Benutzeranleitung / Produktwartung 131734G des Produzenten Yard-Man
Zur Seite of 20
Summer Winter Spring Fall Thank you for purchasing an American-built product, WARNING: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-.
Your unit was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. If you violate any of these rules, you may cause serious injury to yourself or others.
This owner's manual covers two models of lawn tractors. Follow only those instructions which per- tain to your model lawn tractor. Refer to the separate deck manual for all informa- tion concerning the deck. IMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL; however, a small amount of oil may be present from the factory.
FIGURE 2. ~ ) Yo(, FIGURE 3. ACTIVATING THE BATTERY Do not activate battery (fill with battery acid) until battery is actually placed in service. Be certain to read previous warnings before activating the battery. NOTE: Some units may have the battery and battery hardware packed with the battery fluid.
-= j, Negative Terminal /~ "" Battery Drain j Tube- / Positive 0 Terminal J'r INSTALLING THE BATTERY 1. Raise the seat. 2. Make certain the positive cable (heavy red wire) and negative cable (heavy black wire) are routed outside the battery opening.
Model 734G Only: Model 734G is equipped with indicator lights, located in the steering wheel. The steering wheel must beassembled as follows for proper operation of the in-dicator lights. 1. Remove the hex lock nut and cupped washer from the steering shaft, and remove the steering bellow.
LIGHT SWITCH The head lamps are operated by pushing the light switch located on the dashboard. The head lamps will only operate when the engine is running. See figure 8. AMMETER The ammeter registers the rate of battery charge or discharge. The ammeter will register on the discharg- ing side with starting the engine.
NOTE: The parking brake must be set if the operator leaves the seat with the engine running. NOTE: The PTO switch must be in OFF position when starting the engine, when shifting into reverse and if theoperator leaves the seat. ~ - " "~ " " CUTTING CONTROLS A.
OPERA TION GAS AND OIL FILL-UP Service the engine with gasoline and oil as instructed in the separate engine manual packed with your trac-tor. Read instructions carefully. NOTE: Your tractor is shipped without oil; however, a small amount of oil may be present from the factory.
I'OiI Hydrostatic Control Lever ~~acket ~ ~. ~. Loosen FIGURE 13. 2. Start the engine. 3. Push the clutch-brake pedal all the way forward. Then release the pedal completely.
CARBURETOR ADJUSTMENTS A WARNING: If any adjustments are made to the engine while the engine is running (e.g. carburetor), disengage all clutches and blades. Keep clear of all moving parts. Be careful of heated surfaces and muffler. Minor carburetor adjustments may be required to compensate for differences in fuel, temperature, altitude and load.
If frequent additions are required, locate the leak andcorrect. Inadequate supply of fluid may result in per- manent internal damage. If the natural color of the transmission fluid haschanged, black or milky, overheating and/or water con- taminate is indicated.
Dimension "B" should be approximately 1/8" less than Dimension "A." See figure 21. To increase Dimension "B," screw tie rod into tie rod end. To decrease Dimen- sion "B," unscrew tie rod from tie rod end. Reassem- ble tie rod.
BATTERY REMOVAL OR INSTAllATION WARNING: When removing the battery, follow this order of disassembly to prevent your wrench from shorting against the frame.
5. Unplug the electric PTO.6. Remove the torque bracket by removing two hex bolts and washers. See figure 23. 7. Remove the belt keeper assembly by removing the four self-tapping screws which hold the belt keeper assembly to the frame at the engine pulley.
forming on essential carburetor parts, fuel lines and fuel tanks.4. Refer to battery storage instructions on page 14. 5. Store unit in a clean, dry area. If the machine is to be inoperative for a period longer than 30 days, prepare for storage as follows.
TROUBLE SHOOTING CHART FOR ELECTRIC START MODELS TROUBLE ngine will not crank LOOK FOR REMEDY Battery installed incor- rectly The battery must be installed with the negative terminal, identified at the terminal post by (Neg, N or -). grounded. The positive terminal (Pos.
TROUBLE SHOOTING CHART FOR ELECTRIC START MODELS TROUBLE LOOK FOR REMEDY No fuel to the carburetor! Gasoline tank empty. Fill. Fuel line or in-line fuel filter plugged. Remove and clean fuel line. Replace filter if necessary. Air filter dirty If the air cleaner is dirty, the engine may not start.
YaRD-MaN COMPANY. P.O. BOX 360940 .CLEVELAND, OHIO 44136 For two years from the date of original retail purchase, YaRD-MaN COMPANY will either repair or replace, at its option, free of charge, F.O.B. factory or authorized service firm, any part or parts found to be defective in material or workmanship.
oom;-c "0"0 (/)~o ~~ o~~ ~~"O" 0 --~>- ~ ~ - 3 < ~ --~- <oAI_Q.O > § in. 5- ~ r-Z~(QO ~G'»<3~ m ~ 0 -- m3 ~~~ ~O 3~= Z ~ ~... ~ C ~-<n~ ...0 (/) (/) Q.c 3c ~-~ 0 -Q. -. ~"O n"o ~ ~~ :.<m (/)Q. -~ -~(/) mQ.
Ein wichtiger Punkt beim Kauf des Geräts Yard-Man 131734G (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Yard-Man 131734G noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Yard-Man 131734G - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Yard-Man 131734G reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Yard-Man 131734G erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Yard-Man 131734G besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Yard-Man 131734G verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Yard-Man 131734G. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Yard-Man 131734G gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
