Benutzeranleitung / Produktwartung CHT-420 des Produzenten Samsung
Zur Seite of 31
Instruction Manual CHT-420 ( Set : DVD-CM420 ) Speaker : SP-420 www .samsungusa.com OPEN/CLOSE CHANNEL DVD VCR FM/AM INPUT EJECT PHONES REC S.MODE S.EFFECT VOL.
3 2 Note to CATV system installer: This reminder is provided to call CATV system installer's attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, P.
5 T able of Contents ◆ 5 - DVD Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 ■ Disc Menu Language . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 ■ Audio Language .
7 Feature Summary System Features • Complete versatility to play DVD, audio CDs, MP3 discs or VHS Tapes. • Watch a DVD while recording a TV show to the VCR. • Auto Setup automatically sets clock and searches for channels. • Remote controls DVD, VCR decks, FM/AM Tuner and Digital Amplifier.
9 8 Front Panel Overview 1 DVD DECK 2 REWIND/REV 3 FAST-FORWARD/FWD 4 SOUND MODE 5 DVD OPEN/CLOSE 6 VCR DECK 7 FM/AM SELECT 8 VCR EJECT 9 POWER 10 HEADPHONE JACK 11 STOP 12 PLAY/PAUSE 13 RECORD 14 SOU.
11 Remote Control Overview Insert Remote Control Batteries • Remove the battery cover by pushing down on the thumb tab and sliding the cover. • Insert two 1.5V “ AAA ” batteries as shown, paying attention to the correct polarities (+/ – ). • When finished, slide the cover until it clicks back into place.
12 13 Basic Connections/Auto Setup In this section, you will connect the DVD-VCR to your television and run Auto Setup, which automatically searches for channels and sets the player’s internal clock. NOTES: • Advanced Connections are covered in Appendix A.
15 14 Basic VHS Playback To play a videotape, simply insert it in the VHS deck and press the Play button. Tapes without Record Safety Tabs can be set to play automatically when inserted; see page 41. 1 Insert VHS Tape Insert a standard VHS videotape into the VHS Deck.
17 16 Menu Language Follow these steps to change the on-screen menu language to English, French or Spanish. 1 Open “MENU” With the DVD in stop mode, press the MENU button. 2 Set “Language” Using the Up/Down and Left/Right buttons, move the selection arrow to “ Language/Idioma/Langue, ” then press ENTER button.
19 T uner Band Setting This feature allows you to manually set the DVD-VCR’s tuner band to Antenna or Cable, whichever you connected to the Antenna In jack during initial setup. • Use this setting only if Auto Setup detected the incorrect tuner band, i.
21 20 Channel Add/Delete Use this feature if Auto Channel Search missed a channel that you would like to add, or added a channel you wish to remove. 1 Open “ MENU ” With the DVD in stop mode, press the MENU button.
1 Open “ MENU ” With the DVD in stop mode, press the MENU button. 2 Select “ Options ” Using the up/down and left/right buttons, move the selection cursor to “ Option Setup, ” then press ENTER to select.
25 24 Follow these steps to choose your preferred language for DVD subtitles. The DVD-VCR will automatically default to the language you choose if it is available on a given DVD.
27 Dynamic Compression Dynamic Compression constrains the dynamic range, i.e. the difference between the quietest and loudest passages of a DVD soundtrack. This enables you to limit loud noises, such as explosions, or raise the volume of quiet passages, such as whispering, while watching a movie.
29 28 Alt Video Out Black Level The Black Level feature adjusts the reference level of black in the video signal to one of two choices: • Low - Standard NTSC black level. Yields consistent contrast through all sources. • High - Enhanced black level, for increased contrast during DVD playback.
31 30 During DVD/CD playback you can select from the following special playback options. To resume normal playback, press the ❿ ll (Play/Pause) button. NOTE : Changing the view during DVD/CD playback will stop the playback. 1 Still Press the ❿ ll (Play/Pause) button on the remote control during playback.
33 You can zoom in at 2 or 4 times the normal magnification while watching a DVD. 1 Open Zoom Magnifying Glass During Playback or Still mode, press the ZOOM button to display the “Magnifying Glass icon” on the screen.
35 A-B Repeat The A-B Repeat function allows you to repeat any segment of a DVD or CD. Simply mark the beginning point (A) and the ending point (B) of the segment you want to review. 1 Select A-B Repeat Function In Play mode, press the REPEAT button, then press left/right to select A-B Repeat.
37 You can insert up to three Bookmarks on your DVDs, so you can jump quickly to your favorite scene or song. 1 Open Bookmark Menu During playback, press the MARK button on the remote control.
39 Random Playback lets the DVD-VCR set a random order for playback of tracks on a CD. 1 Open Playback Mode Menu In play mode, press the MODE button. 2 Select “RANDOM” Using the left/right buttons, move the selection arrow to “ RANDOM ” then press ENTER to select.
41 40 If you want your videotapes to play automatically when you insert them, turn on Auto Play. NOTE: Only tapes that are missing the Record Safety Tab will play automatically when inserted. 1 Open the “MENU” With the DVD in stop mode, press the MENU button.
43 42 You can record a TV show in progress by inserting a blank tape and pressing the REC button. You can even add time in 30-minute increments up to 4 hours by pressing the REC button repeatedly; see page 45. NOTE: Be sure you videotape has a Record Safety Tab.
45 44 Record Speed You can slow down the recording speed from SP to SLP in order to fit six hours of programming on a T-120 tape. 1 Start Recording Follow the Basic Recording instructions on page 43.
47 46 The S-Video or Component Video connection is only for the DVD player. The tuner and VCR will still be viewed through the RF or line inputs. You must follow the “Alt Video Out” instructions on page 29 to activate your alternative (S-Video, Component) video selection.
Connect the front, center, and surround speakers and the subwoofer to the speaker terminals on the back of the main unit. 1 Connect the speakers to the speaker output terminals on the back of the main unit, matching the colors.
You can customize the sound to best fit the specific acoustics of the room by adding a delay to the sound from the center and surround speakers. The delay time is initially set to 0 ms. ◆ You can enjoy the best sound during 5.1 channel surround playback if the distance between you and each speaker is the same.
Dolby Pro Logic II is a new format for playing multichannel audio signals that offers improvement over conventional Dolby Pro Logic. It can be used to decode not only sources recorded in Dolby Surround, but also regular stereo sources into five channels (front left/right, center and surround left/right).
You can automatically or manually tune in to FM and AM stations to listen to radio broadcasts. 1 Press the FM/AM button. • Each time you press the button, the band alternates between FM and AM. 2 Tune in to a station. • Automatic tuning : Hold down l ➛➛ / ❿ ❿ l to begin the automatic tuning.
57 56 Connecting Other Video Equipment You can connect a wide variety of audio/video equipment to your DVD-VCR, including: • An additional VCR • Laser Disc Player • DVD Player • Camcorder • Satellite Receiver • Video Game Since all of these devices use essentially the same connections, they will be described together.
59 58 T echnical Specifications AUDIO 2 Stereo audio inputs, RCA Connector, -8dbm, 47K Ω , Inputs VIDEO 2 Composite video inputs, RCA Connector, 75 Ω , 1Vp-p RF Antenna or CATV Input, F-Connector, 75 Ω AUDIO 1 Stereo audio outputs, RCA Connector, -8dbm, 1.
AK68-00194A(01) 2003.04.07 ELECTRONICS SAMSUNG ELECTRONICS AMERICA, INC. HEADQUARTERS 105 Challenger Road, Ridgefield Park, N.J. 07660-051 1 TEL: 1-800-SAMSUNG SERVICE DIVISION 400 V alley Road, Suite 201, Mount Arlington, NJ 07856 1-800-SAMSUNG (1-800-726-7864) www .
Ein wichtiger Punkt beim Kauf des Geräts Samsung CHT-420 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Samsung CHT-420 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Samsung CHT-420 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Samsung CHT-420 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Samsung CHT-420 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Samsung CHT-420 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Samsung CHT-420 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Samsung CHT-420. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Samsung CHT-420 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
