DE
Novy logo
Offizielle Bedienungsanleitung

Novy 7665

23 Seiten·358 KB·Dunstabzugshaube·PDF·ENITJA
Novy 7665
Inhaltsverzeichnis 1 Abschnitte GENERAL INFORMATION AnzeigenAusblenden
Page 1 of the Novy 7665 user manual — GENERAL INFORMATION
Seite 1 · Zum Vergrößern klicken
Seite 1

GENERAL INFORMATION

  • Please read these operating instructions carefully. They contain information about installation, operation, safety and maintenance you need to be aware of.
  • This hood is for domestic use only
  • It is recommended to have the installation done by a qualified professional. Any damage due to faulty or unprofessional installation relieves the manufacturer of any form of responsibility.
  • Check the condition of the hood and the installation material before installing. Carefully remove the hood out of the packaging. Be careful not to use sharp knives to open the box.
  • Please keep these instructions to pass on to future users.
  • Disposal of transport packaging and old appliance Your new appliance was sent to you in protective packaging. All utilised materials are environmentally safe and recyclable. Please help us by disposing of the packaging in an environmentally friendly manner. Old appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. This appliance is identified according to the European Directive 2002/96/EC on waste electrical and electronic equipment. Please ask your dealer or inquire at your local authority about current means of disposal.
  • Technical problem In case of technical problems please contact Novy Service Department: For Belgium: Tel.: 056/36.51.02 For France: Tel.: 03.20.94.06.62 For Germany: Tel.: 0511.54.20.771 For all other countries: your local installor or Novy Belgium: +32 (0)56/36.51.02 Please supply us with the model number of your hood. The model number can be found on the engraved plaque behind the filter. You can make a note of the number here: ……………………………
  • For all remarks or questions to which this manual doesn’t answer please contact our Customer Service: For Belgium: Tel.: 056/36.51.01 For France: Tel.: 03.20.94.06.62 For Germany: Tel.: 0511.54.20.771 For all other countrys: your local installor or Novy Belgium: +32 (0)56/36.51.02
Page 2 of the Novy 7665 user manual — GENERAL INFORMATION
Seite 2 · Zum Vergrößern klicken
Seite 2
Novy 7665 — GENERAL INFORMATION diagram (page 2)
Abb. 1

Air supply When using a hood sufficient air flow is necessary. However large your kitchen may be, there is only so much air available in that space. Opening a door or window or the installation of a ventilation grid close to the hood insures a good quality of air flow. Insufficient air flow will impair the extraction efficiency of your hood immensely.

① switch on / off ② decrease speed levels ⑤ and ⑥ speed indicator lamps ③ increase speed levels ④ illumination

Switch on – switch off To switch the motor on push button ①. The hood will always resume the level it was previously switched off in.

Insufficient air flow can cause reflux from other air ducts such as chimneys or combustion appliances. When using a cooker hood and appliances using energy other than electrical in the same space, the pressure in the room may not surpass 4 Pa (= 0.04mBar).

Auto-Stop To avoid that the hood will function during a too long period, it will switch off automatically after 3 hours (when no changes to the controls have been made). Only the motor will turn off automatically. The lighting will stay on.

  • Safety
  • Deep frying under the hood is only allowed under constant supervision.
  • Under no circumstances is it allowed to flambé under the hood.
  • In case of fire always switch off the hood.
  • Never extinguish burning fat or oil with water. Cover the pot with a well fitting lid or a burnblanket.

Switch off with 10 minute delay: Press button ① once. The first greenspeed indicator lamp blinks, the other speed indicator lamps remain lit up according to the level in use. After 10 minutes motor and illumination switch off automatically.

  • Advice For maximum efficiency please follow this advice:
  • When cooking make sure pots are positioned properly under the hood surface.
  • Activate the hood a few minutes prior to cooking.
  • Switch the hood off 10 minutes after cooking is finished (switch off with 10 minute delay).
  • Avoid drafts under the hood surface.
  • When using induction: adapt the intensity of both hob and hood to the lowest possible level in order to avoid excessive creation of damp fumes.

Switch off without delay: Push button ① twice.

Levels of intensity To decrease speed levels push button ②. To increase speed levels push button ③. Three green speed indicator lamps ⑤ indicate level 1 to 3, one red speed indicator lamp ⑥ indicates the level ‘POWER’.

‘POWER’ is only used in case of excessive formation of smoke, fumes or odours. Taking into account the large volume of air which is extracted from the room at this level, it’s use should be limited.

‘POWER’ automatically reverts to level 3 after 6minutes.

A self-rectifying thermal contact makes sure that the motor is switched off when overheated. The motor will switch on again after is has cooled down. The cause of the overheating needs to be determined. This may be, for example, that the contents of the pan have caught fire, the motor

Use · Operation

Page 3 of the Novy 7665 user manual — GENERAL INFORMATION
Seite 3 · Zum Vergrößern klicken
Seite 3

fan is blocked or an object is (partly) closing off the exhaust opening.

be followed. If not an increased fire hazard may occur.

Lighting Press key ④ to switch the lighting on or off. The LED lighting has a soft on/soft off mode, which means that the lighting will evenly go on and off. When switching on the lighting, this will always light up with full power and it can also be used when the fan is off.

Maintenance of the hood Please allow the lights to cool down sufficiently before cleaning the hood. Use a soft, wet cloth and a mild detergent to clean the hood. Never use aggressive, abrasive detergents or sponges. Bleach will damage stainless steel.

Dimming LED lighting: When the LED lighting has been switched on, it can be dimmed by keeping key ④ pressed.

The stainless steel surfaces can be treated with Novy Inoxcleaner (906.060) after cleaning.

Please allow the lights to cool down sufficiently before touching them. Cover and protect delicate surfaces underneath the hood when changing lamps. The hood needs to be disconnected from the current before proceeding.

Maintenance of the grease filter The hood contains one or 2 metal filters (according to the model) which should be cleaned twice a month.

Grease filter indication After 20 cooking hours, the 4 speed indicator lamps will start to blink during 5 minutes, this indicates that the grease filter has to be cleaned. When replacing the cleaned filter, you have to reset the hood by pushing the – button during 5 seconds . If you don’t reset, the speed indicator lamps will continu blinking.

1. Open the bottom plate and then loosen the screws and slide off the cover.
Novy 7665 — GENERAL INFORMATION diagram (page 3)
Abb. 2

Access to the filter Take hold of the right and left side of the plate (a) an pull down simultaneously. Remove the filter (b) by taking hold of its hook and by pulling it down.

Novy 7665 — GENERAL INFORMATION diagram (page 3)
Abb. 3
Novy 7665 — GENERAL INFORMATION diagram (page 3)
Abb. 4
  • Cleaning the filter:
  • in the dishwasher
  • manually: in a hot solution of water and a liquid detergent. Rince and allow to dry completely
2. Removing the LED lamp: A. First disconnect the cable to the LED to be

replaced. Disconnect by means of releasing the lock, by applying light pressure while at the same time pulling away.

Replacing the lamps · Maintenance

Page 4 of the Novy 7665 user manual — GENERAL INFORMATION
Seite 4 · Zum Vergrößern klicken
Seite 4

B. Next, remove the LED to be replaced by

making a gentle rotating movement to the left.

Novy 7665 — GENERAL INFORMATION diagram (page 4)
Abb. 5

Electrical output: electrical cord + plug with ground. To be plugged into socket with ground. Check for compatibility with information on type plate (behind filter). Socket must be within reach. Changes or replacement of the electrical cord should be performed by a professional only.

3. Mounting the new LED: A. Place the new LED light into the locking ring. B. Make a rotating movement to the right until
Dimensionsp. 18 Electrical scheme: p. 19/20

the LED light is locked. C. Connect the power cable. D. Put back the cover and tighten the screws.

Then close the bottom plate.

Novy 7665 — GENERAL INFORMATION diagram (page 4)
Abb. 6

Electrical connection

Page 5 of the Novy 7665 user manual — GENERAL INFORMATION
Seite 5 · Zum Vergrößern klicken
Seite 5

Afmetingen - Dimensions - Abmessungen - Dimensions

Novy 7665 — GENERAL INFORMATION diagram (page 5)
Abb. 7
Novy 7665 — GENERAL INFORMATION diagram (page 5)
Abb. 8
Novy 7665 — GENERAL INFORMATION diagram (page 5)
Abb. 9

7640 - 7645 · 7650 - 7655 · 7660 - 7665

Page 6 of the Novy 7665 user manual — GENERAL INFORMATION
Seite 6 · Zum Vergrößern klicken
Seite 6

Elektrisch schema - Schéma électrique - Elektrischer Schaltplan - Electrical scheme

7640 - 7650 - 7660

Novy 7665 — GENERAL INFORMATION diagram (page 6)
Abb. 10
Page 7 of the Novy 7665 user manual — GENERAL INFORMATION
Seite 7 · Zum Vergrößern klicken
Seite 7

7645 - 7655 - 7665

Novy 7665 — GENERAL INFORMATION diagram (page 7)
Abb. 11

Frage zu Novy 7665 stellen

Besitzer und unser Team antworten in der Regel innerhalb eines Tages – und Ihre Frage hilft auch anderen weiter.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
Noch keine Fragen zu Novy 7665

Stellen Sie die erste Frage — andere Nutzer oder unser Team antworten Ihnen.

Originaldokument

Novy 7665 PDF-Anleitung

23 Seiten·358 KB·Dunstabzugshaube·PDF
Klicken Sie oben auf eine Seite, um sie hier zu öffnen
Seite 1 / …
100%
Seiten werden geladen…