DE
Offizielle Bedienungsanleitung

Ices Electronics

37 Seiten·573 KB·Elektronik·PDF·ENITJA
Ices Electronics
Inhaltsverzeichnis 5 Abschnitte Model: ICR-240 · INSTRUCTION MANUAL · PREPARATION FOR USE · Service and support · … AnzeigenAusblenden
Page 1 of the Ices Electronics user manual — INSTRUCTION MANUAL
Seite 1 · Zum Vergrößern klicken
Seite 1

Model: ICR-240

Ices Electronics — Model: ICR-240 diagram (page 1)
Abb. 1 · Model: ICR-240

INSTRUCTION MANUAL

www.ices-electronics.com

READ THIS INSTRUCTION MANUAL BEFORE OPERATING THE APPLIANCE.

AND SAVE IT FOR FUTURE REFERENCE.

Page 2 of the Ices Electronics user manual — Model: ICR-240
Seite 2 · Zum Vergrößern klicken
Seite 2
Ices Electronics — Model: ICR-240 diagram (page 2)
Abb. 2 · Model: ICR-240
Ices Electronics — Model: ICR-240 diagram (page 2)
Abb. 3 · Model: ICR-240
Ices Electronics — Model: ICR-240 diagram (page 2)
Abb. 4 · Model: ICR-240

Top view · Back view

Page 3 of the Ices Electronics user manual — Model: ICR-240
Seite 3 · Zum Vergrößern klicken
Seite 3
Ices Electronics — Model: ICR-240 diagram (page 3)
Abb. 5 · Model: ICR-240

Front view CONTROLS AND INDICATORS 1. “SNOOZE / SLEEP / DIM” button 2. “ON / OFF / NAP” button 3. “P-“ button 4. “ALARM 1 / VOL –“ button

5. “HOUR / TUNING –“ button 6. “TIME / PRESET” button 7. “P+” button 8. “ALARM 2 / VOL +” button 9. “MIN / TUNING +” button 10. Battery compartment 11. FM antenna 12. AC plug A. Time and radio frequency display

B. Alarm 2 buzzer C. Alarm 2 radio indicator D. FM E. Alarm 1 buzzer F. Alarm 1 radio indicator

Page 4 of the Ices Electronics user manual — PREPARATION FOR USE
Seite 4 · Zum Vergrößern klicken
Seite 4

PREPARATION FOR USE

This clock radio includes a battery backup system that will maintain the time and alarm settings during a temporary power interruption. Insert two ‘AAA’ size batteries correctly by matching the polarity (+/-) markings in the battery compartment (10). If you experience a power failure while batteries are installed, the display will turn ‘off’ but the clock will continue to run and maintain your alarm settings. Please replace all batteries at the same time with only new batteries. The clock radio has slip proof silicon feet. Place the clock radio only on protected furniture. Plug AC plug (12) into 230vac electrical outlet.

Unwind the FM antenna (11) on the back of the clock radio. Extend and reposition the antenna for best radio reception. ALARM CLOCK OPERATION SETTING THE TIME Note:

You cannot set any function when the clock display is blinking after plug in, press

the “TIME/PRESET” to stop blink and start setting.

The time can only be set when the radio is turned off. Press the “ON / OFF / NAP”

button (2) to turn radio on or off.

When the clock display is blinking, you cannot power on radio by the “ON / OFF /

NAP” button (2). 1. Press and hold down “TIME / PRESET” button (6) for approximately 3 seconds until the display flashes. 2. Press “HOUR / TUNING –“ button (5) repeatedly to change the hour setting. 3. Press “MIN / TUNING +“ button (9) repeatedly to change the minute setting. 4. Press “TIME / PRESET” button (6) to confirm at the time and the display will stop flashing.

SETTING THE ALARM TIME This clock radio has dual alarms that can be set and used independently. The procedure to set both alarms are the same. Both alarms can either sound the buzzer or wake up to radio. Note: The alarm time can only be set when the radio is turned off. Press the “ON /

Page 5 of the Ices Electronics user manual — PREPARATION FOR USE
Seite 5 · Zum Vergrößern klicken
Seite 5

OFF / NAP” button (2) to turn radio on or off.

1. For setting alarm time 1 with buzzer, press “ALARM 1 / VOL –“ button (4) and

indicator (E) will flash. For setting alarm time 1 with radio, press “ALARM 1 /

VOL –“ button (4) twice and indicator (F) will flash.

2. When the digits are flashing, press “HOUR / TUNING –“ button (5) repeatedly to change the hour setting. Press “MIN / TUNING +“ button (9) repeatedly to change the minute setting. 3. Press “ALARM 1 / VOL –“ button (4) to confirm. 4. To cancel alarm, press “ALARM 1 / VOL –“ button (4) three times when the

current time is showing. The alarm indicators will be off. 5. When the alarm sounds, press any button to turn off alarm or press “SNOOZE /

SLEEP / DIM” button (1) to enter snooze mode. or will blink during

snooze mode. Alarm will sound again after 5 minutes. Alarm buzzer does not cut the radio sound. If alarm waken up by radio, volume control for radio is not available. 6. Follow the same instructions for alarm 2 with “ALARM 2 / VOL +” button (8). Note:

You must make the time and alarm time adjustments while the display is flashing.

The display will stop flashing after approximately 10 seconds if adjustments are not made.

If two alarms are set together, for example alarm1 set to buzzer alarm and alarm2

set to radio alarm, when buzzer is activated by alarm1 and radio is activated by alarm2, the previous alarm does not stop automatically and has both buzzer and radio sound together. RADIO General Operations

1. Press the “ON/OFF/NAP” button (2) to turn radio on and off. 2. For manual tuning, press “HOUR / TUNING –“ button (5) or “MIN / TUNING +“ button (9) for increments of 0.1mHz. 3. For automatic tuning, press and hold down “HOUR / TUNING –“ button (5) or “MIN / TUNING +“ button (9) for approximately 3 seconds. Depress the button and the radio will start to scan for the next available station. 4. Press “ALARM 1 / VOL –“ button (4) or “ALARM 2 / VOL +“button (8) to adjust

Page 6 of the Ices Electronics user manual — PREPARATION FOR USE
Seite 6 · Zum Vergrößern klicken
Seite 6

volume level. The display changes to show the volume level indication (00 to 14)

during the volume adjustments, then changes back to the radio station frequency and then the current time. 5. Press “HOUR / TUNING –“ button (5) or “MIN / TUNING +“ button (9) to show the radio station frequency. Pre-set Station Memory 1. The radio can store up to 20 FM stations. 2. To store a station in memory, tune to the desired radio station. Press and hold down “TIME/PRESET” button (6) for approximately 3 seconds and “P01” on the display will flash. Press “P+” button (7) or “P-“ button (3) to the desired station

memory (P01 to P20). Press “TIME/PRESET” button (6) once to confirm. 3. Repeat the above steps for up to 20 stations. 4. To recall the station, press “P+” button (7) or “P-“ button (3) until desired station is reached. Sleep mode 1. When the radio is on, press “SNOOZE / SLEEP / DIM” button (1) to enter sleep mode. “OFF” will be displayed. Press “SNOOZE / SLEEP / DIM” button (1) repeatedly for the duration of the “SLEEP” time. The range of “SLEEP” time is 90 minutes to 10 minutes, as displayed on the screen.

NAP Set the desired NAP time and the radio will turn on automatically after the preset time. 1. When the radio is off, press and hold “ON / OFF / NAP” button (2) for approximate 4 seconds and the display and FM indicator (D) will flash. 2. Press “P+” button (7) or “P-“ button (3) to set the desired nap time (45, 60, 90 or 120 mins) 3. Press “ON / OFF / NAP” button (2) to confirm.

DIMMER When the radio is off and the current time showing, press “SNOOZE / SLEEP / DIM” button (1) to select the brightness of the display for high or low.

Page 7 of the Ices Electronics user manual — Service and support
Seite 7 · Zum Vergrößern klicken
Seite 7

Service and support

For information: http://www.ices-electronics.com/ ICES offers service and warranty in accordance to European law, which means that in case of repair (both during and after the warranty period), you should contact your local dealer. Please note: It is not possible to send products directly to ICES for repair. Important note: If this unit will be opened, or accessed in any way by a non-official service center, the warranty expires immediately.

Products with the CE marking comply with the EMC Directive (2004/108/EC) and the Low Voltage Directive (2006/95/EC) issued by

the Commission of the European Community.

The declaration of conformity may be consulted at www.ices-electronics.com

This symbol indicates that the relevant electrical product or battery should not be disposed of as general household waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries. In so doing, you will help to conserve natural resources and improve standards of environmental protection in treatment and disposal of electrical waste (Waste Electrical and Electronic Equipment Directive). ®All rights reserved

Page 8 of the Ices Electronics user manual — GEBRUIKSAANWIJZING
Seite 8 · Zum Vergrößern klicken
Seite 8

Model: ICR-240

Ices Electronics — Model: ICR-240 diagram (page 8)
Abb. 6 · Model: ICR-240

GEBRUIKSAANWIJZING

www.ices-electronics.com

LEES VOORDAT U HET APPARAAT GEBRUIKT DEZE GEBRUIKSAANWIJZING DOOR.

EN BEWAAR HEM OM HEM LATER TE KUNNEN RAADPLEGEN.

Page 9 of the Ices Electronics user manual — GEBRUIKSAANWIJZING
Seite 9 · Zum Vergrößern klicken
Seite 9

Bovenaanzicht · Achteraanzicht

Frage zu Ices Electronics stellen

Besitzer und unser Team antworten in der Regel innerhalb eines Tages – und Ihre Frage hilft auch anderen weiter.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
Noch keine Fragen zu Ices Electronics

Stellen Sie die erste Frage — andere Nutzer oder unser Team antworten Ihnen.

Originaldokument

Ices Electronics PDF-Anleitung

37 Seiten·573 KB·Elektronik·PDF
Klicken Sie oben auf eine Seite, um sie hier zu öffnen
Seite 1 / …
100%
Seiten werden geladen…