Benutzeranleitung / Produktwartung UVC-3 des Produzenten Ubiquiti Networks
Zur Seite of 24
720p Indoor/Outdoor IP Camera with Infrared Model: UVC.
Introduction Thank you for purchasing the Ubiquiti Netw orks ™ UniFi® Video Camera. This Quick Start Guide is designed to guide you through the installation of the UniFi Video Camera and show you how to access the Camer a Configuration Interface. This Quick Start Guide also includes the warranty terms.
Hardware Overview Side View Adjusts Camera Up or Down Rotates Camera Rotates Base Sun Shade Bottom View 24V 0.5A POE M/N: UVC Video Camera Port Cover microSD Card Slot Ethernet Port Ethernet Seal LEDs LEDs Ethernet The Ethernet LED will light steady green when an active Ethernet connection is made and flash when there is activity.
Before Y ou Begin A few notes about the camera befor e you begin installation: • If you wish to use the sun shade, it is easier to engage bef ore you install the camera. • The camera has an adjustable base, tilt, and camer a rotation. • The camera should never be pointing straight up or straight down.
Sun Shade If you want to use the Sun Shade , press the Sun Shade Lock and Release T ab from behind the camera and slide the Sun Shade forward until it locks into place.
*640-00069-04* 640-00069-04 Installation Overview The installation process differs depending on if you ar e mounting the camera on a pole or on a wall. Follo w the instructions for the installation that you are performing. Below is an overview of the steps: • Connect one end of the Ethernet cable to the camera.
3. Connect an Ethernet cable to the Ethernet port on the camera. 24V 0.5A POE M/N: UVC Video Camera 4. Remove the Ethernet Seal from the Port Cov er . 5. Slide the Port Cover back onto the camera near the Ethernet port and snap it in place. 6. Wrap the Ethernet Seal around the Ethernet cable and press it into the Port Cover .
W all Mount 1. Remove the adhesive Mounting T emplate from the back ing and place the label on the wall where you want the camera. 2. Use a 7 mm drill bit to drill the holes in the wall. 3. Insert the four Screw Anchors into the wall. 4. Use a Phillips screwdriver t o secure the camera to the wall with the four Screws .
Pole Mount T o mount the UniF i Video Camera on a pole, use the included Metal Strap : 1. Open the Metal Strap by turning the locking screw counter-clockwise. 2. Slide the Metal Strap through the base of the camera. 3. Wrap the Metal Strap around the pole .
Connecting Po wer over E thernet 1. Connect the other end of the Ethernet cable to one of the following: • PoE Adapter Connect the UniFi Video Camera to the Ethernet port labeled POE on the included PoE Adapter . • EdgeSwitch (shown below) or TOUGHS witch Connect the UniFi Video Camera to a port with 24V power enabled and skip steps 2 and 3.
2. Connect an Ethernet cable from your LAN to the Ethernet port labeled LAN on the PoE Adapter . 3. Connect the power cord to the pow er port on the PoE Adapter .
UniFi Video The UniFI Video software is pre-installed on the UniFi NVR (sold separately). If you do not have the UniF i NVR, you can download and install the latest version of the UniF i Video software at downloads.ubnt.com/unifivideo ; the UniF i Video auto-management feature should automatically detect and install your new camera(s).
Camera Configur ation Interface Access the Camera C onfiguration Interface if you have not yet installed the UniFi Video software, or plan t o use the UniFi Video Camera as a stand-alone camera without the UniFi Video software. 1. Ensure that your host machine is connected to the same LAN as the UniFi Video Camera.
5. The Main screen will appear and you should see a live video stream from the UniFi Video Camera. Adjusting the Camera View Adjust Camera Up or Down Rotate Camera Rotate Base Note: Remove the protective plastic film from the camera lens and IR LEDs. For details on using the UniF i Video software, refer to the U ser Guide at: documentation.
Specifications UniFi Video Camera Dimensions 225 x 75 x 75 mm (8.85 x 2.95 x 2.95") Weight 373 g (13.1 oz) Ports (1) 10/100 Ethernet Port, microSD Card Slot Sensor Progressive Scan RGB CMOS ¼" Lens 3.
Safety Notices 1. Read, follow , and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer . W ARNING: Do not use this product in location that can be submerged by water . W ARNING: A void using this product during an electrical storm.
Limited W arranty UBIQUITI NETWORKS, Inc (“UBIQUITI NET WORKS”) warrants that the product(s) furnished hereunder (the “Product(s)”) shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation.
Disclaimer EXCEPT FOR ANY EXPRESS W ARRANTIES PROVIDED HEREIN, UBIQUITI NETWORKS, ITS AFFILIATES, AND IT S AND THEIR THIRD P ARTY DA T A, SERVICE, SOFTWARE AND HARDW ARE PROVIDERS HEREBY DISCLAIM AND .
Note Some countries, states and provinces do not allo w exclusions of implied warranties or conditions, so the abov e exclusion may not apply to you . Y ou may hav e other rights that vary from country to country, state to state, or province t o province.
Industry Canada This Class A digital apparatus complies with Canadian CAN ICES-3(B). T o reduce potential radio interference to other users , the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r .p .
RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
Español La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
Declaration of Conformity Česky [Czech] UBIQUITI NET WORKS tímto prohla uje, e tent o UBIQUITI NET WORKS device, je ve shod se základními po adavky a dal ími p íslu n mi ustanoveními sm rnice 1999/5/ES.
Lietuviškai [Lithuanian] UBIQUITI NET WORKS deklaruoja, kad šis UBIQUITI NET WORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB Direktyvos nuostatas.
Ein wichtiger Punkt beim Kauf des Geräts Ubiquiti Networks UVC-3 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Ubiquiti Networks UVC-3 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Ubiquiti Networks UVC-3 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Ubiquiti Networks UVC-3 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Ubiquiti Networks UVC-3 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Ubiquiti Networks UVC-3 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Ubiquiti Networks UVC-3 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Ubiquiti Networks UVC-3. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Ubiquiti Networks UVC-3 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
