flat surface. 2. Fully extend the wire aerial located on the rear of your clock radio.
7 Operating your clock radio 1. Press the On / Standby button to switch on your clock radio. The display will show "TUNING" for a few seconds. When first switched on, the radio will be in DAB mode. After each use the radio will remember the mode used and then switch on in that mode the next time that it is used 2.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 8 Selecting a station - DAB 1. Press the On / Standby button to switch on your clock radio. The display will show "TUNING" for a few seconds. 2.
9 1 Secondary services - DAB 1. Certain radio stations have one or more secondary services associated with them. If a station has a secondary service associated with it then the secondary service will then appear immediately after the primary service as you press the T uning Up button.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 10 d. Multiplex Name Displays the name of the DAB multiplex to which the current station belongs. e. T ime and day Displays the current time (24 hour clock) and day of the week.
1 1 Finding new stations - DAB From time to time, new DAB radio stations may become available. Or you may have moved to a different part of the country . In this case you may need to cause your radio to scan for new stations. 1. Press and release the Menu button so that "MANUAL" shows on the display .
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 12 Manual tuning - DAB Manual tuning allows you to tune your radio to a particular DAB frequency in Band III. Any new stations found will be added to the station list.
13 Dynamic Range Control (DRC) - DAB The DRC facility can make quieter sounds easier to hear when your radio is used in a noisy environment. There are three levels of compression: DRC 0 No compression applied. (default) DRC 1 Maximum compression applied.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 14 Operating your radio - FM auto-tune 1. Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so a that it is as straight as possible extending vertically either above or below the radio.
15 Manual tuning - FM 1. Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so a that it is as straight as possible extending either above or below the radio. 2. Press the On / Standby button to switch on your clock radio.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 16 1 Display modes - FM Y our radio has a range of display options for FM mode:- The Radio Data System (RDS) is a system in which inaudible digital information is transmitted in addition to the normal FM radio programme.
17 1 2 4,6 Presetting stations Y ou may store your preferred DAB and FM radio stations to the preset station memories. There are 20 memory presets in your radio, 10 for DAB and 10 for FM. Presets are remembered by your radio in the event of a power failure.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 18 Recalling a preset station 1. Press the On / Standby button to switch on the radio. 2. Press the Mode button to select the desired waveband. 3. Press and release the Preset button .
iPod docking Y our clock radio has an iPod dock facility which allows you to play digital audio files and video soundtracks held on your iPod using the clock radio's loudspeakers. Y our radio uses the iPod Universal Dock connector developed for use with iPods.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) Navigating your iPod 1. T o navigate iPod menus to make selections or to change settings, you should use your iPod controls. The clock radio controls can be used for Previous / Next and Play / Pause functions.
Setting alarm times Y our clock radio has two alarms which can be set to wake you to DAB, FM radio, iPod item or beep type alarm. Each alarm can be set to sound once, daily , on weekdays or at weekends. The alarms can only be set when your clock radio is switched on and in DAB or FM mode.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 8. Press the Select button to enter the hour setting. The alarm minute digits will flash on the display . 9. Press the T uning Up or Down buttons to choose the desired alarm minute.
23 16. Press the Select button to enter the alarm month setting. The alarm day will flash on the display . 17. Press the Tuning Up or Down buttons to choose the alarm day . 18. Press the Select button to enter the setting. The alarm source option will flash on the display .
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 24 Cancelling alarms 1. While an alarm is sounding it can be cancelled by pressing the On / Standby button . 1 T o view the alarm settings 1. Press the On / Standby button to switch on the clock radio.
25 Snooze function 1. When the radio, iPod or buzzer alarm sounds, pressing the Snooze button will silence the alarm for the selected number of minutes. The Snooze duration can be adjusted between 5 and 20 minutes in 5 minute increments. The default setting is 5 minutes.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 26 Sleep function Y our clock radio can be set to turn off after a preset time has elapsed. The sleep setting can be adjusted between 5 and 90 minutes in 5 minute increments.
27 Setting the clock manually Normally your clock radio will set its clock automatically using the DAB radio signal. If no DAB signal is available and you need to set the time manually , please follow the procedure shown below . 1. Press the On / Stan dby butto n to switch on the clock radio.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 28 9. Press the Select button to enter the minutes setting. The year will then flash on the display . 10. Press the Tuning Up or Down buttons to change the year as needed.
T o return to auto clock set mode 1. Press the On / Standby button to switch on the clock radio. If necessary press and release the Mode button to put the radio into DAB mode. 2. Pres s an d rel eas e the Menu butt on to enter the setu p me nu. "MANU AL" will appear on the display .
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 30 Clock display 1. When your clock radio is in standby mode the time and day will be displayed. The time is always shown using a 24 hour clock format. Display backlight dimmer 1.
Software version The software display cannot be altered and is just for your reference. Ensure your clock radio is switched on and in DAB or FM mode. 1. Press and release the Menu button . 2. Press the Tuning Up or Down buttons until the display shows your clock radios software information.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 32 System reset If your radio fails to operate correctly , or some digits on the display are missing or incomplete carry out the following procedure. 1. Press the On / Stan dby butto n to switch on the clock radio.
Headphone socket A 3.5mm stereo Headphone Socket located on the rear of your clock radio is provided for use with either headphones or an earpiece. Inserting a plug automatically mutes the internal loudspeaker . IMPORT ANT : Excessive sound pressure from earphones and headphone s can cause hearing loss.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 34 Auxiliary Input (Line in) socket A 3.5mm stereo Auxiliary Input socket is provided on the rear of your clock radio to permit an audio signal to be fed into the unit from an external audio device such as iPod, MP3 or CD player .
Cautions Do not allow this clock radio to be exposed to water , steam or sand. Do not leave your clock radio where excessive heat could cause damage such as in a parked car where the heat from the sun can build up even though the outside temperature may not seem too high.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 36 The Company reserves the right to amend the specification without notice. Circuit Features Output Power 2 x 2.4 W att Headphone socket 3.5mm dia Auxiliary Input socket 3.
37 iPod is a trademark of Apple Inc., registered in the U.S. and other countries. "Made for iPod" means that an electrical accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below .
ROBERTS RADIO TECHNICAL SER VICES 97-99 Worton Road Isleworth Middlesex TW7 6EG T echnical Helpline: 020 8758 0338 (Mon-Fri during office hours) Website: http://www .
Ein wichtiger Punkt beim Kauf des Geräts Roberts Radio CRD-42 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Roberts Radio CRD-42 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Roberts Radio CRD-42 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Roberts Radio CRD-42 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Roberts Radio CRD-42 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Roberts Radio CRD-42 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Roberts Radio CRD-42 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Roberts Radio CRD-42. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Roberts Radio CRD-42 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
