Benutzeranleitung / Produktwartung KENMORE POWER MISER 153.336331 des Produzenten Sears
Zur Seite of 24
" r ] Gas Water Heater Owners Manual NOT FOR USE IN MOBILE HOMES MODEL NUMBERS: 153.336331 30 Gal. 153.336332 30 Gal. 153.336431 40 Gal. 153.336432 40 Gal. 153.336631 30 Gal. 153.336701 30 Gal. High Altitude 153.336801 40 Gal. High Altitude 153.336901 30 Gal.
WARNING Improper installation, adjustment, alteration, service or mainte- nance can cause DEATH, SERIOUS BODILY INJURY OR PROP- ERTY DAMAGE. Refer to this manual for assistanceor consult your local Sears Service Center for further information.
// WARNING _, gas water heater cannot operate properly without the cor- rect amount of air for combustion. Do not install in a confined area such a closet, unless you provide air as shown in the "Locating The New Water Heater" section. Never obstruct the flow of ventilation air.
General Safety ............................................................................................................................... _,_ Table of Contents ......................................................................................
thank You for purchasing a Sears water heater. Properly installed and maintained, it should give you years of trouble free service. If you shoufd decide that you want the new water heater professionally insta]led, contact the local Sears Service Center or any Sears store.
............I I1' Materials Needed To simplify the installation Sears has available the instaila- tion parts shown below. You may or may not need all of these materials, depending on your type of installation.
Turn "OFF" the gas supply to the water heater. WARNING If the main gas line shutoff valve sew- ing all gas appliances is used, also shut "OFP' the gas at each appliance. Leave all gas appliances shut "OFF" until the water heater installation is completed.
Facts to Consider About the Location You should carefully choose an indoor location for the new water heater, because the placement is a very impor- tant consideration for the safety of the occupants in the building and for the most economical use of the appli- ance.
Combustion Air and Ventilation for Appliances Located in Unconfined Spaces -Unconfined Space is a space whose volume is not lessthan 50 cubic feet per 1,000 Btu per hour of the aggregate input rating of all appliances installed in that space.
Water Piping WARNING HOTTER WATER CAN SCALD: Water heaters are intended to produce hot water. Water heated to a temperature which will satisfy clothes washing, dish washing, and other sanitiz- ing needs can scald and permanently injure you upon con- tact.
WARNING The temperature-pressure relief valve must be manually operated at least once a year. Caution should be taken to ensure that (1) no one is in front of or around the outlet of the temperature-p.
Venting (cont'd) WARNING f Be surevent pipe is properly connected to prevent escape of dangerous flue gases which couldcause deadly asphyxia|ion; WARNING Chemicalvapor corrosion of the flue and vent system may occur if air for combustion contains certain chemical vapors.
Installation Checklist BEFORE LIGHTING THE PILOT: 1. Check the gas lines for leaks. a. Use a soapy water solution. DO NOT test for gas leaks using a match or open flame. b. Brush the soapy water solution on all gas pipes, joints and fittings. c. Check for bubbling soap.
WARNING BEFORE LIGHTING [PROPANE (L.P.) GAS WATER HEATERS]: Propane (L.P.) gas is heavier than air. Should there be a leak in the system, the gas will settle near theground; Basements, crawl spaces, skirted areas under mobile homes (even when ventilated), closets and areas below ground level will serve as pockets for the accumulation of this gas.
I iiii i , I I FOR YOUR SAFETY READ BEFORE LIGHTING , WARNING I If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand.
Due to the nature of the typical gas water heater, the water temperature in certain situations may vary up to 30°F higher or lower at the point of use such as, bathtubs, showers, sink, etc.
Start Up Conditions CONDENSATION Whenever the water heater is filled with cold water, a cer- tain amount of condensation will form while the burner is on. A water heater may appear to be leaking when in fact the water is condensation. This usually happens when.
SMELLY WATER (cont'd) If the smelly water persists after the anode replacement and chlorination treatment, we can only suggest that con- tinuous chlorination and filtering conditioning equipment be considered to eliminate the water problem. Do not remove the anode leaving the tank unprotected.
Venting System Inspection At least once a year a visual inspection should be made of the venting system. You should look for: I. Obstructions which could cause improper venting. The combustion and ventilation air flow must not be obstructed. 2. Damage or deterioration which could cause improper venting or leakage of combustion products.
r!ll,i Temperature-Pressure Relief Valve Operation The temperature-pressure relief valve must be manually operated at least once a year. I TEMPERATURE-PRESSURE DRAIN LINE _" WARNING When checking.
Use this guide to check a "Leaking _' water heater. Many suspected "Leakers" are not leaking tanks. Often the source of the water can be found and corrected. If you are not thoroughly familiar with gas codes your water heater, and safety practices, contact the Sears Service Center to check the water heater.
ua u_ o_ _m zO / I J Ii - i:E 11'_ ._ m_m 00_ qD ¢o 22.
1..i.1 . MMMM JZJs pl ° _S SiR -I° N_ _|_ _ c c c o c © C © c o c o c oh o _ L_ L_ CC ¢_ ¢-, 0 C O_ 0 _ 0 C 0 L¢) CO 0 L_ L_ CO ,'_ ¢'4 O_ Oh > o s_ _ o 5_ _ m ¢N P_ c9 cco o8 co 99 m m t _m M- i ,T'- e,l t-.. o O I ,T'- tl {'-4 b.
...................................................................... iiiimll! About Your Warranty Some warranties say that you must drain the tank once a month. •Yourtank will last longer if you do this. Your Sears warranty is good whether you drain the tank often or not.
Ein wichtiger Punkt beim Kauf des Geräts Sears KENMORE POWER MISER 153.336331 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Sears KENMORE POWER MISER 153.336331 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Sears KENMORE POWER MISER 153.336331 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Sears KENMORE POWER MISER 153.336331 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Sears KENMORE POWER MISER 153.336331 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Sears KENMORE POWER MISER 153.336331 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Sears KENMORE POWER MISER 153.336331 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Sears KENMORE POWER MISER 153.336331. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Sears KENMORE POWER MISER 153.336331 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
