Benutzeranleitung / Produktwartung HM1200TX des Produzenten Haier
Zur Seite of 22
HM1400TX HM1200TX.
FUNCTION INTRODUCTION.............................................3-4 INSTALLA TION...................................................................5-7 CLOSE UP ..........................................................................8-10 USING INSTRUCTIONS.
FUNCTION INTRODUCTION FUNCTION COMPARING TABLE FUNCTION MODE Washing capacity Power switch ON/OFF 5Kg 18 H X W X D Weight Power(Spin) Power(Wash) Power Door-locking device Stainless steel tub Rinse Sp.
HM1400TX HM1200TX.
Remove the package and check that the machine is undamaged. If you have any doubts, do not use the machine and call on a qualified technician. Keep all packing parts (plastic bag, foam rubber, screws etc.) out of the reach of children since they could be dangerous.
Connect the plug to a socket provided with efficient earthing. Or use the spare earthing wire supplied together with the machine and the earthing terminal located on the left-upper corner of the back of your machine (Warning: this appliance must be earthed as a safety measure according to the law).
Installa tion Connect the drain hose to a drain duct (with internal diameter of at least 4 cm.) or place it for drainage into a sink or a tub, ensuring that there are no kinks or bends.
Close up HM1400TX HM1200TX 500 1400 500 1200 1 2 3 4 5 6 7 A B C D E F I II III IV V 1 2 3 4 5 6 7 A B C D E F I II III IV V HM1400TX HM1200TX 500 1400 500 1200 1 2 3 4 5 6 7 A B C D E F I II III IV V.
Close up A Programme selector lcwob. By turning this dial (clockwise only) you can select from eighteen wash programmes the one most suited for your washing. 1~7 cotton cycle A~F synthetic cycle I~V wool cycle B Programme selector Knob. With this dial you can set the wash temperature that you desire.
Close up E Economic Wash Button. It reduces water and power consumption when rinsing if the machine does not have a full load. (Less than 3kg) F1 Speed Button. Push the button down, to reduce spin speed from1400r/min to 500r/min during strong washing mode and medium washing mode G Detergent Dispenser.
Using instru ctions:Y our machine offers the best re sults when... In order to get the excellent results that you would expect from your washing machine, it is important to load the washer correctly. Y ou should therefore choose the quantity of each type of fabric that you want to wash.
Using instructions:Your mac hine offers the best results when... A perfect wash depends above all on choosing the most suitable programme. We would therefore advise you to divide up your washing into separate loads of more or less the same types of fabric.
The 3 compartments marked 1, 2, 3 (Fig.9) should be used as follows: 1 Pre-wash detergent 2 Wash detergent 3 Conditioner, starch, scents The detergent has been put in properly Remember that it is impo.
Using instru ctions:Y our machine offers the best re sults when... The following table will guide you: When using concentrated detergents, remember to keep to the manufacturer's instructions using only the measuring cups supplied with the packet.
Using instructions:Your mac hine offers the best results when... Y ou can now start washing. We would advise you, especially the first few times, to check that the programme that you have set is really the one you want and that the fabric selection is correct.
Maintenance: fiv e simple precautions for this mac hine Your machine is designed to last without complicated maintenance. All the same, we would ask you to take care of a few small matters. If you follow these four simple rules, we are sure that the washing machine will stay as your faithful friend and helper for a long, long time.
Check that: the tap is open and properly connected to the inlet pipe; Solution to Pro blems Even though your washing machine has been carefully designed and constructed, something could still go a miss with your machine. Before rushing to phone one of our service centres, however, please check that the operations listed below have been carried out.
Solution to Problems Check that: the transit bolts have been removed (see installation manual); the machine is level; the washing load is according to the instructions given in this booklet. The machine vibrates too much when spinning The machine stops operating before finishing Check that: there is a sudden power failure or water stop.
Guide f or selecting pro gr amme A B C D E F I 3 II III IV V.
Warning: 1. If the supply cord is damaged, it must be replaced, these are available from an authorised service agent. 2. The appliance must be placed so that the plug is accessible. 4. The appliance is not intended for use by yong children or infirm persons without supervision.
I4=ON/OFF I5=ECONOMIC W ASH I6=1400/500 I4=ON/OFF I5=ECONOMIC W ASH I6=1200/500 WIRING CIRCIUT(HM1400TX) WIRING CIRCIUT(HM1200TX).
0020504683.
Ein wichtiger Punkt beim Kauf des Geräts Haier HM1200TX (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Haier HM1200TX noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Haier HM1200TX - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Haier HM1200TX reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Haier HM1200TX erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Haier HM1200TX besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Haier HM1200TX verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Haier HM1200TX. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Haier HM1200TX gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
