Benutzeranleitung / Produktwartung R9943 des Produzenten Roberts Radio
Zur Seite of 24
R9943 3 band PLL Synthesised Radio Please read this manual before use ROBER TS Sound for Generations.
Controls .......................................................................... 2- 3 Display ............................................................................... 4 Battery operation ......................................................
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 2 Controls 1. On/Off/Sleep button 2. Light button 3. Waveband, Time set, FM Stereo/Mono button 4. Tuning Up/Down buttons (Top) 1 23 4 5 6 7 5. Telescopic aerial 6.
3 Controls (Right side) 8. Headphone socket 9. Tone control 10. Volume control 11. Rotary tuning control 12. Mains input socket (on rear) 13. Battery compartment (on rear) 11 10 9 8 12 13.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 4 1. Step indicator 2. Sleep/Snooze indicator 3. Summer time indicator 4. Stereo indicator 5. Waveband indicators 6. Frequency/Time indicators 7. Frequency units indicators 8.
5 Battery operation 1. Remove the Battery cover on the rear of the unit by pushing the catches in the direction shown by the arrows. 2. Insert four LR20 (D size) batteries into the spaces in the compart- ment. Take care to ensure all batteries are inserted with the correct polarity as shown inside the battery compartment.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 6 Setting the clock 1. The clock will start running when the batteries are installed or when the radio is connected to the mains supply. The display will show 0:00 .
7 Operating you radio Your radio is equipped with four tuning methods:- Scan tuning, Rotary tuning, Manual tuning, and Memory preset tuning. When switched on your radio will display the waveband and frequency in use. A graphical display similar to a conventional radio tuning dial will be shown in the bottom half of the display.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 8 Manual tuning 1. Press the On/Off button to switch on your radio. 2. Select the required waveband by repeatedly pressing the Band button. For the FM waveband fully extend the Telescopic aerial angle and rotate, if necessary, to obtain best reception.
9 Rotary tuning 1. Press the On/Off button to switch on your radio. 2. Select the required waveband by repeatedly pressing the Band button. For the FM waveband fully extend the Telescopic aerial angle and rotate, if necessary, to obtain best reception.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 10 Presetting stations There are 5 memory presets for each of the 3 wavebands. 1. Press the On/Off button to turn on the radio. 2. Tune to the required station using one of the methods previously described.
11 Recalling a preset station 1. Press the On/Off button to turn on the radio. 2. Select the required waveband by repeatedly pressing the Band button. 3. Momentarily press the required Preset button , the preset number and station frequency will appear in the display.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 12 Wake to buzzer alarm A bleep tone will sound when using the buzzer alarm. The alarm bleep will increase in volume every 15 seconds for one minute followed by one minutes silence before repeating the cycle.
13 Wake to radio alarm When the radio alarm is selected the radio will turn on and play the last station listened to. The radio alarm will sound for one hour unless turned off by pressing the On/Off button . Pressing the On/Off button whilst the alarm is sounding will cancel the alarm for 24 hours.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 14 7. Press the Tuning up/down buttons to set the required radio alarm duration. (1, 2, 3 or 4 hours) 8. Press the button to complete alarm setting. 9. To permanently cancel the alarm press the button until the symbol is removed from the display.
15 Sleep timer The sleep timer will automatically switch off the radio after a preset time has elapsed. 1. Press and continue to hold down the button the display will cycle through the available sleep times in the order 90-60-30-15-90. Release the button when the required sleep time appears in the display.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 16 Headphone socket A 3.5mm Headphone Socket located on the right-hand end of you radio is provided for use with either headphones or an earpiece. Inserting a plug automatically mutes the internal loudspeaker.
17 Tuning step size In Europe and other parts of the world MW tuning steps are 9kHz, in America the MW tuning step size is 10kHz. On FM most countries use 100kHz tuning steps, your radio can however be set so as to allow an FM tuning step size of 50kHz.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 18 Summer time Your radio can be set to advance the clock to summer time by pressing a single button. 1. Ensure that your radio is switched off. Press and hold down the Summer time button until the summer time indicator appears in the display.
19 Reset button If your radio fails to operate correctly, or some digits on the display are missing or incomplete carry out the following procedure. 1.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) Specifications Power Requirements Mains AC 230 volts, 50Hz only Batteries 4 x LR20 (D size) Battery Life Approx. 70 hours of listening for 4 hours a day at normal volume using alkaline cells.
The wire coloured BLUE must be connected to the terminal marked N or coloured BLACK. The wire coloured BROWN must be connected to the terminal marked L or coloured RED. Mains supply The R9943 will operate from a supply of AC 230 volts, 50Hz only. DO NOT cut off the mains plug from this equipment.
If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) These statements do not affect the statutory rights of a consumer.
20 Issue 1 ROBERTS RADIO TECHNICAL SERVICES 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline :- 020 8758 0338 (Mon-Fri during office hours).
Ein wichtiger Punkt beim Kauf des Geräts Roberts Radio R9943 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Roberts Radio R9943 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Roberts Radio R9943 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Roberts Radio R9943 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Roberts Radio R9943 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Roberts Radio R9943 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Roberts Radio R9943 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Roberts Radio R9943. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Roberts Radio R9943 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
