Benutzeranleitung / Produktwartung 850BI Series des Produzenten Jackson
Zur Seite of 25
Outdoor Gas Barbeque Owner’s Manual This manual is for use with 700, 700BI and 850BI series grills Warning: Please read and understand th e contents of this manual fully before operating. Failure to do so may result in fire or explosion. Homeowners should re tain these instructions.
2 TABLE OF CONTENTS: SAFETY. 3 LP GAS CYLINDER REPLACEME NT. 4-5 OPD EQUIPPED CYLINDER. 6 HOSE AND REGULATOR. 6 LEAK TESTING. 7 INSTALLATION. 8 CLEARANCES. 9 ASSEMBLY. 10-13 GETTING TO KNOW YOUR GRILL 14 LIGHTING INSTRUCTIONS. 15 GAS CONVERSION. 16-18 MAINTENANCE.
3 SAFETY: Your new Jackson G rill barbeque is a safe, conveni ent appliance when used and maintained properly. As with all gas-fired appliances, ce rtain safety precautions must be obse rved. Failure to follow these precautions may result in damage or injury.
4 LP GAS CYLINDER PLACEMENT: Cylinders must be installe d according to assembly instructions. Install the ga s cylinder into the tank hole inside of the Jack son Pedestal. LP GAS CYLINDER: QCC-1 Quick Closing Coupling Your grill is designed to be used with an LP gas cylinder equipped with th e new QCC-1 Quick Clos ing Coupling system.
5 HANDLING: 1. Government regulations pr ohibit shipping full LP gas cylinders. Yo u must take your new cylinder to an LP gas dealer for filling. 2. A filled LP gas cylinder is under very high pressu re. Always handle with care and transport i n the upright position.
6 OPD EQUIPPED CYLINDER: Effective January 1, 1998, the stan dard for outdoor g as appliances, ANSI Z21.58/CAN CGA-1.6, requires t hat appliances are to be used with cylind ers equipped with an Overfill Prevention Device (OPD).
7 4. Leak test the connection. See “leak test ”. 5. Refer to lighting in structions. To avoid activating t he Flow Limiting Device when lighting, op en the cylinder valve slowly with the appli ance valves off.
8 INSTALLATION: In Canada, this appliance must be in stalled in accord ance with the local code and relevant CGA standard s: CAN/CGA-B149.1 LP Gas/Propane Installation Code and latest codes where ap plicable. In the USA, this appliance must be installed in accord ance with the local code and relevant national code: ANSI Z223.
9 INSTALLING 700BI / 850BI INTO A NON COMBUSTIBLE ISLAND. ALL DIMENSIONS ARE IN INCHES : 700BI 850 BI A 32.5 39.5 B 9.25” 9.25” C 17” 17” D 10.25” 10.25” E 3” 3” F 17.25” 17.25” G 24.25” 24.25” H 24” min. 24” min. I 18.5” 18.
10 ASSEMBLY: Please ensure the proper tools are u sed for ease of installation. Some assembly will be required if this unit is installed in a pede stal. Please remove all compon ents from the packaging and inspect all compon ents to ensure there is no damag e to any components in the packaging.
11 Secure the Condiment Bins to the Display Panel using the screws from the securing plates. After the Side Shelves have been installed, ensure th e Grill Head is pushed back in the ped estal as far as possible.
12 Rotisserie Rod Bushing Placed on the cut out provided on the Inner Hood Rotisserie Kit Completed Installation Upper Flavor Shield, Cooking Grid Installation. Remove the Upper Flavor Shields form the Packaging . Please ensure that all protective plastic has b een removed from these parts.
13 Main Gas Line Connections for Propane Gas and Natural Gas. The main Fuel supply gas line is connected to a Mani fold Tee securely mounted inside the ped estal located on the left hand side of the pedestal. Remove the Propane hose and regulat or assembly from t he packaging.
14 Getting To Know Your Grill. 1 Outer Hood Handle 11 Pull Out Grea se Tray 2 Hood Ther mometer 12 Main Co ntrol Knobs / Display Panel 3 Outer Hood 13 Electronic Ignition 4 Cooking Grids 14 Side Burne.
15 H I M E D L O W H I M E D L O W MAIN BURNER LIGHTING To light the Main Burners always start with the Left Ha nd Burner first. Turn the Left hand Control Knob to HI and Depress the Igniter Button.
16 Operating The Rear Burner When operating the Rear Burner please ensure that the Warming Rack is REMOVED . The Warming Rack will become damaged if NOT removed while the Rear Infrared Burner is in use. The rear burner is spe cially designed to be used with the Rotisserie Kit, and shou ld ONLY be used when using the Rotisserie Kit.
17 4 Using a 13 mm wrench undo all of the main burner orifices from the unde rside of the Display Panel. Place then aside form any other orifices included in the Natural Gas Conversion Kit. 5 Using an approved thread sealant, replace the Main Burner Orifices with the NEW Natural Gas orifices supplied.
18 SIDE BURNER 1 Open the side burner lid and rem ove the grate over the burner head. 2 Undo the 2 Phillips head screws that hold the Flame Thrower (burner ignition) a nd VERY Carefully move away from the burner Head. 3 Undo the 3 screws that hold the Burner Head onto the Side Shelf base.
19 GAS LINE Remove the 3/8” flare fitting that attaches the propane ho se from the Manifold block inside of the pedestal and replace with an a pproved 10’ Natural Gas Hose neoprene hose.
20 FOOD SAFETY TIPS AND TECHNIQUES We want to enjoy healthy and safe grill cooking, so here are some tips for basic ba rbecue hygiene: Bacteria are living orga nisms that grow and multi ply rapidly in warm moist foods.
21 TROUBLE SHOOTING PROBLEM POSSIBLE CAUSES SOLUTION Low heat or lo w flame when valve turned to high. For propane – improper lighting procedure. Ensure lighting procedu re is followed carefully. All gas grill valves must be in the off positio n when the tank valve is turned on.
22 - PARTS LIST Part Number Part Description Quantity 1 07-400 Outer Hood 1 2 04-3403 Warming Ra ck Bracket 2 3 07-402 Hood Handle 1 4 07-4505 Thermomete r 1 5 07-403 Inner Hood 1 6 07-404 Rear Burner.
23 EXPLODED VIEW 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 41 42 25 1 2 3 4 5 6 7 8 12 2 14 18 50 26 28 9 10 11 13 16 24 30 30.
24 Jackson Grills Limited Lifetime Warranty Jackson Gri lls Inc. warrant s the follow ing materi als and wo rkmanship to be free of def ects for as long as you own the grill.
25 A special message to our customers Thank you for choosing th e Jackson Grill for your n ew gas grill. This applian ce is designed with quality components and we are confident that it will provide you with years of ex cellent operation.
Ein wichtiger Punkt beim Kauf des Geräts Jackson 850BI Series (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Jackson 850BI Series noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Jackson 850BI Series - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Jackson 850BI Series reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Jackson 850BI Series erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Jackson 850BI Series besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Jackson 850BI Series verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Jackson 850BI Series. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Jackson 850BI Series gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
