Benutzeranleitung / Produktwartung 10 STX des Produzenten Cannon
Zur Seite of 38
Owner’s Manual Mag num 5 S T Mag num 10 STX Magnum 10 STX TS.
2 www.cannondownriggers.com Table of Contents T ABLE OF CONTENTS Introduction .................................................................................................................................................................. 3 Warranty / Servic e Information .
3 www.cannondownriggers.com Introduction Introduction Overvie w Thank you for purchasing the Canno n Magnum electric downri gger. We have designed your n ew do wnrig- ger to be an accurate and reliable tool that will enhan ce fishing control and improve your ability to catch fish.
4 www.cannondownriggers.com Product Warranty CANNON LIMITED W ARRANTY Johnson Outdoors Marine Electronics, Inc. warrants to the original purchaser that if the accompanyi ng product (see exclusions below) proves to be defective in material or workmanship within the following warranty periods, Johnson Outdoors Marine Electronics, Inc.
5 www.cannondownriggers.com Product Overview Introduction to Controlled Dep th Fish ing Undoubtedly there are many fishermen familiar with the methods and use of controlled depth fishi ng. During the mid 1960's the state of Michi gan intro- duced Pacific salmon into the Great Lakes in an at- tempt to revitalize its sport fishing industry.
6 www.cannondownriggers.com Installation Arrows Indicate Typical Mounting Locations Installing the Base on Your Boat Decks up to 7/16" thick Where access to the underside of the deck is not available, the mounting base can be mounted using wellnuts.
7 www.cannondownriggers.com Installation Decks thinner than 1/4" Use a Cannon deck plate (PN 2200693) to prevent deflection and add stability to decks thinner than 1/4".
8 www.cannondownriggers.com INSTALLING THE BOOM AN D B ALL HOOK 1) Remove the ball hook collar, ball hoo k, and 1/4 -20 nut from the included hardware bag assembly. 2) Thread the nut onto the ball hook, then thread the ball hook into the ball hook collar.
9 www.cannondownriggers.com FIGURE 5 FIGURE 6 FIGURE 7 FIGURE 8 6) Insert the 1/4-20 nylon locknut into the hex pocket on the nose of the frame (motor side of frame). (Figure 5) 7) Insert 1/4-20 x 2” bolt into reel side of frame nose. With a Phillips head screw driver, thread bolt into the nylon locknut from step 6.
10 www.cannondownriggers.com BOOM END PULLEY Telescopic Boom 1) Remove boom end assembly from hard wa re bag. 2) Remove #8 self tapping screw from h ard ware bag. 3) Insert boom end post into end of the small tube of the telescopic boom assembly. (Figure 9) 4) Align hole in boom post with hole in small end tube.
11 www.cannondownriggers.com REMOVABLE SPOOL COVER Your new downrigge r com es with a removable spool cover. By removing this cover, you are able to gain easy access to your spooled cable and ea sy spool removal. This feature allows you to easily ac- cess tangled line, get it repaired and get you back into action quickly.
12 www.cannondownriggers.com Installation ATTACHING THE RO D H OLDER(S) The locking rod holder(s) incorporate a l ocking tooth design which can be easily adj usted every 15° with the soft grip knob. The symmetrical design will al- low mounting of the rod holder on either side of the downrigger or two rod hold ers at the same time.
13 www.cannondownriggers.com Installation TERMINA TING THE DOWNRIGGER CABLE TIP: Use only straight cable whe n routing through the terminator. Worn or kin ked cable can be stressed and may break prematurely when retri eving trolling weights.
14 www.cannondownriggers.com USING THE INCLUDED POWE R LOSS MANUAL CRANK HANDLE In case of a dead battery, your downrigger come s equipped with a power loss manual cra nk handle. This handle allows for the retrieval of your weight should you lose power or have an electrical failure.
15 www.cannondownriggers.com Installation Wiring Y our Downrigger Your Boat's Electrical Condition It is important to make sure that your boat is properly set up before installing your Magnum with Positive Ion Control (PIC). Whenever a boat is in water, various subm erged parts intera ct to create weak electrical currents.
16 www.cannondownriggers.com Installation FUSE / BREAKER SPECIFICATIONS: An over-current protection device (circuit breake r or fuse) must be used with this downrigger. Coast Guard re- quirements dictate that each ungroun de d current-carrying conductor must be pr otected by a manually reset, trip- free circuit breaker or fuse.
17 www.cannondownriggers.com Getting Started GETTING ST ARTED Manual Descent: Fast or Slow By turning the clutch kn ob gently clockwise (toward the boom), you can let your trolling weight descend a s fast or as slowly as you wish. Turning the knob co unter- clockwise (away from the boom ) stop s the weight.
18 www.cannondownriggers.com Getting Started Adjusting the Depth Meter The Cannon Depth Meter provide s non-slip accu- racy, plus easy resetting. To reset, just slide the meter away from the reel until the gears are disengag ed. Spin meter gear to change setting.
19 www.cannondownriggers.com Fishing Theor y Fishing With Your Downrigger Release some line from your rod and re el so that the lure is anywhere from 5 to 100 feet behind the bo at. This is called drop back. Attach the fishing line firmly into the line release.
20 www.cannondownriggers.com How the Positive Ion Control Sy stem Works The PIC system uses an internal circuit that passes the voltage through the drive train of the Magnum to the shaft. The shaft contacts the cable by means of a ball bearing, spring and, lastly, a one direction button hea d screw.
21 www.cannondownriggers.com Blowback Calculations Blowback Simply stated, blowback is what happe n s to the downrigger weight when you pull it through the water behind your boat. As your speed increases, so doe s the horizontal distance betwee n the weig ht and your downrigger.
22 www.cannondownriggers.com Ten Good Trolling Tips 1) Test your lures over the boat side before sending them down and back. Do this to make sure the lure wig- gles and wobbles properly without goi ng belly up or wandering off. Some lures can be adjusted, fine tuned actually, to impart maximum action.
23 www.cannondownriggers.com Troubleshooting Troubleshooting PROBLEM: In the UP or AUTO-UP mode the downrigge r stops periodically or the circuit breaker trips repeatedly. SOLUTION: • Low battery. The battery voltage at the power cord is less than 11.
24 www.cannondownriggers.com Parts List 1902300 Magnum 5 ST.
25 www.cannondownriggers.com Parts List In the U.S.A., replacement part s may be ordered directly from CANNON Parts Dep t., 121 Power Drive, Mankat o, Minnesota 56001. . Be sure to provide the MODEL and SE- RIAL numbers of your downrigger when ordering parts.
26 www.cannondownriggers.com Parts List 1902301 Magnum 5 ST /E.
27 www.cannondownriggers.com Parts List In the U.S.A., replacement parts may be ordered directly from CANNON Parts Dept., 121 Power Drive, Mankato, Minnesota 56001. B e sure to provide the MODEL and SERIAL numbers of your downrigger when orderin g parts.
28 www.cannondownriggers.com Parts List 1902305 Magnum 10 STX.
29 www.cannondownriggers.com Parts List In the U.S.A., replacement parts may be ordered directly from CANNON Parts Dept., 121 Power Drive, Mankato, Minnesota 56001. B e sure to provide the MODEL and SERIAL numbers of your downrigger when orderin g parts.
30 www.cannondownriggers.com Parts List 1902306 Magnum 10 STX /E.
31 www.cannondownriggers.com Parts List In the U.S.A., replacement parts may be ordered directly from CANNON Parts Dept., 121 Power Drive, Mankato, Minnesota 56001. B e sure to provide the MODEL and SERIAL numbers of your downrigger when orderin g parts.
32 www.cannondownriggers.com Parts List 1902310 Magnum 10 STX TS.
33 www.cannondownriggers.com Parts List In the U.S.A., replacement parts may be ordered directly from CANNON Parts Dept., 121 Power Drive, Mankato, Minnesota 56001. B e sure to provide the MODEL and SERIAL numbers of your downrigger when orderin g parts.
34 www.cannondownriggers.com Parts List 1902311 Magnum 10 STX TS /E.
35 www.cannondownriggers.com Parts List In the U.S.A., replacement parts may be ordered directly from CANNON Parts Dept., 121 Power Drive, Mankato, Minnesota 5600. B e sure to provide the MODEL and SERIAL numbers of your downrigger when orderin g parts.
36 www.cannondownriggers.com Wiring Diagram Magnum Series Wiring Diagram.
37 www.cannondownriggers.com THIS P AGE INTENTIONALL Y LEFT BLANK.
X www.cannondownriggers.com ENVIRONMENTAL COMPLIANCE STA TEMENT: It is the intention of Johnson Outdoors Mari ne Electronics, Inc. to be a responsible corporate citizen, operating in compliance with known and applicable environmental regulations, and a good neighbor in the communities where we make or sell our products.
Ein wichtiger Punkt beim Kauf des Geräts Cannon 10 STX (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Cannon 10 STX noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Cannon 10 STX - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Cannon 10 STX reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Cannon 10 STX erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Cannon 10 STX besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Cannon 10 STX verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Cannon 10 STX. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Cannon 10 STX gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
