Benutzeranleitung / Produktwartung PELLET 5660(I) des Produzenten United States Stove
Zur Seite of 40
1 Report #: 215 ‐ S ‐ 32 ‐ 4 and 215 ‐ S ‐ 33 ‐ 4 Installation and Operating Manual Models 5660( I ) Safety Notice Please read this en tire manual before installation and use of this pellet fuel ‐ bu rning room heater.
2 TABLE OF CONTENTS Topic Page(s) Introduction 3 Safety Information .
3 Introduction The entire family of United States Stove Company thanks you for pur chasing your new pellet burning room hea ter.
4 SAFETY INFORMATION Be sure to read the entire owner’s manual prior to installing and operating this Pellet heater.
5 SAFETY INFORMATION ‐ continued Keep foreign objects out of the hopper. Contact your local building officials to obtain .
6 SPECIFICATIONS Heating Specifications: Burn Rate: *43,900 btu’s per hour or 5.1 lbs. of fuel per hour Hopper Capacity: 55 lbs. *Dependent upon quality and heating value of pellet fuel.
7 DIMENSIONS ‐ continued The minimum installation dimensions, of the insert opening, are: 32” (813mm) wide x 22 ‐ 3/4” (578mm) high x 12 ‐ 1/4” (311mm) deep.
8 OPERATING INSTRUCTIONS Check and Fill the Fuel Hopper with Pellets: This Pellet Stove is available as a freestanding unit or as a fireplace insert.
9 OPERATING INSTRUCTIONS ‐ continued When the pellets have ignited and flame has been established, the start ‐ up cycle will end; this procedur e takes between 8 and 12 minutes.
10 OPERATING INSTRUCTIONS ‐ continued Control Board Functions: MODE Button: The MODE button allows you to switch operating mode on your Pellet Stove Room Heater.
11 OPERATING INSTRUCTIONS ‐ continued the Auger feed rate will help keep the flames from extinguishi ng on the minimum heat level setting.
12 THERMOSTAT INSTALLATION Optional thermostats are available for use with your pellet stove. A thermostat can help you maintain a constant room temperature.
13 USA 6” CANADA 8” USA 6” CANADA 8” CLEARANCES TO COMBUSTIBLES INSTALL ALL VENTS AT CLEARANCES SPECIFIED BY THE VENT MANUFACT URER! .
14 INSTALLING YOUR ROOM HEATER You have already made the important decision of choosing your U.
15 INSTALLING YOUR ROOM HEATER ‐ continued HORIZONTAL EXHAUST VENT INSTALLATION 1. Locate your pellet stove in a location .
16 INSTALLING YOUR ROOM HEATER ‐ continued HORIZONTAL EXHAUST VENT INSTALLATION .
17 INSTALLING YOUR ROOM HEATER ‐ continued FREESTANDING INTERIOR VERTICAL INSTALLATION 1. Locate your Pellet Stove Room Heater .
18 INSTALLING YOUR ROOM HEATER ‐ continued FREESTANDING EXTERIOR VERTICAL INSTALLATION 1. Locate your Pellet Stove Room Heater i.
19 .
20 INSTALLING YOUR ROOM HEATER ‐ continued SELKIRK DIRECT ‐ TEMP VENT SYSTEM FOR PELLET STOVE HEATERS Images courtesy of Selk.
21 INSTALLING YOUR ROOM HEATER ‐ continued SELKIRK DIRECT ‐ TEMP VENT SYSTEM FOR PELLET STOVE HEATERS Images courtesy of Selk.
22 INSTALLING YOUR ROOM HEATER ‐ continued SELKIRK DIRECT ‐ TEMP VENT SYSTEM FOR PELLET STOVE HEATERS Images courtesy of S.
23 INSTALLING YOUR ROOM HEATER ‐ continued SELKIRK DIRECT ‐ TEMP VENT SYSTEM FOR PELLET STOVE HEATERS Images courtesy of .
24 MOBILE HOME INSTALLATION Mobile home installation shoul d be done in accordance with the Manufactured Home and Safety Stan dard (HUD), CFR 3280, Part 24.
25 INSERT PELLET STOVE INSTALLATION U.S. Stove Pellet Burning Room Heaters are also available as an insert into existing masonry of factory ‐ built fireplaces.
26 INSERT PELLET STOVE INSTALLATION ‐ continued Step 3: Sh roud Top: Facing the back of the unit take the top shroud side piece and fasten, as shown, with 4 screws provided.
27 INSERT PELLET STOVE INSTALLATION ‐ continued Minimum Clearance to Combustibles and Floor Protection .
28 Installation into a Masonry Fireplace: 1. Your chimney must be inspected by a certified chimney sweep or installer to determine its structural condition.
29 VENT TERMINATION LOCATIONS Figure 22 .
30 MAINTENANCE FAILURE TO CLEAN AND MAINTAIN THIS UNIT AS INDICATED MAY RESULT IN POOR PERFORMANCE AND HAZARDOUS SITUATIONS. CLEAN THE HEATER FREQUENTLY AS ACCUMULATION OF SOOT, CREOSOTE OR FLYASH MAY OCCUR.
31 MAINTENANCE ‐ continued Ash Removal ‐ Freestanding Unit: If left neglected ashes will eventually fill the ash pan. Remove the ashes per iodically to avoid unnecessary ash build up.
32 MAINTENANCE ‐ continued Cleaning Heat Exchanger Tubes – Your Pellet Stove Room Heat er is designed with a built in heat exc hanger tube cleaner.
33 MAINTENANCE ‐ continued Chimney/Vent System Cleaning: 1. Soot Formation – When wood products are burned slowly they produce tar and other organic vapors which combine with expelled moisture to form soot.
34 TROUBLE SHOOTING See figure 26, page 31, for component locations . The heater will not light: Check that the heater is plugged in and that the wall outlet has power.
35 TROUBLE SHOOTING ‐ continued The auger motor does not function normally. If the auger shaft does not turn but the motors armature tries to spin then this is a sign your auger is jammed.
36 TROUBLE SHOOTING ‐ continued Door Glass has soot buildup at a fast rate and flame is lazy with black tips.
37 WIRING DIAGRAM .
38 REPLACEMENT PARTS Contact your authorized U.S. Stove Pellet Burning Room Heater dealer to obtain any of these parts.
39 LIMITED WARRANTY United States Stove Company warrants to the original purchaser its Pellet Heaters against premature failure of any component du e to workmanship, quality, or materials as follows: TIME PERIOD: Firebox / Firepot ................
40 .
Ein wichtiger Punkt beim Kauf des Geräts United States Stove PELLET 5660(I) (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie United States Stove PELLET 5660(I) noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für United States Stove PELLET 5660(I) - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von United States Stove PELLET 5660(I) reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über United States Stove PELLET 5660(I) erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon United States Stove PELLET 5660(I) besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von United States Stove PELLET 5660(I) verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit United States Stove PELLET 5660(I). Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei United States Stove PELLET 5660(I) gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
