Benutzeranleitung / Produktwartung 146.1622201 des Produzenten Kenmore
Zur Seite of 28
Use & Care Guide ® Liquid Propane Gas Grill Sears Model No. 146.16222010 Kmart Item No. 640-01303702-3 • Safety • Parts • Useand Care • Assembly This Grill is for OutdoorUseOnly • Read and follow all Safety, Assembly, and Use & Care Instructions in this Guide before assembling and cooking with this grill.
If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplieror your fire department. 1. Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance.
2 For Your Safety... Grill Service Center... Product Record Information ... Safety Symbols... Installation Safety Precautions ... Kenmore Grill Warranty... Use and Care... Parts List... Parts Diagram. Assembly... Troubleshooting .. 2 2 2 2 3 .4-10 ...
• NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. • Never fill a cylinder beyond 80% full. • If the information in the two points above is not followed exactly, a fire causing death or serious injury may occur.
LP Tank Exchange Connecting Regulator To The LP Tank • Many retailers that sell grills offer you the option of replacing your empty LP tank through an exchange service. Use only those reputable exchange companies that inspect, precision fill, test and certify their cylinders.
Holdcoupling nut and regulator as shown for proper connection to LP tank valve. Leak Testing Valves, Hose and Regulator 1.Turn all grill control knobs to OFF. 2.Be sure regulator is tightly connected to LP tank. &Completely open LP tank valve by turning OPD hand wheel counterclockwise.
For Safe Use of YourGrill and to Avoid Serious Injury: • Do not let children operate or play neargrill. • Keep grill area clear and free from materials that burn. • Do not block holes in sides or back of grill. • Use grill only in well-ventilated space.
If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with The valve open, gas will contiune to flow out of the burner and could accidently ignite with risk of injury Match-Lighting ADo not lean over grill while lighting.
CAUTION SPIDER ALERT! IMPORTANT: Always ensure that the venturi burner tubes are clean. A venturi burner tube has a narrow area in which spiders tend to build nests. If you notice that your grill is getting hard to light or that the flame isn't as strong as it should be, take the time to check and clean the venturi's.
Indirect Cooking Poultry and large cuts of meat cook slowly to perfection on the grill by indirect heat. Place food over unlit burner(s); the heat from lit burners circulates gently throughout the grill, cooking meat or poultry without the touch of a direct flame.
Key Qty Description ........... 1 2 ROTATE ROD,F/SIDEBURNER LID 2 1 SIDEBURNER LID 3 1 SIDEBURNER GRID 4 1 IGNITOR WlRE,SIDEBURNER 5 1 SIDEBURNER 6 1 SIDEBURNER BASE 7 1 RIGHT SIDE SHELF 8 1 FASCIA, F.
jf i J _2"640-01303702.3.58.
Before Assembly Open shipping box by slicing down its edges with a box cutter. Remove all packed grill parts and packing materials from the styrofoam support pieces. Obtain the aid of an assistant to remove the grill head from the support pieces. Place the grill head on its side; do not place it on its bottom or the grease tray could become bent.
/1 Bottom Shelf to Legs Place bottom shelf end with cut out hole for LP cylinder between legs with axle holes. Attach to right and left leg assemblieswith (6) M4xl0 screws. Do not fully tighten at this time. Cart will not be level. This will be corrected when the feet and wheels are installed.
The screwsused in this step: 1. 4pcsofM6x13screws: Wheels and Leg Extenders to Cart [] Turn assembly upside down. Align the bottom shelf side holes with leg holes. [] Attach sides of bottom shelf to four legs with (4) M6x13 screws, M6 lock washers and M6 flat washers.
Front Panel [] Stand cart upright. [] Attach back brace to top of cart with (4) M4xlO screws. (A) Do not fully tighten at this time. [] Attach one front panel to lower half of cart with (4) M4xl0 screws, and to bottom shelf with (1) M4xl0 screw. (B) IMPORTANT: Holes on top and bottom edges of front panels must be towards the left side of grill.
H Grill Head to Cart [] Stand cart upright. [] This step requires two people to lift and positiongrill head onto cart. [] Carefully lower the grill head onto the cart, Make sure the regulator hose and igniter wire are hanging outside the cart. Open lid and attach head to cart with (4) MGx13 screws and compression washers.
Left Side Shelf [] Slide 4 hooks onto push bar. Attach push bar to left side shelf with the (2) M5xl0 screws, M5 lock washers and M5 flat washers pre-assembled to the ends of the push bar. (A) [] Attach fascia to left side shelf with (2) M5xl0 screws, M5 lock washers and M5 flat washers.
RightSide Shelf [] Remove sideburner grate from sideburner before assembling and attaching the right side shelf. [] Attach fascia to right side shelf with (2) M5xl0 screws, M5 lock washers and M5 flat washers. [] Hang right side shelf onto the brackets on right side of firebox.
Sideburner [] Loosen side burner in side shelf. To loosen, unscrew and remove two front screws and washers holding sideburner in place. Note: Do not loosen electrode screw. [] Remove knob and bezel from sideburner control valve. To remove, pull knob straight out from valve stem.
Heat Diffusers, Cooking Grate and Warming Rack [] Place heat diffusers over burners by inserting tabs into slots in front and back of firebox.. [] Place cooking grates onto grate rests.
D [] [] [] Grease Cup Clip, Grease Cup and LP tank Hang grease cup clip from bottom of firebox and place grease cup into grease cup clip. Unscrewthe hose hook, place the hose of regulator inside the hook, then screw it back into place. LP tank is sold separately.
EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Sas leaking from ._racked/cut/burned hose. Sas leaking from LP ._ylinder. Sas leaking from LP ._ylinder valve. Sas leaking between LP ._ylinder and regulator .
Troubleshooting (continued) Burner(s) will not light using ignitor. (See Electronic Ignition Troubleshooting also) Burner(s) will not match light. ELECTRONIC IGNITION: • No spark, no ignition noise. • No spark, some ignition noise. • Sparks, but not at electrode or at full strength.
Troubleshooting- Electronic Ignition SECTION I No sparks appearat any electrodes when controlknob turned to ; no noise can be heardfrom spark module. Battery not installed properly. Dead battery. Buttonassembly not installed properly. Faulty sparkmodule.
26.640-01303702-3-58.
640-01303702-3-588,27.
Your Home For expert troubleshooting and home solutionsadvice: www.managemyhome.com For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself.
Ein wichtiger Punkt beim Kauf des Geräts Kenmore 146.1622201 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Kenmore 146.1622201 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Kenmore 146.1622201 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Kenmore 146.1622201 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Kenmore 146.1622201 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Kenmore 146.1622201 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Kenmore 146.1622201 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Kenmore 146.1622201. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Kenmore 146.1622201 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
