Benutzeranleitung / Produktwartung ST32000641AS des Produzenten Seagate
Zur Seite of 42
Product Manual Barracuda ® XT 100586689 Rev. D September 2010 ST32000641AS ST33000651AS.
Copyright © 2010 Seagate Technology LLC. All rights reserved. Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries.
Barracuda XT SATA Product Manual, Rev. D Contents Seagate Technology Support Services . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . .
Barracuda XT SATA Product Manual, Rev. D.
Barracuda XT SATA Product Manual, Rev. D Figures Figure 1 5V current profile (3000GB) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Figure 2 12V current profile (3000GB) . . . . . . . . . . . . .
Barracuda XT SATA Product Manual, Rev. D.
Barracuda XT SATA Product Manual, Rev. D 7 For information regarding online support and services, visit http://www .seag ate.com/www/en-us/about/ contact_us/ Available services include: • Presales &.
8 Barracuda XT SATA Product Manual, Rev. D.
Barracuda XT SATA Product Manual, Rev. D 9 1.0 Introduction This manual describes the functional, mechanical and interface specifications for the following Seagate Barracuda ® XT model drives: These .
10 Barracuda XT SATA Product Manual, Rev. D Drive Specifications www.seagate.com 2.0 Drive Specifications Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power.
Barracuda XT SATA Product Manual, Rev. D 11 www.seagate.com Drive Specifications * One Gbyte equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. * *During periods of drive idle, some offline activity may occur according to the S.
12 Barracuda XT SATA Product Manual, Rev. D Drive Specifications www.seagate.com 2.3 Recording and interface technology Interface SATA SATA Recording method Perpendicular Perpendicular Recording densi.
Barracuda XT SATA Product Manual, Rev. D 13 www.seagate.com Drive Specifications case power consumption, using only random seeks with read or write latency time.
14 Barracuda XT SATA Product Manual, Rev. D Drive Specifications www.seagate.com 2.6.0.1 Typical 5V startup and operation current profiles (3000GB) Figure 1 5V current profile (3000GB) 2.
Barracuda XT SATA Product Manual, Rev. D 15 www.seagate.com Drive Specifications 2.6.0.3 Typical 5V startup and current profiles (2000GB) Figure 3 5V current profile (2000GB) 2.
16 Barracuda XT SATA Product Manual, Rev. D Drive Specifications www.seagate.com 2.6.1 Conducted noise Input noise ripple is measured at the host system power supply across an equivalent 80-ohm resistive load on the +12V line or an equivalent 15-ohm resistive load on the +5V line.
Barracuda XT SATA Product Manual, Rev. D 17 www.seagate.com Drive Specifications 2.7 Environmental specifications 2.7.1 Ambient temperature Ambient temperature is defined as the temperature of the environment immediately surrounding the drive. Actual drive case temperature should not exceed 69°C (156°F) within the operating ambient conditions.
18 Barracuda XT SATA Product Manual, Rev. D Drive Specifications www.seagate.com 2.7.5 Shock All shock specifications assume that the drive is mounted securely with the input shock applied at the drive mounting screws. Shock may be applied in the X, Y or Z axis.
Barracuda XT SATA Product Manual, Rev. D 19 www.seagate.com Drive Specifications 2.8.1 Test for Prominent Discrete Tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing.
20 Barracuda XT SATA Product Manual, Rev. D Drive Specifications www.seagate.com 2.10 Warranty To determine the warranty for a specific drive, use a web browser to access the following web page: support.seagate.com/customer/warranty_validation.jsp From this page, click on the “Verify Your Warranty” link.
Barracuda XT SATA Product Manual, Rev. D 21 www.seagate.com Drive Specifications This equipment is designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation.
22 Barracuda XT SATA Product Manual, Rev. D Drive Specifications www.seagate.com caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals as electronic drive component reliability can be affected by the installation environment.
Barracuda XT SATA Product Manual, Rev. D 23 3.0 Configuring and Mounting the Drive This section contains the specifications and instructions for configuring and mounting the drive.
24 Barracuda XT SATA Product Manual, Rev. D Configuring and Mounting the Drive www.seagate.com For installations which require cables, you can connect the drive as illustrated in Figure 5 . Figure 5 Attaching SATA cabling Each cable is keyed to ensure correct orientation.
Barracuda XT SATA Product Manual, Rev. D 25 www.seagate.com Configuring and Mounting the Drive Figure 6 Mounting dimensions (3000GB model).
26 Barracuda XT SATA Product Manual, Rev. D Configuring and Mounting the Drive www.seagate.com Figure 7 Mounting dimensions (2000GB model).
Barracuda XT SATA Product Manual, Rev. D 27 4.0 SATA Interface These drives use the industry-standard Serial ATA(SATA) interface that supports FIS data transfers. It supports ATA programmed input/output (PIO) modes 0 to 4; multiword DMA modes 0 to 2, and Ultra DMA modes 0 to 6.
28 Barracuda XT SATA Product Manual, Rev. D SATA Interface www.seagate.com Notes 1. All pins are in a single row, with a 1.27 mm (0.050”) pitch. 2. The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the mating sequences are: • the ground pins P4 and P12.
Barracuda XT SATA Product Manual, Rev. D 29 www.seagate.com SATA Interface 4.3 Supported ATA commands The following table lists Serial ATA standard commands that the drive supports. For a detailed description of the ATA commands, refer to the Serial ATA International Organization: Serial ATA Revision 2.
30 Barracuda XT SATA Product Manual, Rev. D SATA Interface www.seagate.com Recalibrate 10 H Security Disable Password F6 H Security Erase Prepare F3 H Security Erase Unit F4 H Security Freeze F5 H Sec.
Barracuda XT SATA Product Manual, Rev. D 31 www.seagate.com SATA Interface 4.3.1 Identify Device command The Identify Device command (command code EC H ) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data, whose contents are shown in on page 29.
32 Barracuda XT SATA Product Manual, Rev. D SATA Interface www.seagate.com 48 Reserved 0000 H 49 Standard Standby timer, IORDY supported and may be dis- abled 2F00 H 50 ATA-reserved 0000 H 51 PIO data.
Barracuda XT SATA Product Manual, Rev. D 33 www.seagate.com SATA Interface 80 Major version number 003E H 81 Minor version number 0028 H 82 Command sets supported 346B H 83 Command sets supported 7F01 H 84 Command sets support extension (see note following this table) 4163 H See Word 108-111 note.
34 Barracuda XT SATA Product Manual, Rev. D SATA Interface www.seagate.com Description (if bit is set to 1) Bit Word 63 0 Multiword DMA mode 0 is supported. 1 Multiword DMA mode 1 is supported. 2 Multiword DMA mode 2 is supported. 8 Multiword DMA mode 0 is currently active.
Barracuda XT SATA Product Manual, Rev. D 35 www.seagate.com SATA Interface 4.3.2 Set Features command This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets BSY, checks the contents of the Features register, clears BSY and generates an interrupt.
36 Barracuda XT SATA Product Manual, Rev. D SATA Interface www.seagate.com 4.3.3 S.M.A.R.T. commands S.M.A.R.T. provides near-term failure prediction for disk drives. When S.M.A.R.T. is enabled, the drive monitors predetermined drive attributes that are susceptible to degradation over time.
Barracuda XT SATA Product Manual, Rev. D 37 Index A acceleration 18 acoustics 18 active mode 16 agency certification 20 altitude 17 ambient temperature 12, 17 areal density 12 ATA commands 29 Australi.
38 Barracuda XT SATA Product Manual, Rev. D P perpendicular recording technology 9 physical characteristics 12 point-to-point 9, 23 power consumption 12 power dissipation 13 power management modes 16 .
Barracuda XT SATA Product Manual, Rev. D 39 Write Buffer 30 Write DMA 30 Write DMA Extended 30 Write DMA FUA Extended 30 Write DMA Without Retries 30 Write Log Extended 31 Write Multiple 31 Write Mult.
40 Barracuda XT SATA Product Manual, Rev. D.
.
Seagate Technology LLC AMERICAS Seagate Technology LLC 920 Disc Drive, Scotts Valley, California 95066, United States, 831-438-6550 ASIA/PACIFIC Seagate Singapore International Headquarters Pte.
Ein wichtiger Punkt beim Kauf des Geräts Seagate ST32000641AS (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Seagate ST32000641AS noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Seagate ST32000641AS - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Seagate ST32000641AS reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Seagate ST32000641AS erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Seagate ST32000641AS besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Seagate ST32000641AS verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Seagate ST32000641AS. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Seagate ST32000641AS gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
