Benutzeranleitung / Produktwartung VOD128 des Produzenten Audiovox
Zur Seite of 31
OPERA TION MANUAL 128-7935A V OD128 12.1" O VERHEAD LCD MONITOR WITH D VD PL A YER ®.
An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation.
• 12.1 " TFT (Thin Film T ransistor) Active Matrix LCD (Liquid Crystal Display) Monitor • Built-in DVD Player • Auto On with Disc insertion • Selectable (M1 and M2) IR Receive and T ransm.
4 CONTROLS AND INDICA TORS DIAGRAM (FRONT VIEW) 1 2 3 4 5 6 7 8 9 10 1 1 12 13 14 15 16 17 18 1. EJECT ( ) Button This Button is used for ejecting discs from the disc compartment. ( Note: Disc can be ejected with the unit turned Off. V ehicle ignition must be in Run or ACC position ).
5 CONTROL FUNCTION DESCRIPTION (FRONT VIEW) 9. POWER ( ) Button Used to turn the system on/off. 10. Dome Lights Provide additional interior illumination. 1 1. Infrared T ransmitter and Sensor T ransmits audio to wireless headphones. Also allows the remote control to operate the VOD128 and to control other accessories in the system.
Side View Back View CONTROL FUNCTION DESCRIPTION (SIDE VIEW AND BACK VIEW) 6 1 3 1. Headphone Jack Allow the use of wired headphones with a 1/8" (3.5mm) plug for listening to the video program audio. 2. Smart Port AUX Cable - Connect Auxiliary A V Input.
7 REMOTE CONTROL OPERA TION MAIN FUNCTION DESCRIPTION Battery Installation Before attempting to operate your Remote Control, install the batteries as described below . 1) T urn the Remote Control face down. Using your finger , slide the battery cover off in the direction of the arrow .
8 Function control i s availabl e on the uni t and the r emote con trol. Function not ava ilable in t his model. * ** 1. 2. 3. 4. 5. 6. 7. 8. PO WE R Bu tt on * Pr es s th is but to n t o tu rn the un it ON a nd OFF . MO NI TO R S ELE CT M1 Bu tto n – M2 Bu tto n – SY ST EM M EN U Bu tt on Al lo w th e u ser to ac ces s t he s ys te m me nu .
9 9. 10 . 1 1. 12 . FMM ON / OFF Button* T urns the wireless FM Modulator on or off. CHANNEL SELECT Button* Selects the wireless FM Modulator Frequency (CH1 88.1MHz, CH2 88.3MHz, CH3 88.5MHz, CH4 88.7MHz, CH5 88.9MHz, CH6 89.1MHz, CH7 89.3MHz, CH8 89.
10 AUDIO B utton Press t o displ ay and sel ect the av ailable AUDIO l anguages in DVD mod e. Each ti me you p ress the b utton, th e languag e chang es. Note: T he lang uages for audio var y from dis c to dis c. SUBTIT LE Butt on Press t o displ ay and sel ect the av ailable s ubtitl e languag e in DVD mo de.
1 1 A- B B ut to n Al lo w us er t o r ep e at th e pl ay b ac k fr om p oi nt A t o p oi n t B . Pr es s A- B b ut t on On - Sc re e n D is p la y D V D p la y er ZO OM B ut to n Pr es s th is b ut to n to en l ar ge t he pi c tu r e w he n pl ay i ng a D V D d is c .
12 31 . 32 . 33 . 34 . DA Y / NIGHT Mode Button This control toggles the unit between “Day” and “Night” LCD illumination modes. In the “Day” mode, the LCD backlit intensity is at maximum. In “Night” mode, the LCD backlit is dimmed to a preset level that is more suitable for low light operation.
13 The System Menu Contains features and options that let you customize your system to change the screen mode display , OSD language and source default.
14 SYSTEM MENU SCREEN MODE OSD LANGUAGE SOURCE DEF AUL T DVD OSD LANGUAGE ENGLISH SP ANISH FRENCH GERMAN OSD LANGUAGE This allows the user to select the language for the on-screen display . The user can either select English, Spanish, French or German for the OSD language.
15 SETTINGS AND ADJUSTMENTS The Setup Menu contains features and options that let you customize your DVD player . For example, you can set a language for the on- screen display or prevent DVD playback for children. Using the Setup Menu 1. Press the SETUP button on the remote.
16 T V t y p e T V d i s p l a y 4 :3 1 6: 9 L a n g u a g e Vi d e o R a t i n g M i s c S u b t i t l e Audio O S D L a n g u a g e E ng l i s h F re n c h S pa n i s h G er m a n I ta l i a n L a n.
TV T ype The TV TYPE setup allows you to select the system to fit to the color system of the TV to be connected. NTSC - Select this type for NTSC TV P AL - Select this type for P AL TV Multi - Select .
S c r e e n S a v e r L o a d F a c t o r y Lo a d F a c to r y Yes N o L a n g u a g e Vi d e o R a t i n g M i s c Load Factory Load Factory allows you to reset all options to factory settings. * This function will not af fect the Rating control settings.
19 Playing MP3 Discs MP3 is a format for storing digital audio. An audio CD-quality song can be compressed into the MP3 format with very little loss of quality , while taking up much less space. CD-R discs that have been encoded in MP3 format can be played on your DVD player .
20 Flat Mode: pl ay the e ntire dis c This mode is always on (defau lt). Du ring th e Flat M ode all the dat a folde rs with MP3, JP EG & mov ies wil l be play ed in se quence. I f the Fl at Mode functi on is of f, it will on ly play the sel ected f older; other f olders are disab led.
Edit Mode Program View Add to Program Method: Make sure disc playback is off. Move cursor to E dit Mode function and press OK. After Edit Mode is selected, open the folder and select the songs which will be compiled. A check mark appears to the left of the selected song; highlight the Add to program function and press OK.
DVD Basics T o get the optimum use out of the DVD section, make sure you read this section completely . Regional Coding Both the DVD player and DVDs are coded by region. These regional codes must match in order for the disc to play . If the codes don’t match, the disc won’t play .
23 TURNING THE UNIT ON OR OFF 1. Pushing in the Screen Release button will unlock the LCD screen and it will drop down slightly . Pivot the screen downward until a comfortable viewing angle is reached. The hinge friction will hold the screen in position while the system is in use.
24 ACCESSORIES OVERHEAD DOME LIGHTS The Dome Lights integrated into the VOD128 are controlled by a three position slide switch. Sliding the switch to the ON position will turn the lights ON.
25 SOURCE FEA TURE* Video1 The Video 1 input may be connected to a Video Cassette Player (VCP), video game system, or other audio / video devices. T o access the A/ inputs, turn the VOD128 on and press the S (source) button on the VOD128 or the Source button on the remote control until "VIDEO 1" is displayed on the screen.
26 GAME CONTROLLER FUNCTIONAL DESCRIPTION The Game Controller transmits to the VOD128 with two infrared transmitters located on the front of the Game Controller . The Game Controller must be pointed toward the VOD128 for correct operation. Press the source button on the remote control or the unit until the GAME*menu is displayed.
TROUBLESHOOTING 27 PROBLEM IR remote inoperative — V erify that the batteries in the remote are fresh. — V erify that the remote sensor eye is not obstructed. — If monitor is set to M1, press M1 button on remote; If monitor is set to M2, press M2 on remote.
28 PROBLEM Picture is distorted — The disc might be damaged. T ry another disc. — It is normal for some distortion to appear during forward or reverse scan. SOLUTION The icon ( ) appears on screen x — The feature or action cannot be completed at this time because: 1.
REPLACEMENT P ARTS SPECIFICA TIONS Remote Control 136-4427 29 LCD Backlighting Edge Light T ube Resolution 2400 x 480 Pixels 1, 152, 000 Operation T emperature 32 ~131º F (0 ~ 55º C) Storage T emperature -4 ~ 158º F (-20 ~ 70º C) Backlit life 30,000 Hours Video Display System NTSC / P AL Headphone Audio Output 0.
12 MONTH LIMITED WARRANTY Applies t o A udiov o x Mo bile V i de o Pro duc t s AUDIOVOX ELECTRONICS CORP . (the Company) warrants to the original retail purchaser of this product that should this prod.
128-7935A © 200 7 Audiovox Electronics Corp., Hauppauge, NY 1 1788 WWW.
Ein wichtiger Punkt beim Kauf des Geräts Audiovox VOD128 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Audiovox VOD128 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Audiovox VOD128 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Audiovox VOD128 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Audiovox VOD128 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Audiovox VOD128 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Audiovox VOD128 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Audiovox VOD128. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Audiovox VOD128 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
