Benutzeranleitung / Produktwartung HF7 160E des Produzenten Hoover
Zur Seite of 32
® W ashing machine Instructions f or use HF7 160E 40000287.qxd 13/11/2003 13:02 Page 1.
Contents P age Introduction 3 General deliv er y notes 4 Saf ety notes 4 Quick start 5 Installation & testing 6 Useful advice f or the user 11 Description of controls 12 Detergent dra wer 14 Deter.
Intr oduction Please read and f ollow these instructions carefully and operate the machine accordingly .This booklet provides impor tant guidelines f or saf e use, installation, maintenance and some useful advice f or best results when using your machine.
General delivery notes Please check that the f ollowing items are deliv ered with the appliance: – Instruction manual – Guarantee card – Blanking plug – Inlet hoses & brac ket – Base panel & x2 push clips Check that no damage has occurred to the machine during transit.
K) When moving the appliance nev er lift it by the controls , the detergent dra wer , the hoses or the power cab le. T o avoid damaging the door when mo ving the appliance nev er rest the door against objects e.
Remov e the machine from the packaging - close to where it will finally be positioned - and proceed as f ollows: On the back of the machine 1) Remov e the central screw A and side screws B and pull out the tr ansit brac ket C along with the red locator .
Note: we recommend y ou keep the transit bracket and screws to pr otect the machine f or future transit. The Manufacturer s will not be responsible for an y damage to the machine caused b y not follo wing the instructions relating to releasing the transit pr otection.
If the inlet hose’ s connection point is changed, check that the 3/4” threaded f err ule on the inlet hose is firmly attached to the electrovalv e connector . W ater supply requirements Connect the machine to the drainage system used b y household sinks.
T esting the installation Ref er to the programme guide f or details of how to select programmes. 1. T urn on the water supply and check f or leaks from fill hoses. 2. Switch on the electricity supply . 3. Select a spin programme and then press the ST ART/P A USE button to start the machine.
T o ensure the dr um is thoroughly clean after testing and storage , select programme 1 and run the machine f or a complete cycle using only wash detergent and water . If the machine is not to be used immediately , s witch off the mains power supply and remov e the plug from the power soc ket.
11 Useful washing ad vice Tips on using your appliance in the most en vironmentally-fr iendly and economical way Loading y our washing machine T o make fur ther reductions of energy , water and detergent consumption, w e recommend that you put a full load into y our machine.
Description of Contr ols All the controls on your product’ s control panel are listed as f ollows . The button function is selected when the button neon is lit. Carefully read the relev ant descriptions detailed below: ST ART/P A USE ST ART After selecting the programme press the ST AR T/P A USE button once to start the machine.
The tables in the w ashing section descr ibe the v ar ious prog rammes and illustrate the number or symbol to select f or them. 13 Note: this model is fitted with an electronic “sensor” device that chec ks the load is balanced correctly .
– the third, labelled “ ” is f or special additives , fabric softeners, frag rances, starch, brighteners etc. The machine is programmed to automatically tak e up additives during the final rinse stage for all w ash cycles.
Deter gents, washing aids and amounts to use Choice of detergent General purpose detergents – P owder detergents, f or a thorough wash, with bleaching agents , are par ticularly suitable f or use in hot wash progr ammes (60°C and over), f or heavily soiled and stained laundr y .
Bef ore pour ing in the detergent chec k that there are no foreign bodies in the detergent dra wer . Dosage details are usually shown on the detergent pac kaging. Follo w those instructions! Dosages Only use detergents which are suitable f or use in a washing machine .
17 Pr ogramme selector The washing machine has diff erent programme groups according to type of w ash, temperature, spin speeds and dur ation for handling the v ar ious types of f abric and their le vel of soiling (see wash prog ramme guide). 1. CO TTONS The programmes are designed f or maximum washing and rinsing.
18 D AIL Y W ASH 40°C - F AST 29' A complete washing cycle (w ash, r inse and spin), ab le to wash in appro ximately 29 minutes: - a maximum load of 2 KGs; - lightly soiled f abr ics (cotton and mix ed fabrics). W e recommend, with this programme, a 20% detergent loading dose (compared to the nor mal one), in order to a void detergent w aste.
Sor ting the laundry – It is recommended you w ash only items which are washable with w ater and detergent and not dr y-clean items . – If you need to w ash r ugs , bedspreads or other heavy items, it is best not to spin them.
Note: when sor ting laundry – check there are no metal objects in the laundr y (such as paper clips, saf ety pins, pins, coins etc...); In the e vent of a machine f ailure dur ing the warranty period and f oreign objects are f ound to be the cause of the f ailure a labour charge ma y be made for the call out of an engineer .
Putting detergent in machine D) Open the dra wer , choose the detergent and put in the correct amount, according to the manuf acturer’ s instr uctions and the detergent advice section within this manual. Add any other laundry aids (see page 15). Close the dra wer again.
W ater and electricity consumption and appr o ximate length of programmes selected 22 The abov e results are based upon cold fill water (15°C) and maximum load capacities. * Programme length is v ariable depending on the type of f abr ic in the loads, the weight of the load, the wash temper ature and pressure of the water as it enters the machine.
23 PROGRAMME F ABRIC TYPE PROGRAMME FOR LO AD W A TER DETERGENT TEMP °C II I Whites Colourfast f abrics Intensive - hea vily 7 90° ** Cotton, linen, hemp soiled Whites & Cotton, colourfast Norma.
24 P oints to consider: When washing hea vily soiled laundr y it is recommended the load is reduced by about 1-1.5 kg. By doing so the laundry is allowed to circulate more freely . Energy label data based on programme 3 tested in accordance with EN60456.
25 Cleaning and r outine maintenance Do not use alcohol-based scourers and /or thinners on the outside of your washing machine , just a wipe with a damp cloth will suffice. The w ashing machine needs very little maintenance: – Cleaning the dra wer compar tments.
T ransporting or storing the appliance f or long periods when appliance is not in use If the appliance is being transpor ted or is out of use f or long per iods in unheated places , all remaining water must be completely remo ved from all hoses.
27 T r ouble shooting What might be the cause of... Defects y ou can remedy y ourself Bef ore calling GIAS Ser vice f or technical advice please run through the follo wing checklist. A charge will be made if the machine is found to be w or king or has been installed incorrectly or used incorrectly .
It is unlikely that water will be visib le in the drum! This is due to the latest technology that achie ves the same standar d of washing and rinsing b ut with far less water consumption.
P o wer failure If there is a power f ailure the wash cycle will be interrupted, the wash prog ramme and functions will be suspended. When the power is restored, the w ash programme and functions will re-star t from the same point and complete the programme .
T echnical data • Max. load of dry laundr y 7kg • W ater pressure (0.5-8 bar) 0.05-0.8 MP a • Spin speed 1600 r pm Measurements • Width 50cm • Depth 54cm • Height 85cm 30 NB: F or specifications regarding electr ical data, see the data plate on the front of the washing machine (door area).
Customer Service The appliance is cov ered by a cer tificate of guarantee which allo ws you free use of the Hoov er T echnical Suppor t Service (ter med GIAS tel: 08705 400 600), e xcept for the price of the call, for a period of one y ear from the date of purchase.
F or ser vice and repairs please call our national number: Hoo ver T ec hnical - T el: 08705 400 600 Suppor t Service [ Eire 018301 666 ] Alwa ys use genuine Hoov er spares, a vailab le direct from GI.
Ein wichtiger Punkt beim Kauf des Geräts Hoover HF7 160E (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Hoover HF7 160E noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Hoover HF7 160E - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Hoover HF7 160E reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Hoover HF7 160E erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Hoover HF7 160E besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Hoover HF7 160E verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Hoover HF7 160E. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Hoover HF7 160E gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
