Benutzeranleitung / Produktwartung Communications System ConnecT/R des Produzenten Spirit
Zur Seite of 32
SPIRIT ® Communications System ConnecT/R Owner’s Manual.
Table of Contents Introduction 1 Installation 4 Step 1—Set the MODE switch 5 Step 2—Set the ADMIN switch 8 Step 3—Mount the ConnecT/R 9 Step 4—Connect the ConnecT/R 10 Step 5—Test the Equipm.
IMPORTANT SAFETY INSTRUCTIONS To reduce risk of injury from fire or electric shock, always follow basic safety precautions when using this product. The safety symbol (exclamation point inside a triangle) on the ConnecT/R alerts you to the important operat- ing and maintenance instructions below.
product. Opening the product may expose you to dangerous voltages or other risks. 10. 11. 12. During thunderstorms, avoid using tele- phones except cordless models. There may be a slight chance of electric shock from lightning. Do not use a telephone in the vicinity of a gas leak.
Introduction The following descriptions define important terms used in this manual. ● The SPIRIT ® Communications System ConnecT/R provides you with the ability to add telephone devices to your SPIRIT System. It connects to the controller. ● The controller is the central processor through which all SPIRIT calls in your company are processed.
2 Although you can have a SPIRIT Telephone connected to the SPIRIT ConnecT/R, it isn't necessary. In fact, many business uses, such as telephones in hotel lobbies or facsimile ma- chines with built-in telephones, will not have a SPIRIT Telephone attached to the ConnecT/R.
SPIRIT Telephone (6 or 24 buttons) 308 or 1224 Controller ConnecT/R Data Terminal Facsimile Machine Standard Telephone Credit Card Reader Cordless Telephone Autodialer Answer/ Record Machine Modem Computer 3 Figure 2.
4 Installation A complete ConnecT/R has the components shown in Figures 3 and 4. You could have two telephone devices attached and you do not have to have a SPIRIT Telephone attached. INSTALLATION INSTRUCTIONS 1. Never install telephone wiring during a lightning storm.
AC Power Telephone Device: Fax, Modem, Answer/Record Outlet Machine, Telephone, etc. Controller 4-Wire Cords Directly connected by a cord from one unit to the other, or connected via a wiring run.
6 Telephone Device Business Requirement MODE Corded or cordless telephone Have another phone that acts like an extension to the 1 attached SPIRIT Telephone. Corded or cordless telephone located Ensure privacy between the SPIRIT Telephone and the 2,3,4 somewhere other than the SPIRIT other attached phone.
● ● ● ● 7 Mode 1 (equal access) gives the telephone device and the SPIRIT Telephone equal access to the connection, regardless of which made the connection first (like an extension phone in your home). You could use this mode, for example, if the attached device is a cordless phone and you want to use it as an extension.
8 Step 2 — If the telephone device has touch tone dialing, set ADMIN for call restrictions. Both rotary and touch tone devices can be restricted from making certain kinds of calls.
Use the following table to choose the setting appropriate for your needs. ADMIN Setting Restrictions 1 None. (Allows unrestricted calling.) 2 Prohibits dialing 0 or 1 as the first digit. 3 Prohibits dialing 0 or 1 as the first or second digit. 4 Prohibits dialing outside calls.
10 5. Press the tabs firmly into position. 6 . 7 . With the tabs at the top, hold the ConnecT/R against the wall where you plan to mount it and use a pencil to mark the location of the holes in the tabs. The bottom of the ConnecT/R should be at least two feet from the floor.
4-Wire Cords STATION JACK Sample Answer/ Record Machine 3. 11 CTRLR jack on the back of the ConnecT/R and connect the other end into the controller. You can do this either by plugging it into the STATION jack on the controller or by plug- ging it into a modular wall jack connected via a wiring run to the STATION jack on the controller.
12 5. ConnecT/R. You can connect it by plugging it into the TEL DEVICE jack on the ConnecT/R or by plugging it into the wall jack that is connected to the TEL DEVICE jack on the ConnecT/R. To install two telephone devices on a ConnecT/R, use a T-type adapter (AT&T part # 267A2 or 267A).
Step 5 — Test the equipment. – – After the ConnecT/R is installed, test the tel- phone device and SPIRIT Telephone as follows. 1. To test for dial tone, pick up the receiver (or its equivalent) of the telephone device and listen.
14 Using the Telephone Device Note that the ConnecT/R may feel warm under normal operation. Telephone devices attached to the ConnecT/R will operate similarly to the way they would if they were instal.
NOTE: The ability of a touch tone tele- phone device to place certain calls is based on the way ADMIN was set on the ConnecT/R. A rotary device is restricted according to the way the port was customized. To place an intercom call, lift the receiver or its equivalent and dial [ # ] [ # ] on a touch tone device or 1 1 on a rotary device.
16 Interactions with SPIRIT System Features The following charts describe how the telephone device will interact with specific SPIRIT features. Features Interactions Limitations Auto Callback (1224/2448 If attached SPIRIT Telephone uses the feature, Telephone device cannot models only) device will ring when callback occurs.
Features Interactions Limitations HFAI If a SPIRIT Telephone is attached to the HFAI can't be turned on or ConnecT/R and if HFAI is on, telephone device off from telephone device.
18 Features Interactions Limitations Message Light When telephone device is in use, Message light on None. SPIRIT Telephone (if one is attached) will flash on and off as an alert. To turn this Alert feature off, press [ 1 ] [ # ] on the SPIRIT Telephone without lifting the receiver.
Troubleshooting This section should help you determine the Remember that the way your SPIRIT System cause of problems you might encounter and was customized may influence how a particular help you resolve them.
20 Operational Difficulty What to Check Hold The call is lost Someone else picked up the held call Other party hung up Telephone device can't access call put on hold by SPIRIT Telephone Miscellan.
Operational Difficulty What to Check Cordless Telephone Doesn't ring SPIRIT customized ringing and line-use options* Receiver out of range Low batteries in cordless phone Ringing switch on cordle.
22 Operational Difficulty What to Check Ring pattern not the same as SPIRIT Telephone This is common; there is nothing wrong. Range is short. Move the base to a more central location. Wall mount the base unit (elevating it may increase its range). Be sure the base unit is at least three feet from metal structures or objects.
Operational Difficulty What to Check Messages consist of dial tone only This can occur if the calling party hangs up without leaving a message and the answer/ record machine requires a signal from the Central Office before terminating the recording process.
24 General Operational Difficulty What to Check Modem Won't dial out SPIRIT customized line-use option* ADMIN switch setting Data distortion or interruption MODE switch setting Doesn't answe.
Appendix A — Wiring Requirements ● ● ● ● 25 Note the following cabling requirements before connecting the equipment. If these limits (which are the same ones that apply to our current SPIRIT System) are exceeded, the ConnecT/R may not work properly.
26 Appendix B — Limited Product Warranty and Limitation of Liability AT&T warrants that the product will be free from defects in material and workmanship for one year from the date of purchase.
Index Answer/record machines 2, 6 Outside call 14 Answering Calls 14 Applications 3 AT&T Helpline 19 Automatic Line Selection 14, 16 Call restrictions 8 Controller 1 CTRLR jack 11 Emergency number.
FCC Warning Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Ein wichtiger Punkt beim Kauf des Geräts Spirit Communications System ConnecT/R (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Spirit Communications System ConnecT/R noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Spirit Communications System ConnecT/R - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Spirit Communications System ConnecT/R reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Spirit Communications System ConnecT/R erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Spirit Communications System ConnecT/R besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Spirit Communications System ConnecT/R verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Spirit Communications System ConnecT/R. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Spirit Communications System ConnecT/R gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
