Benutzeranleitung / Produktwartung U31-NG2 des Produzenten Recoton/Advent
Zur Seite of 32
W ARNING: If the information in these instructions are not followed ex- actly , a fi re or explosion may result causing property damage, personal injury or loss of life. FOR YOUR SAFETY Do not store or use gasoline or other fl ammable vapors and liquids in the vicinity of this or any other appliance.
2 FPI U31-2 Gas Fireplace Insert FPI GAS FIREPLACE INSERT Note: Oversize faceplate is 44" x 28" (1 1 18 mm x 71 1mm) TO THE NEW OWNER Congratulations! Y ou are the owner of a state-of-the-art Gas Insert by FPI.
3 FPI U31-2 Gas Fireplace Insert T ABLE OF CONTENTS FPI GAS FIREPLACE INSERT Final Check .............................................................21 OPERA TING INSTRUCTIONS Operating Instructions .............................................21 Lighting Procedure .
4 FPI U31-2 Gas Fireplace Insert SAFETY LABEL This is a copy of the labels that accompany each U31-2 Gas Insert. We have printed a copy of the contents here for your review . The safety label is located on a plate inside the base of the unit visible when the bottom louver is opened.
5 FPI U31-2 Gas Fireplace Insert REQUIREMENTS 5.08: Modifica tions to NFPA-54, Chapter 10 (2) Revise 10.8. 3 by adding the followi ng additional re quirements: (a) For all side wall hor izontally vent.
6 FPI U31-2 Gas Fireplace Insert INST ALLA TION IMPORT ANT : SA VE THESE INSTRUCTIONS The FPI Gas Insert must be installed in ac- cordance with these instructions. Carefully read all the instructions in this manual fi rst. Consult the building authority having jurisdiction to de- termine the need for a permit prior to starting the installation.
7 FPI U31-2 Gas Fireplace Insert INST ALLA TION NOTE: Mantel clearances for Installation into a Zero Clearance Kit are different. Please refer to the Zero Clearance Kit Manual for details.
8 FPI U31-2 Gas Fireplace Insert THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !! Conversion Kit from Natural Gas to Propane Model #402-969 for: U31-NG2 Units 1) T urn the unit off and allow it to cool to room temperature.
9 FPI U31-2 Gas Fireplace Insert INST ALLA TION TEST FOR FLUE SPILLAGE A " spillage" test must be made before the installed unit is left with the customer . Follow the procedure below: 1) Start all exhaust fans in the home and then close all external doors and windows in the house.
10 FPI U31-2 Gas Fireplace Insert LOG SET INST ALLA TION Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced.
11 FPI U31-2 Gas Fireplace Insert INST ALLA TION Logs D)02-46 and E)02-47 in position. 6) Place the Left T op Log D)02-46 on the pin on Log C)02-56 and on top of the cutout on Log A)02-43. 7) Place the notch in Center Log E)02-47 over Log B)02-45 and across the cutout on Log A)02-43.
12 FPI U31-2 Gas Fireplace Insert Diagram 4 Diagram 5 Rear View: T rim Assembly Diagram 2 Diagram 3 Rear View: Faceplate Assembly Diagram 1 F ACEPLA TE & TRIM INST ALLA TION 1) Lay the faceplate panels fl at, face down on something soft so they don't scratch.
13 FPI U31-2 Gas Fireplace Insert BA Y FRONT INST ALLA TION 1) Place the bay door onto the 2 pins on the top of the unit. 2) Install bottom louver by sliding the two bracket clips into the brackets located underneath the bay door and secure with 2 screws into the bracket on the bottom of the Bay Front as per diagram above.
14 FPI U31-2 Gas Fireplace Insert INST ALLA TION WIRING DIAGRAM CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous opera- W ARNING:.
15 FPI U31-2 Gas Fireplace Insert FULL SCREEN FRONT INST ALLA TION 1) Hold the full screen door up against the unit in order to make the following wire connections. Pull the ON/OFF connector wires from the fi rebox and connect them to the switch. Connect the fan switch wires with the wire connectors from the fan speed control.
16 FPI U31-2 Gas Fireplace Insert INST ALLA TION 5) Place Bottom Frame near hinge. Flip hinge over Bottom Frame and secure with 3 screws. 4) Install Spring Hinges on the Left and Right Side of the bottom of the fi rebox using 2 screws per hinge.
17 FPI U31-2 Gas Fireplace Insert HAMPT ON CAST F ACEPLA TE INST ALLA TION 1) Lay the faceplate panels fl at, face down on something soft so they don't scratch. 2) Attach the side fi ller brackets to the left and right sides using 3 screws and washer per side.
18 FPI U31-2 Gas Fireplace Insert 11 ) Mount the cast faceplate panels onto the insert body , sliding the side fi ller brackets into the space between the glass and the fi rebox.
19 FPI U31-2 Gas Fireplace Insert 1) Align the left side Faceplate T rim Bracket with the Firebox Flange and secure using 2 screws as shown in diagram 1. Repeat for right side. Faceplate T rim Bracket Firebox Flange Blanking Plate Flanges 3) Hold the Faceplate T rim up against the unit in order to make the following wire connections.
20 FPI U31-2 Gas Fireplace Insert 5) Place the bottom hooks of the Surround into the bottom slots of the Faceplate. Slightly pull up the Surround and push the top hooks into the top slots of the Faceplate. Push down to secure. T ug on the Sur- round to ensure it is securely locked in place.
21 FPI U31-2 Gas Fireplace Insert OPERA TING INSTRUCTIONS OPERA TING INSTRUCTIONS Before operating this appliance, proceed through the following check list. 1) Read and understand these Instructions before operating this appliance. 2) Check to see that all wiring is correct and enclosed to prevent possible shock.
22 FPI U31-2 Gas Fireplace Insert COPY OF LIGHTING INSTRUCTION PLA TE OPERA TING INSTRUCTIONS SHUTDOWN PROCEDURE 1) Use the rocker switch to turn off the main burner . 2) Open the bottom louver assembly . 3) Push in the gas control knob slightly and turn clockwise to "OFF".
23 FPI U31-2 Gas Fireplace Insert T op View of pilot fl ame Correct fl ame pattern has two strong blue fl ames: 1 fl owing around the thermopile and 1 reaching towards the rear burner (it does not have to be touching the burner).
24 FPI U31-2 Gas Fireplace Insert F AN MAINTENANCE CAUTION: Label all wires prior to disconnection when servicing controls. Wiring error can cause improper and dangerous opera- Remove the 2 screws holding the grate in position. Remove the 2 screws, push Burner T ray to the left, and lift off.
25 FPI U31-2 Gas Fireplace Insert P ARTS LIST 1) 400-01 1 Fan Opening Cover 400-515/P Fan Assembly (120 V) 2) 910-331/P Fan Motor (120 V) 5) 910-750 Power Cord (120 V) 910-752 Wire Harness (intermedia.
26 FPI U31-2 Gas Fireplace Insert P ARTS LIST 402-560/P V alve Assembly - NG 402-562/P V alve Assembly - LP 52) 910-028 Robertshaw V alve -Nat. Gas 910-029 Robershaw V alve - LP 53) 910-190 Piezo Ignitor and nut 54) * V alve Heat Shield 55) 904-702 Fibre Washer 56) * Pilot Bracket 57) 904-240 Burner Orifi ce Nat.
27 FPI U31-2 Gas Fireplace Insert P ARTS LIST Bay Door 400-988 Bay Door c/w Black T rims 102) * Glass Retainer Side 103) * Glass Retainer Front 106) 940-315/P Side Glass 107) 936-243 Gasket - Adhesive.
28 FPI U31-2 Gas Fireplace Insert P ARTS LIST 402-919 Complete Faceplate (Set) with Black T rim - Oversize 41) * Faceplate Side Right - Oversize 42) * Faceplate T op - Oversize 43) * Faceplate Side Left Assy-Oversize 402-534 T rims Pkg.
29 FPI U31-2 Gas Fireplace Insert P ARTS LIST.
30 FPI U31-2 Gas Fireplace Insert 402-971** Cast Faceplates (Set) 187) 910-246 Burner On/Off Switch 188) 910-330 Fan Speed Control (120 V) 189) 904-733 Knob - Black Cast Surround 201) * Cast Faceplate.
31 FPI U31-2 Gas Fireplace Insert W ARRANTY FPI Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance T eam c arefully inspects each unit thoroughly before it leaves our facility . FPI Fireplace Products International Ltd.
Installer: Please complete the following information Dealer Name & Address: ______________________________________________ ___________________________________________________________________ Insta.
Ein wichtiger Punkt beim Kauf des Geräts Recoton/Advent U31-NG2 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Recoton/Advent U31-NG2 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Recoton/Advent U31-NG2 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Recoton/Advent U31-NG2 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Recoton/Advent U31-NG2 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Recoton/Advent U31-NG2 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Recoton/Advent U31-NG2 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Recoton/Advent U31-NG2. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Recoton/Advent U31-NG2 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
