DE
Novy logo
Offizielle Bedienungsanleitung

Novy 856

24 Seiten·236 KB·Dunstabzugshaube·PDF·ENITJA
Novy 856
Inhaltsverzeichnis 4 Abschnitte GENERAL INFORMATION · EN 11 · EN12 · EN 13 AnzeigenAusblenden
Page 1 of the Novy 856 user manual — EN 11
Seite 1 · Zum Vergrößern klicken
Seite 1

GENERAL INFORMATION

  • Please read these operating instructions carefully. They contain information about installation, operation, safety and maintenance you need to be aware of.
  • This hood is for domestic use only
  • It is recommended to have the installation done by a qualified professional. Any damage due to faulty or unprofessional installation relieves the manufacturer of any form of responsibility.
  • Check the condition of the hood and the installation material before installing. Carefully remove the hood out of the packaging. Be careful not to use sharp knives to open the box.
  • Please keep these instructions to pass on to future users.
  • Disposal of transport packaging and old appliance Your new appliance was sent to you in protective packaging. All utilised materials are environmentally safe and recyclable. Please help us by disposing of the packaging in an environmentally friendly manner. Old appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. This appliance is identified according to the European Directive 2002/96/EC on waste electrical and electronic equipment. Please ask your dealer or inquire at your local authority about current means of disposal.
  • Technical problem In case of technical problems please contact Novy Service Department: For Belgium: Tel.: 056/36.51.02 For France: Tel.: 03.20.94.06.62 For Germany: Tel.: 0511.54.20.771 For all other countries: your local installor or Novy Belgium: +32 (0)56/36.51.02 Please supply us with the model number of your hood. The model number can be found on the engraved plaque behind the filter. You can make a note of the number here: ……………………………
  • For all remarks or questions to which this manual doesn’t answer please contact our Customer Service: For Belgium: Tel.: 056/36.51.01 For France: Tel.: 03.20.94.06.62 For Germany: Tel.: 0511.54.20.771 For all other countrys: your local installor or Novy Belgium: +32 (0)56/36.51.02

EN 11

Page 2 of the Novy 856 user manual — EN12
Seite 2 · Zum Vergrößern klicken
Seite 2
Novy 856 — EN12 diagram (page 2)
Abb. 1

When using a hood sufficient air flow is necessary. However large your kitchen may be, there is only so much air available in that space. Opening a door or window or the installation of a ventilation grid close to the hood insures a good quality of air flow. Insufficient air flow will impair the extraction efficiency of your hood immensely.

① switch on / off ② decrease speed levels ⑤ and ⑥ LED indication speed level ③ increase speed levels ④ illumination

Insufficient air flow can cause reflux from other air ducts such as chimneys or combustion appliances. When using a cooker hood and appliances using energy other than electrical in the same space, the pressure in the room may not surpass 4 Pa (= 0.04mBar).

Switch on – switch off To switch the motor on push button ①. The hood will always resume the level it was previously switched off in.

Switch off with 10 minute delay: Press button ① once. The first green LED blinks, the other LED’s remain lit up according to the level in use. After 10 minutes motor and illumination switch off automatically.

  • Safety
  • Deep frying under the hood is only allowed under constant supervision.
  • Under no circumstances is it allowed to flambé under the hood.
  • In case of fire always switch off the hood.
  • Never extinguish burning fat or oil with water. Cover the pot with a well fitting lid or a burnblanket.

Switch off without delay: Push button ① twice.

Auto-Stop To avoid that the hood will function during a too long period, it will switch off automatically after 3 hours (when no changes to the controls have been made). Motor and lighting will turn off automatically.

  • Advice For maximum efficiency please follow this advice:
  • When cooking make sure pots are positioned properly under the hood surface.
  • Activate the hood a few minutes prior to cooking.
  • Switch the hood off 10 minutes after cooking is finished (use delay function when present).
  • Avoid drafts under the hood surface.
  • When using induction: adapt the intensity of both hob and hood to the lowest possible level in order to avoid excessive creation of damp fumes.

Levels of intensity To decrease speed levels push button ②. To increase speed levels push button ③. Three green LED’s ⑤ indicate level 1 to 3, one red LED ⑥ indicates the level ‘POWER’.

‘POWER’ is only used in case of excessive formation of smoke, fumes or odours. Taking into account the large volume of air which is extracted from the room at this level, it’s use should be limited.

‘POWER’ automatically reverts to level 3 after 20 minutes.

Illumination An exteral lightning can be connected to the hood

EN12

Use · Operation

Page 3 of the Novy 856 user manual — EN 13
Seite 3 · Zum Vergrößern klicken
Seite 3

Programming the remote control

The remote control for hood and hob are preinstalled and ready for use. Only when te remote control needs to be reprogrammed (interaction with other controls)act as in the following.

Maintenance of the grease filter The hood contains one metal filter which should be cleaned twice a month.

Grease filter indication After 20 cooking hours, the 4 LEDs will start to blink during 5 minutes, this indicates that the grease filter has to be cleaned. When replacing the cleaned filter, you have to reset the hood by pushing the – button during 5 seconds . If you don’t reset, the LED lights will continu blinking.We advise you to clean your filter twice a month for an optimal operation.

Determine the code used: Simultaneously press on/off + the key with the lighting symbol. The lamp flashes as well as the selected code (there are 10 code options in total).

Change the codea. Simultaneously press on/off + the key with

the sun for 3 seconds until the lamp is flash- ing. After this the lamp as well as the selected code will flash. Repeat this step until you have reached the required code (there are 10 code options in total). b. Simultaneously press + lamp of the roof cover

Access to the filter Take hold of the right and left side of the plate (a) and pull down simultaneously. Remove the filter (b) by taking hold of its hook and pulling down.

control until the second green LED is blinking. c. Press the key with the sun on the remote con-

Novy 856 — EN 13 diagram (page 3)
Abb. 2

trol within 10 seconds to confirm the settings. The cooker hood and the remote control are now in line with each other.

  • Cleaning the filter:
  • in the dishwasher
  • manually: in a hot solution of water and a liquid detergent. Rince and allow to dry completely
  • Change the batteries:
  • For changing the batteries unscrew the plastic cover, remove the old batteries and insert the new ones. Pay attention to the polarity marking given in the battery compartment (figure 4).
  • Empty batteries are not to be disposed of in the household refuse, but they are to be handed in as chemical waste.

NOVY key: You can switch on the ambient lighting using the NOVY key (figure 5).

Technical information: - Power supply: (2xAAA) batteries - Frequence: 433.92Mhz - Numbre of codes: 10 - Worktemperature: 0-50°C - Dimensions: 110 x 50 x 19mm

The stainless steel surfaces can be treated with Novy Inoxcleaner (906.060) after cleaning.

Dimensionsp. 18 Electrical scheme: p. 19

EN 13

Maintenance

Frage zu Novy 856 stellen

Besitzer und unser Team antworten in der Regel innerhalb eines Tages – und Ihre Frage hilft auch anderen weiter.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
Noch keine Fragen zu Novy 856

Stellen Sie die erste Frage — andere Nutzer oder unser Team antworten Ihnen.

Originaldokument

Novy 856 PDF-Anleitung

24 Seiten·236 KB·Dunstabzugshaube·PDF
Klicken Sie oben auf eine Seite, um sie hier zu öffnen
Seite 1 / …
100%
Seiten werden geladen…