DE
Novy logo
Offizielle Bedienungsanleitung

Novy 686

24 Seiten·358 KB·Dunstabzugshaube·PDF·ENITJA
Novy 686
Inhaltsverzeichnis 2 Abschnitte GENERAL INFORMATION · Operation AnzeigenAusblenden
Page 1 of the Novy 686 user manual — GENERAL INFORMATION
Seite 1 · Zum Vergrößern klicken
Seite 1

GENERAL INFORMATION

  • Please read these operating instructions carefully. They contain information about installation, operation, safety and maintenance you need to be aware of.
  • This hood is for domestic use only.
  • It is recommended to have the installation done by a qualified professional. Any damage due to faulty or unprofessional installation relieves the manufacturer of any form of responsibility.
  • Check the condition of the hood and the installation material before installing. Carefully remove the hood out of the packaging. Be careful not to use sharp knives to open the box.
  • Please keep these instructions to pass on to future users.
  • Disposal of transport packaging and old appliance. Your new appliance was sent to you in protective packaging. All utilised materials are environmentally safe and recyclable. Please help us by disposing of the packaging in an environmentally friendly manner. Old appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. This appliance is identified according to the European Directive 2002/96/EC on waste electrical and electronic equipment. Please ask your dealer or inquire at your local authority about current means of disposal.
  • Technical problem In case of technical problems please contact Novy Service Department: For Belgium: Tel.: 056/36.51.02 For France: Tel.: 03.20.94.06.62 For Germany: Tel.: 0511.54.20.771 For all other countries: your local installor or Novy Belgium: +32 (0)56/36.51.02 Please supply us with the model number of your hood. The model number can be found on the engraved plaque behind the filter. You can make a note of the number here: ……………………………
  • For all remarks or questions to which this manual doesn’t answer please contact our Customer Service: For Belgium: Tel.: 056/36.51.01 For France: Tel.: 03.20.94.06.62 For Germany: Tel.: 0511.54.20.771 For all other countrys: your local installor or Novy Belgium: +32 (0)56/36.51.02
Page 2 of the Novy 686 user manual — Operation
Seite 2 · Zum Vergrößern klicken
Seite 2

Operation

The controls are on the rotating valve.

Novy 686 — Operation diagram (page 2)
Abb. 1 · Operation

Air supply When using a hood sufficient air flow is necessary. However large your kitchen may be, there is only so much air available in that space. Opening a door or window or the installation a ventilation grid close to the hood insures a good quality of air flow. Insufficient air flow will impair the extraction efficiency of your hood immensely.

Open the glass cover by turning it towards you. ① switch on / off ② decrease speed levels ③ and ④ LED indication speed level ⑤ increase speed levels ⑥ illumination

Insufficient air flow can cause reflux from other air ducts such as chimneys or combustion appliances. When using a cooker hood and appliances using energy other than electrical in the same space, the pressure in the room may not surpass 4 Pa (= 0.04mBar).

Switch on – switch off To switch the motor on push button ①. The hood will always resume the level it was previously switched off in.

Switch off with 10 minute delay: Press button ① once. The first green LED blinks, the other LED’s remain lit up according to the level in use. After 10 minutes motor and illumination switch off automatically.

  • Safety
  • Deep frying under the hood is only allowed under constant supervision.
  • Under no circumstances is it allowed to flambe under the hood.
  • In case of fire always switch off the hood.
  • Never extinguish burning fat or oil with water. Cover the pot with a well fitting lid or a burnblanket.

Switch off without delay: Push button ① twice.

Levels of intensity To decrease speed levels push button ②. To increase speed levels push button ⑤. Three green LED’s ③ indicate level 1 to 3, one red LED ④ indicates the level ‘POWER’. POWER’ is only used in case of excessive formation of smoke, fumes or odours. Taking into account the large volume of air which is extracted from the room at this level, it’s use should be limited. ‘POWER’ automatically reverts to level 3 after 6 minutes.

  • Advice For maximum efficiency please follow this advice:
  • When cooking make sure pots are positioned properly under the hood surface.
  • Activate the hood a few minutes prior to cooking.
  • Switch the hood off 10 minutes after cooking is finished (switch off with 10 minute delay).
  • Avoid drafts under the hood surface.
  • When using induction: adapt the intensity of both hob and hood to the lowest possible level in order to avoid excessive creation of damp fumes.

Auto-Stop To avoid that the hood will function during a too long period, it will switch off automatically after 3 hours (when no changes to the controls have been made). Motor and lighting will turn off automatically.

Illumination To activate the lights press button ⑥. The lights will switch on at full power. Lighting can be activated independently from the motor.

Use

Page 3 of the Novy 686 user manual — Operation
Seite 3 · Zum Vergrößern klicken
Seite 3

Recirculation (option) If you have chosen for recirculation, please follow the instructions below.

Cleaning indication: The red LED will light up after 200 working hours (time to regenerate the Monoblock recirculation filter). The recirculation filter is to be found behind the grease filter.

Maintenance of the grease filter The hood contains one metal filter which should be cleaned twice a month.

Grease filter indication After 20 cooking hours, the 4 LEDs will start to blink during 5 minutes, this indicates that the grease filter has to be cleaned. When replacing the cleaned filter, you have to reset the hood by pushing the – button during 5 seconds . If you don’t reset, the LED lights will continu blinking.We advise you to clean your filter twice a month for an optimal operation.

  • Remove the Monoblock recirculation filter:
  • Open the bottom plate with both hands and remove the aluminium grease filter from the hood.
  • The Monoblock recirculation filter is found in its opening in the cooker hood. Remove it from the cooker hood.
  • Regenerate the Monoblock recirculation filter:
  • The Monoblock can be regenerated up to 12 times. This is done in the oven.
  • Place the filter in the oven for 1 hour at 120°C. Provide sufficient fresh air in the room where the oven has been placed, as smells can be released. Smells can be released when baking certain kinds of fish. The best solution for this is to immediately regenerate the filter.

Access to the filter

Novy 686 — Operation diagram (page 3)
Abb. 2 · Operation

Reset the Monoblock recirculation filter The cooker hood (motor) must be running! Simultaneously press + and – for 5 sec. until the red indicator lamp flashes 3 times for confirmation.

Open the rotating valve (A). Protect the hob. You can take the grease filter (B) from the hood by pulling the handle on the filter. The filter will come down.

  • Place the Monoblock recirculation filter:
  • Open the bottom plate with both hands and remove the aluminium grease filter from the hood.
  • Place the Monoblock recirculation filter is its opening in the cooker hood.
  • Put back the aluminium grease filter and close the bottom plate.
  • Cleaning the filter:
  • in the dishwasher
  • manually: in a hot solution of water and a liquid detergent. Rince and allow to dry completely Important! The previous instructions need to be followed. If not an increased fire hazard may occur.

Deactivate the programming: Attention! This is not recommended for a cooker hood with recirculation. Simultaneously press + and – for 5 sec. until the third green LED flashes 3 times.

Maintenance of the hood Please allow the lights to cool down sufficiently before cleaning the hood. Use a soft, wet cloth and a mild detergent to clean the hood. Never use aggressive, abrasive detergents or sponges. Bleach will damage stainless steel. The stainless steel surfaces can be treated with Novy Inoxcleaner (906.060) after cleaning.

Maintenance

Page 4 of the Novy 686 user manual — Operation
Seite 4 · Zum Vergrößern klicken
Seite 4

Replacement of the fluorescent lighting

  • Turn the fluorescent lamp a quarter turn to remove it from its holder.
  • Put back the new lamp in the holder and turn it again a quarter of a turn until you hear a soft ‘click’.

First take the plug from the wall socket or switch off the power group. Let the lamp cool down sufficiently before replacing it.

Novy 686 — Operation diagram (page 4)
Abb. 3 · Operation

Reference Novy 680.025

Type of lamp LUMILUX T8 L15 W/840

Reference Novy 686.025

Type of lamp LUMILUX T8 L16 W/840

  • Back to the initial position
  • Tighten everything again to the initial position.
  • IMPORTANT! When the glass panel (A) is placed back, the glass panel has to be pushed over the filter holder so its fixed (fig. 3.3).
  • Place the grease filter back in its support
  • Open the bottom plate and remove the grease filter from the hood.
Novy 686 — Operation diagram (page 4)
Abb. 4 · Operation

Electrical output: electrical cord + plug with ground. To be plugged into socket with ground. Check for compatibility with information on type plate (behind filter). Socket must be within reach. Changes or replacement of the electrical cord should be performed by a professional only.

Dimensionsp. 18 Electrical scheme: p. 19-20
  • Loosen the screws that keep the glass plate at its place.
  • Tilt down the glass plate C to make it pass the filter holder. If necessary, lightly press side D for easily tilting down.
Novy 686 — Operation diagram (page 4)
Abb. 5 · Operation

Model Hood 680 · Model Hood 686 · Electrical connection

Page 5 of the Novy 686 user manual — Operation
Seite 5 · Zum Vergrößern klicken
Seite 5

Afmetingen - Dimensions - Abmessungen - Dimensions

Novy 686 — Operation diagram (page 5)
Abb. 6 · Operation
Novy 686 — Operation diagram (page 5)
Abb. 7 · Operation
Page 6 of the Novy 686 user manual — Operation
Seite 6 · Zum Vergrößern klicken
Seite 6

Elektrisch schema - Schéma électrique - Elektrischer Schaltplan - Electrical scheme

Novy 686 — Operation diagram (page 6)
Abb. 8 · Operation
Page 7 of the Novy 686 user manual — Operation
Seite 7 · Zum Vergrößern klicken
Seite 7
Novy 686 — Operation diagram (page 7)
Abb. 9 · Operation
Page 8 of the Novy 686 user manual — Operation
Seite 8 · Zum Vergrößern klicken
Seite 8
Page 8 of the Novy 686 user manual — Operation

Frage zu Novy 686 stellen

Besitzer und unser Team antworten in der Regel innerhalb eines Tages – und Ihre Frage hilft auch anderen weiter.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
Noch keine Fragen zu Novy 686

Stellen Sie die erste Frage — andere Nutzer oder unser Team antworten Ihnen.

Originaldokument

Novy 686 PDF-Anleitung

24 Seiten·358 KB·Dunstabzugshaube·PDF
Klicken Sie oben auf eine Seite, um sie hier zu öffnen
Seite 1 / …
100%
Seiten werden geladen…