Benutzeranleitung / Produktwartung VCX1525-WH des Produzenten Dimplex
Zur Seite of 20
Owner ’ s Manual Model VCX1525 VCX1525-WH T o view the full line of Dimplex products, please visit www .dimplex.com 7209350100R03 IMPORT ANT SAFETY INFORMA TION: Always read this manual rst before attempting to install or use this replace.
2 www .dimplex.com T able of Contents Always use a qualied technician or service agency to repair this replace. ! NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment.
3 W elcome & Congratulations Thank you and congratulations for choosing to purchase an electric replace from Dimplex, the world leader in electric replaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation.
4 www .dimplex.com When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: ① Read all instructions before using the Convex In-Stud replace.
5 SA VE THESE INSTRUCTIONS IMPORT ANT INSTRUCTIONS ⑬ Do not modify the replace. Use it only as described in this manual. Any other use not re com men ded by th e m an uf ac tur er may cause re, electric shock or injury to persons. ⑭ This unit may have a polarized plug (one blade is wider than the other).
6 www .dimplex.com IMPORT ANT INSTRUCTIONS W ARNING: Remote control contains small batteries. Keep away from children. If swallowed, seek medical attention immediately . W ARNING: Do not install battery backwards, charge, put in re or mix with used or other battery types - may explode or leak causing injury .
7 Fireplace Installation ! NOTE: A 15 Amp, 120 V olt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a regular basis when the heater is operating.
8 www .dimplex.com W ARNING: The Convex In Stud replace is wall mountable and can be built in a wall space 16 inches (406 mm) over-center between 2” x 4” wall studs. Follow the installation instructions for either wall mount or built-in mounting; failure to do so may cause damage or injury .
9 Fireplace Installation obstruct the bottom of this heater . Bottom of unit must be a minimum of 14 inches (356 mm) above the oor or any surface such as a tabletop to ensure adequate space for heat exhaust from the bottom of the replace (Figure 3).
10 www .dimplex.com ⑦ With the glass assembly taken off, mount the rebox onto the two (2) mounting screws. ⑧ Mark position of hole “H”. ⑨ Remove replace from wall. ⑩ Install drywall anchor into drywall at marked position. ⑪ With the glass assembly of f, mount the replace onto the two (2) mounted screws.
11 Fireplace Installation installation should be entrusted to duly qualied personnel where required by law . ① Leave the frame uninstalled from the replace chassis until step 13. ② Prepare a wall opening following the dimensions shown in Figure 5.
12 www .dimplex.com ④ Remove the outer jacket and strip the individual conductor from the end. ⑤ Loosen the screw securing the junction box cover and remove the cover . ⑥ T ake the cables out from the junction box, loosen the two (2) wire nuts and remove the cord set (Figure 6).
13 Fireplace Installation fasteners. Attach supplied wall cover brackets to the top and the bottom of replace to cover the gap on the dry wall (Figure 8). ⑬ Attach replace frame as shown in Figure 4 . Bathroom Installation This rebox must be protected by a GFI receptacle or circuit for bathroom use.
14 www .dimplex.com Operation Figure 9 T op Light Dimmer Thermostat Heater On/Off Switch Main On/Off Switch A. Main On/Off Switch The switch has two ON positions marked with and “ ON ”. The “ ON ” position is for manual operation. In this position the built-in remote control is by- passed.
15 Operation Resetting The T emperature Cutoff Switch Should the heater overheat, an automatic cut out will turn the replace off and it will not come back on without being reset. It can be reset by switching the Main On/Off Switch to OFF and waiting ve (5) minutes before switching the unit back on.
16 www .dimplex.com Figure 1 1 Lift to remove Glass assembly Bulb Replacement Instructions: ① Disconnect power supply to the replace either by unplugging the replace or switch off at the breaker panel. ② Remove glass assembly . Remove the screws securing the glass assembly on the chassis (Figure 4).
17 Maintenance Figure 12 Light Block ⑥ Replace with new bulbs. ⑦ Reassemble light block and glass assembly in reverse order . Glass Cleaning The front glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc.
18 www .dimplex.com W arranty Products to which this limited warranty applies This limited warranty applies to newly purchased Dimplex replaces and surrounds (mantels) and trims.
19 W arranty Dimplex will in its sole discretion • either repair or replace such defective product or part without charge. If Dimplex is unable to repair or replace such product or part, or if repai.
20 www .dimplex.com © 201 1 Dimplex North America Limited Dimplex North America Limited 1367 Industrial Road Cambridge ON Canada N1R 7G8 Replacement Parts Front Glass - VCX1525 . . . . . . . . . . . . . . . . . . . . . . 5901 170100RP VCX1525-WH . . .
Ein wichtiger Punkt beim Kauf des Geräts Dimplex VCX1525-WH (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Dimplex VCX1525-WH noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Dimplex VCX1525-WH - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Dimplex VCX1525-WH reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Dimplex VCX1525-WH erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Dimplex VCX1525-WH besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Dimplex VCX1525-WH verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Dimplex VCX1525-WH. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Dimplex VCX1525-WH gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
