Benutzeranleitung / Produktwartung ENC5304VDE des Produzenten Lennox Hearth
Zur Seite of 24
1 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. HOMEOWNER'S CARE AND OPERA TION INSTRUCTIONS VENTED GAS FIREPLACE HEATERS - DIRECT VENT MODELS P/N 875,021M REV. G 03/2007 MODELS FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors or liquids in the vicin- ity of this or any other appliance.
2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. CONGRATULATIONS! In selecting this LENNOX Direct-Vent Gas Appliance you have chosen the finest and most dependable fireplace to be found anywhere. A beautiful, prestigious, alternative to a wood burning fireplace.
3 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Carbon Monoxide Poisoning: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nau- sea.
4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 3 Honeywell Electronic Gas Valve Figure 2 Note: The piezo ignitor is located on the modesty panel - refer to Figure 1. Variable Flame Height Adjustment ( Millivolt Appliances only) 1. All Millivolt appliances are equipped with a variable gas control valve.
5 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Maintenance The appliance and venting system should be thoroughly inspected before initial use and at least annually by a qualified service techni- cian. However, more frequent periodic inspec- tions and cleanings should be performed by the homeowner.
6 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Periodically (After the Burning Season) Maintenance Task Accomplishing Person Procedure Cleaning Firebox Interior Check Flame Patterns and Flame Heig.
7 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ENSURE THAT THE FRONT GLASS PANEL IS IN PLACE AND SEALED DURING ADJUSTMENT. Figure 4 Burner Adjustments The following paragraphs address burner ad- justment concerns and procedures. Flame Appearance and Sooting Proper flame appearance is a matter of taste.
8 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Log Placement Carefully position the ceramic fiber logs and twigs over the burner as shown in Figures 6 (EDV3530), 7 (EDV4035) or 8 (EDV4540) on this page. Refer to the detailed log placement instructions provided in the LOG PLACEMENT GUIDE accompanying this document.
9 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 9 Electronic Appliance Checkout To light the burner, refer to the lighting instruc- tions on page 13 and 14 . Ensure the ignitor lights the pilot. The pilot flame should engulf the flame sensor as shown in Figure 10 .
10 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. These louvers are designed to replace the standard charcoal louvers that are provided with the appliance.
11 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Touch-Up Paint (Charcoal) Kit 90L74 TPK-C Touch-Up Paint (Tan) Kit 98K67 TPK-T Touch-Up Paint Kit Repair of minor scratches and discoloration of the appliance charcoal painted surfaces may be accomplished with the touch-up paint kit.
12 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Style View Doors - Style View Doors come in 4 beautiful styles. They are easy to install and will not require hardware to attach them to the standard glass door frame. The door includes heavy duty magnet door latches and functional twin-pane doors.
13 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ACCESSORY COMPONENTS CONTINUED T all Arch Pane Door Style View Doors Continued - Style View Doors also come in a T all Ar ch Pane Design. T wo distinctive grille kits, the “ Crescents ” and “ Sunrise ” design, are also offered seperately .
14 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WARRANTY Your gas appliance is covered by a limited twenty year warranty. You will find a copy of the warranty accompanying this manual. Please read the warranty to be familiar with its coverage. Retain this manual.
15 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTES:.
16 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. LIGHTING INSTRUCTIONS – MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING A. This appliance has a pilot which must be lighted with a piezo ignitor. When lighting the pilot, follow these instructions exactly.
17 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT INSTRUCTIONS D'ALLUMAGE POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE A. Cet appareil est muni d ’ une veilleuse qui doit ê tre allum é e avec un allumeur pi é zo- é lectrique.
18 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. A. When lighting the appliance, follow these instructions exactly. B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
19 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE — ELECTRONIC INSTRUCTIONS D’ALLUMAGE POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE A. Lorsque vous allumez l ’ appareil, suivez exactement ces instruc- tions.
20 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE MILLIVOL T GAS CONTROL SYSTEM 1. Spark ignitor will not light pilot after repeated triggering of ignitor button. 2. Pilot will not stay lit after carefully following the lighting instructions.
21 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE ELECTRONIC IGNITION SYSTEM SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION See Below. Disconnect the two black wires from the wire nuts. Test switch(s) for continuity with a multimeter.
22 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS LIST GAS CONTROLS — HONEYWELL ELECTRONIC GAS CONTROLS — SIT MILLIVOLT . o NN O I T P I R C S E D l a r u t a Ne n a p o r P . o N t r a P. y t Q. o N t r a P. y t Q . 0 3T I S - e v l a V s a G7 0 K 3 41 3 5 J 8 81 .
23 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS 4 8 14 7 41 40 31 30 43 33 32 34 42 36 35 16 13 2 5 6 2 3 17 18 19 11 9 1 12 21 10 15 20 EDV4035 & EDV4540 EDV3530.
24 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Printed in U.S.A. © 2003 by Lennox Hearth Products P/N 875,021M REV. G 03/2007 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
Ein wichtiger Punkt beim Kauf des Geräts Lennox Hearth ENC5304VDE (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Lennox Hearth ENC5304VDE noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Lennox Hearth ENC5304VDE - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Lennox Hearth ENC5304VDE reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Lennox Hearth ENC5304VDE erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Lennox Hearth ENC5304VDE besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Lennox Hearth ENC5304VDE verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Lennox Hearth ENC5304VDE. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Lennox Hearth ENC5304VDE gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
