Benutzeranleitung / Produktwartung WFGA-60FS des Produzenten Wells
Zur Seite of 34
PRINTED IN UNITED ST A TES OF AMERICA WELLS BLOOMFIELD, LLC 2 ERIK CIRCLE, P . O. Box 280 V erdi, NV 89439 www .wellsbloomfield.com telephone: 775-689-5703 fax: 775-689-5976 IMPORTANT: DO NOT DI SCARD.
371 301098 OpM anual for WFGA-60FS Gas Fryer Unless otherwise specified, all commercial cooking equipment manufactured by WELLS BLOOMFIELD, LLC is warranted against defects in ma terials and workmansh.
W A R R A N T Y x i SPECIFICATIONS 1 WFGA-60FS FEATURES & OPERATING CONTROLS 2 PRECAUTIONS & GENERAL INFORMATION 4 AGENCY LISTING INFORMATION 5 I N S T A L L A T I O N 6 PREPARATION PRIOR TO O.
W ARNING: FIRE HAZARD / HOT OIL The HI-LIMIT THERMOST A T is a FIRE PROTECTION DEVICE. If tripping persists, clean debris from the space between the hi-limit bulb and the element to enhance oil flow and facilitate reset. Otherwise, contact your authorized Wells Service Agent for repairs.
FEATURES & OPERATING CONTROLS (continued) 3 For units equipped with OPTIONAL FILTER WAND W1 BURNER INTERLOCK SWITCH Disables burners any time drain valve is not clo s ed. W2 3-WAY VALVE HANDLE HORIZONTAL directs outp ut of filter pump to filter wand.
This appliance is intended for use in commercial establishments only. This appliance is intended to prepare food for human consumpti on. No other use is recommended or autho rized by the manufacturer or its agents. DO NOT open any panel that require s the use of tools for access.
AGENCY LISTING INFORMATION 5 371 301098 OpM anual for WFGA-60FS Gas Fryer This appliance conforms to NSF Standard 4 for sanitation only if installed in accordance with the supplie d Installation Instructions and maintained according to the in structions in this manual.
INSTALLATION NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation.
VENTILLATION REQUI R EMENTS A single WFGA-60FS gas-fired fryer require s a minimum of 700 cubic feet per hour (12 CFM) make-up air. The ventilatio n for the kitch en must have sufficient capacity to pr event a negative-pres sure condit ion. DO NOT obstruct or restri ct ventilation and make-up air required to support combustion.
INSTALLATION (continued) 8 ELECTRICAL INSTALLATION 1. Fryer electrical diagram and trou ble s hooting schematic are located on the inside of the fryer door. 2. The fryer is equipped with a three -prong grounding plug (NEMA 15-5P) for your protection a gai nst shock hazard.
PREPARATION PRIOR TO OPERATION 9 Press POWER SWITCH OFF . Close DRAIN VALVE (lever horizontal). Fill FRYPOT with 4 gallons of cold water. Press POWER SWITCH to FRYER . Wait 10 seconds, then press and hol d CLEAN but t on for six seconds. A beep will sound and readout will displ ay “BOIL”.
PREPARATION PRIOR TO OPERATION (continued) 10 Examine the CRADLE ROLLERS. Adjust or tighten as required. Lubricate the rollers with vegetable oil. DO NOT operate the fryer unless CRA DLE ROLLERS are in place and rotating freely. Install LIFT CRADLE onto CRA DLE PIVOT.
PREPARATION PRIOR TO OPERATION (continued) 11 Close DRAIN VALVE (item 19) by turning the handle to the horizontal ( CLOSED ) position. IMPORTANT : Remember to fill the fryer to the COLD OIL LINE with fresh shortening prior to turning the PO WER SWIT CH to the FRYER position.
PREPARATION PRIOR TO OPERATION (continued) 12 CHECK CONTROLS FOR PROPER OPERATIO N Refer to Operating Instructions, page 13. NOTE: This fryer is equipp ed with two separate auto-ignition burner control syste m s. On startup, each ignition system will tr y three times to prove its associated burner flame.
OPERATION 13 371 301098 OpM anual for WFGA-60FS Gas Fryer PROGRAMMING KEY FUNCTI ONS As each control panel key is pressed, a “beep” will sou nd. Illuminated indicator light for each key will light whenever that ke y is pre ssed, and any time the function associated with that key is active.
OPERATION (continued) 14 PROGRAM MENU TIMES AND TEM PERATURES For solid shortening melt optioned fr y ers , make sure elements are packed with 55 pounds of solid shorteni ng. For all other fr yers, make sure FRYPOT is filled with room temperature liqui d shorteni ng to the COLD OIL LEVEL line inscribed on inside of FRYPOT.
OPERATION (continued) 15 371 301098 OpM anual for WFGA-60FS Gas Fryer USING FUNCTION KEYS PAUSE Halts time countdown while any menu is running and readout displays time remaining. • Purpose: Allows the user to raise fry bask et to inspect product in the middle of a cook cycle.
PRE-HEAT THE FRYER Press any MENU key. If oil temperature has not reached programmed temperature, readout will display “ Pre -” “ HEAt ”, followed by the menu key #, and HEAT indicator will light.
OPERATION - OPTIONAL FILTER WAND 17 371 301098 OpM anual for WFGA-60FS Gas Fryer FRYER OIL WAND Wells p/n 23068 Fryer Oil Wand is u sed as a convenient method of cleaning the sides of the frypot dur ing filtering, and fo r draining oil from the fryer for disposal.
OPERATION - OPTIONAL FILTE R WAND (continued) 18 371 301098 OpM anual for WFGA-60FS Gas Fryer FILTERING OIL - NORMAL OPERATI ON 1. Prepare the filter re servoir pan for filterin g. 2. Turn the DRAIN VALVE HANDLE down to open the drain and fill the filter reservoir.
OPERATION - OPTIONAL FILTER WAND (continued) 19 371 301098 OpM anual for WFGA-60FS Gas Fryer DANGER: BURN HAZARD Contact with hot oil will cause severe b urn s. Always wear protective clothing and heat resistant gloves when operating the fryer, filtering the oil or usi ng th e oil wand.
OPERATION - OPTIONAL FILTE R WAND (continued) 20 371 301098 OpM anual for WFGA-60FS Gas Fryer USING THE OIL WAND - WASH OUT FRYPOT or DISCARD OI L 1. If discarding oil, be sure a suitable hot oil dispo s al container is available. Otherwise, prepare the filter reservoir pan for filtering.
OPERATION - OPTIONAL FILTER WAND (continued) 21 371 301098 OpM anual for WFGA-60FS Gas Fryer RETURN FRYER TO NORMAL OPERATION AFTE R USING THE OIL WAND 1. After washing down the frypot, turn the DRAIN VALVE HANDLE up to close the frypot drain. IMPORTANT: Drain handle must be fully closed in order to activate the heater safety switch.
CLEANING INSTRUCTIONS 22 122 306626 OpM anual for HDG-Series Griddles 122 306626 OpM anual for HDG-Series Griddles DANGER: BURN HAZARD Contact with hot oil will cause severe burns. Allow the fryer to cool before cleaning. Always wear protective clothing and heat resi stant gloves when cleaning the fryer.
23 CLEANING INSTRUCTIONS (continued) 371 301098 OpM anual for WFGA-60FS Gas Fryer 371 301098 OpM anual for WFGA-60FS Gas Fryer PREPARATION Drain oil from fryer before cleaning FREQUENCY Monthly, or as needed TOOLS Low-foaming commercial fryer cleanser Metal disposal container MONTHLY BOIL-OUT 1.
24 371 301098 OpM anual for WFGA-60FS Gas Fryer MAINTENANCE INSTRUCTIONS - CRADLE LIFT AND ROLLERS NOTE: Failure to keep the cradle lift screw properly l ubricated will result in premature wear of the brass lift nut Wear caused by lack of proper lubrication is NOT covered by warranty.
MAINTENANCE INSTRUCTIONS - FILTER SYSTEM 25 IMPORTANT: Make sure all oil is pumped into FRYPOT before removing reserv oir. NOTE: When prop erly ass embled, handle will point away from suction tube on BOTTOM SCREEN. NOTE: Inspect the “O” RING on FILTER SUCTION TUBE for damage.
MAINTENANCE - FILTER SYSTEM (continued) 26 NOTE: Oil should be at least 300ºF (149ºC) DO NOT attempt to filter cold oil. DO NOT attempt to pump oil when less than 300ºF. Cold oil will not pass through the filter paper. Filtering cold oil will re su lt in the premature failure of the filter pump.
MAINTENANCE - FILTER SYSTEM (continued) 27 Carefully and slowly add the contents of one package of FILTER POWDER to the oil in the frypot. Sprinkle filter powder onto surfa c e of the oil at point where it is being drawn down the drain. Brush down sides and bottom of frypot using provide d hi-temperature brush.
MAINTENANCE - DISCARDING USED OIL 28 1. Press the POWER SWITCH to the OFF positio n and allow the oil to cool to 120ºF (49ºC), or less , before attempting to drain the oil from the fryer. All oil should be in the kettle Make sure all oil has been returned to kettle, and there is no oil remaining in the filter reservoir.
29 371 301098 OpM anual for WFGA-60FS Gas Fryer TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY Fryer will not heat Unit disconnected from electric power Reconnect to power Check/reset circuit breaker Menu temp not programmed or set too low Press TEMP key to check current temperature.
30 371 301098 OpM anual for WFGA-60FS Gas Fryer TROUBLESHOOTING (continued) SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY Filter pump will not run Switches not set for filtering Press power s witch (item 1) to FILTER Press pump filter switch (item 6) to O N Pump overload (item 17) tripped Reset overload.
DESCRIPTION PART NO. BASKET, FULL SIZE 22441 BASKET, 1/2 SIZE 22448 FLAVOR-SAVER OIL FILTER POWDER (pk45) 22410 WAOC-1 MOBILE OIL DISPOSAL CADDY 22470 PADDLE, STIRRING CHICKEN 22515 BRUSH, CLEANING F .
Genuine Parts Protect - YOU - All - W ays SER VICE TRAINING - QUALITY SERVICE SER VICE TRAINING - QUALITY SERVICE CUSTOMER SA TISF ACTION CUSTOMER SA TISF ACTION Commercial Food Equipment Service Asso.
Ein wichtiger Punkt beim Kauf des Geräts Wells WFGA-60FS (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Wells WFGA-60FS noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Wells WFGA-60FS - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Wells WFGA-60FS reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Wells WFGA-60FS erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Wells WFGA-60FS besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Wells WFGA-60FS verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Wells WFGA-60FS. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Wells WFGA-60FS gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
