Benutzeranleitung / Produktwartung CIBV-30-2 des Produzenten Empire Comfort Systems
Zur Seite of 22
R-3450 Page 1 FOR YOUR SAFETY : What to do if you smell gas: • Do not touch any electrical switches • Do not try to light any appliance. • Do not use the phone in your building. • Immediately call your gas supplier from a neighbor's phone.
Page 2 R-3450 Introduction Always consult your local Building Department regarding regulations, codes or ordinances which apply to the installation of a vented fireplace heater. Instructions to Installer 1. Installer must leave instruction manual with owner after installation.
R-3450 Page 3 Some people cannot smell well. Some people cannot smell the odor of the chemical stench put into the gas. You must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor.
Page 4 R-3450 Figure 2 Figure 3 Qualified Installing Agency Installation and replacement of gas piping, gas utilization equipment or accessories and repair and servicing of equipment shall be performed only by a qualified agency.
R-3450 Page 5 Assembly of Cast Iron (Outer Casing) Stove Casting (Figures 5, 6, 7, 8 and 9) Attention: Included in the hardware package are (8) 1/4" inside diam- eter washers. A 1/4" washer may be used with a 1/4-20 x 3/8" bolt when assembling the stove casting parts.
Page 6 R-3450 Figure 6 8. Position the completed portion of the casing in the approximate location for installation as the completed assembly will be heavy. 9. Refer to Figure 7, removing protective packing foam from casing front and window. Remove the (1) 3/4" bolt and (1) 1/4" washer from top of window.
R-3450 Page 7 Figure 8 14. Refer to Figure 9, the appliance firebox can now be inserted into the outer casing. Center the firebox in the outer casing. Attention: Remove (1) Phillips-head screw in the top of the valve cover. The screw is used to secure the valve cover in place during shipping.
Page 8 R-3450 Stone Inlay Replacement of Standard Grille Top Whenever the standard grille top is replaced with a stone inlay you must install the top shield and heat shield, which are provided with the stone inlay. Installation of Optional Stone Inlay 1.
R-3450 Page 9 Gas Supply (Figure 11) Check all local codes for requirements, especially for the size and type of gas supply line required. Recommended Gas Pipe Diameter Pipe Length Schedule 40 Pipe Tubing, Type L (Feet) Inside Diameter Outside Diameter Nat.
Page 10 R-3450 Insulated Vent Enclosure (Figure 12) Vented fireplace heaters installed with the vent going directly to the outside and above the eaves can cause poor venting. The cold pipe will have a delay in proper venting and cause the fireplace heater to shut "off" by the vent safety switch.
R-3450 Page 11 If pilot flame pattern is incorrect, as shown in Figure 14 • See Troubleshooting, page 16. Main Burner Flame Pattern (Figure 15 and Figure 16) Figure 15 shows a correct main burner flame pattern. Figure 16 shows an incorrect main burner flame pattern.
Page 12 R-3450 Electric (120 volt) Operated Remote Control, FREC-1 Connect the green and red, stripped and bare, wires on the ON/OFF/ REMOTE switch wire harness to the wires on remote receiver that is a component in the FREC-1. Turn the ON/OFF/REMOTE switch on the wiring chase to the REMOTE position.
R-3450 Page 13 General Glass Information Only glass approved for use in Empire Comfort Systems, Inc. fireplaces may be used for replacement. The glass replacement should be done by a licensed or qualified service person. WARNING: 1. The use of substitute glass will void all product warranties.
Page 14 R-3450 12. Replace and attach the (2) 1" x 13-3/4" divider brackets onto the glass frame assembly with the (6) screws and (6) nuts from Step 7. 13. Grasp bottom of glass frame, push upward and insert glass frame into glass frame support top, push inward and insert glass frame into glass frame guide.
R-3450 Page 15 FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand.
Page 16 R-3450 Empire Comfort Systems, Inc. Nine Eighteen Freeburg Ave. Belleville, Illinois 62222-0529 How To Order Repair Parts ... Parts can be ordered only through your service person or dealer. For best results, the service person or dealer should order parts through the distributor.
R-3450 Page 17.
Page 18 R-3450 Index Part No. Number Description Index Part No. Number Description 1 R-3436 REMOTE/OFF/ON SWITCH 2 CI-326 SWITCH BOX 3 CI-328 WIRE CHANNEL 4 CI-336 REAR COVER WELDED ASSEMBLY 5 11228 D.
R-3450 Page 19.
Page 20 R-3450 OPTIONAL BLOWER CIB-2 V ented Fir eplace Heater CIBV -30 Installing Optional CIB-2 Blower 1. Loosen, but do not remove, (4) hex-head screws located on the exterior, bottom of the appliance. 2. Position the blower assembly at the rear of the appliance.
R-3450 Page 21 Cleaning The blower wheel will collect lint and could require cleaning once a year. If the air output decreases or the noise level increases, it indicates a dirty wheel. Blower Motor The blower motor does not have oiling holes. Do not attempt to oil blower motor.
Page 22 R-3450 Service Notes Empire Comfort Systems, Inc. Nine Eighteen Freeburg Ave. Belleville, Illinois 62222-0529 PH: 1-800-851-3153 F AX: 1-800-443-8648 E-MAIL: empire@accessus.
Ein wichtiger Punkt beim Kauf des Geräts Empire Comfort Systems CIBV-30-2 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Empire Comfort Systems CIBV-30-2 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Empire Comfort Systems CIBV-30-2 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Empire Comfort Systems CIBV-30-2 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Empire Comfort Systems CIBV-30-2 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Empire Comfort Systems CIBV-30-2 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Empire Comfort Systems CIBV-30-2 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Empire Comfort Systems CIBV-30-2. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Empire Comfort Systems CIBV-30-2 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
