Benutzeranleitung / Produktwartung 660 des Produzenten Bolens
Zur Seite of 32
Operator's Manual Transmatic Lawn Tractor Models 660 - 688 IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unt is equ pped with an internal combustion engine and should not .
TABLE OF CONTENTS Content Page Important Safe Operation Practices ........................................................................ 3 Slope Gauge ..................................................................................................
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safely and/or properly of yourself and others. Read and follow alt instructions in this manuat before attempting to operate this machine.
23. Muffler and engine become hot and can cause a burn. Do not touch. 24. Check overhead clearances carefully before driving under low hanging tree branches, wires, door openings etc., where the operator may be struck or pulled from the unit, which could result in serious injury.
c. Before and while backing, look behind and down for smalt children. d. Never carry children, even with the blade(s) shut off. They may fall off and be sedousty injured or interfere with safe machine operation.
Replace the blade(s) with the original equipment manufacturer's (O.E.M.) blade(s) only, listed in this manual. "Use of parts which do not meet the original equipment specifications may lead to improper performance and compromise safety! ° 6.
1.1,1 O,. 0 ..I &i Z 0 J I.- 1.1.1 1'4 SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE 1,91 A POWER POLE 15° ,_WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury.
SECTION 3: TRACTOR SET-UP IMPORTANT: Your tractor is shipped with motor oil in the engine. However, you MUST check the oit level before starting the engine and operating. Refer to the separate Briggs & Stratton Operator/Owner Manual (or Tecumseh eng ne s Owner s Manua ) packed w th your tractor.
Attaching The Seat Seat styles vary by tractor mode! and there are three different styles available: • Standard Adjustment • Quick Adjustment & • Knob Adjustment Refer to Figure 3, Figure 4 and Figure 5 to identify which your tractor's seat style and follow appIicabIe instructions below.
Gas and OilFill-up The gasoline tank is located under the hood and has a capacity of either two or three gallons. Do not overfill. ,_ WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running.
SECTION 4: KNOW YOUR LAWN TRACTOR DDDDD_ t If so equipped Figure 8 A Clutch-brake Pedal E B Choke Control1- F C Throttle Control Lever G D Deck Engagement / Lift Lever H Ignition Switch The ignition switch is located on the right side of the tractor's dash .
Choke Control On some models, moving the throttle lever all the way forward activates the engine's choke control. On all other models, the choke control can be found on the left side of the dash panel and is activated by pulling the knob outward.
SECTION 5: OPERATING THE LAWN TRACTOR WARNING AVOID SERIOUS INJURY OR DEATH • GO UP AND DOWN SLOPES, NOT ACROSS. • AVOID SUDDEN TURNS. • DO NOT OPERATE THE UNIT WHERE {T COULD SLIP OR TIR • {F MACHINE STOPS GOING UPHILL, STOP BLADE(S) AND BACK DOWNHILL SLOWLY.
Operating The Lawn Tractor ,_ WARNING: Always Iookdown and behind before and while backing up to avoid a back- over accident. WARNING: Before leaving the operator's position.
. For best results it is recommended that the first two laps be cut with the discharge thrown towards the center. After the first two laps, reverse the direction to throw the discharge to the outside for the balance of cutting. This will give a better appearance to the lawn.
SECTION 6: MAKING ADJUSTMENTS _lb WARNING: Never attempt to make any adjustments while the engine is running, except where specified in the operator's manual. WARNING: Disconnect the spark plug wire(s) and ground against the engine before performing any adjustments, repairs or maintenance.
° Measure the distance from the front of the blade tip to the ground and the rear of the blade tip to the ground. The first measurement taken should be between 1/4" and 3/8" less than the second measu rement. Determine the approximate distance necessary for proper adjustment and proceed, if necessary, to the next step.
Remove the hairpin clip which secures the o disengagement rod to the stabilizer shaft assembly. See Figure 16. Parking Brake Adjustment ,i_ WARNING: Never attempt to adjust the _ .
° Remove the shift cover panel and locate the speed control rod. See Figure 18. NOTE: There is a small yellow wire connected to a spring switch on the underside of the shift cover panel.
o Two turns at a time, thread the adjustment ferrule toward the right, front tire to lengthen the tie rod. Or, thread the adjustment ferrule away from the right, front tire to shorten the tie rod. NOTE: Lengthening the tie rod increases the tractor's front tie toeqn.
o Unscrew the oil fill cap and remove the dipstick from the oil fill tube. See Figure 22. Drain Port Figure 22 . Pop open the protective cap on the end of the oil drain valve to expose the drain port. See Figure 22. . Push the oil drain hose (packed with this manual) onto the oil drain port.
SECTION 8: SERVICE _ WARNING: Disconnect the spark plug wire and ground against the engine before performing any adjustments, repairs or maintenance. Cutting Deck Removal WARNING: Shut the engine off,.
o Remove the hairpin clips which secure the rear deck hangers to the deck stabilizer bracket. See Figure 27. Retain the hairpin clips. Rear Deck Hangers Stabilizer Bracket Figure 27 .
It is important thateach cutting blade edge be ground equally to maintain proper blade balance. A poorly balanced blade will cause excessive vibration and may cause damage to the tractor andresult in personal injury. The blade canbe tested by balancing it on a round shaft screwdriver.
Deck Belt (38- and 42-inch Decks) WARNING: Shut the engine off, remove ignition key, set the parking brake, disconnect the spark plug wire(s) and ground against the engine to prevent unintended starting before removing the cutting deck. ,_ WARNING: Always wear safety glasses or safety goggles to protect your eyes while removing the cutting deck.
Orive Belts {Upper and Lower) NOTE: The engine pulley must be removed from the engine's crankshaft in order to change the tractor's drive belts. Doing so requires an air/impact wrench. o o It is recommended that both belts be changed at the same time.
SECTION 9: OFF-SEASON STORAGE WARNING: Never store the machine or fuel container indoors where there is an open flame, spark or pilot light such as on water heater, furnace, clothes dryer or other gas appliance. WARNING: Use a fuel stabilizer additive or drain the fuel into an approved container outdoors, away from an open flame.
SECTION 11: TROUBLE SHOOTING GUIDE Trouble Corrective Action Engine will not crank Engine cranks but will not start Engine smokes Excessive vibration Mower will not discharge grass or leaves uncut strips Possible Cause(s) Safety switch button not depressed.
NOTES 29.
NOTES 30.
NOTES 31.
MANUFACTURER'S LIMITED WARRANTY FOR: O n II I Ii TRO BIIT o The limited warranty set forth below is given by Troy-Bill LLC with respect to new merchandise purchased and used in the United States, its possessions and territories.
Ein wichtiger Punkt beim Kauf des Geräts Bolens 660 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Bolens 660 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Bolens 660 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Bolens 660 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Bolens 660 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Bolens 660 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Bolens 660 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Bolens 660. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Bolens 660 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
