Benutzeranleitung / Produktwartung ET-007 des Produzenten Radio Shack
Zur Seite of 24
Cat. No. 43-0 07 OWNER’S MANUAL Please read before using this equ ipment. ET-007 900 MHz Handsfree Cordless Headset System 43-007.fm Page 1 Wedn esday, March 22, 2000 11:24 AM.
2 FEATURES Your RadioShack ET-007 900 MHz Handsfree Cordless Headset System gives you commu nication with both port- ability and convenience. It includes a corded base te lephone, a 900 MHz digi- tal wireless headset, a wireless headset charger and an infrared rem ote dial card.
3 Carry Strap — lets you hang the remote dial card from your neck for handsfree carrying. Your ET-007 is listed to UL stan dards and meets all applicable FCC stan- dards. READ THIS BEFORE INSTALLATION We have designed you r phone to con- form to federal regula tions and you can connect it to mo st phone lines.
4 The ET-007 also complies with the limits for a Class B device as specified in Part 15 of FCC Rules. These limits provide reasonable prot ection against rad io and TV interference in a residential ar ea. However, your ET-007 migh t cause TV or radio interfere nce even when it is op- erating properly.
5 CONTENTS Installation .. ................ ................ ................ ................. ................ ................ ............ 6 Selecting a Location .............. ................ ................. ................ ................ .
6 INSTALLATION SELECTING A LOCATION You can plac e the ET-007 on a desk or table, mount it on a standard wall plat e, or mount it direct ly on a wall. Choose a location that is: • near an AC outlet .
7 4. Route the adap ter's cord through the strain relie f slot on the bottom of the phone. 5. Lift the b ase telephone's a ntenna to a vertical position . CONNECTING THE HEADSET CHARGER , WIRELESS HEADSET AND INFRARED REMOTE DIAL CARD To connect the h eadset charger, con - nect the headset char ger’s built-in AC cord to the AC outlet.
8 • The INTERCOM and HOLD in di- cators on the co rded phone stop flashing after th e headset charger and wireless headset are con - nected, even when there is no battery pack in the headset. If they flash, mo ve the headset an d charger clos er to the co rded phone.
9 3. Route t he modular c ord into the right gr oove on the moun ting bracket and rou te the AC adapter's cord into the left groove . 4. Press up on the ha ndset holder to remove it, turn it over , then slide it back down into its slot.
10 PREPARATION Follow the steps in “ Connecting the Headset Charger, Wire less Headset and Infrared Remote Dial Card” on Page 7 to install the battery in the he adse t. CHARGING THE BATTERY PACK After you inst all a battery pa ck, let the battery charge f or about 24 ho urs b ef or e you use the headset t he first time.
11 SETTING THE DIALING MODE Set TON E/ PU LS E on the bottom of the corded phone for the type of service you have, either tone or pulse (rotary). If you are not sur e which typ e you have, do this simple te st. 1. Set TONE/PULSE to TONE . 2. Lift the h andset and listen fo r a dial tone.
12 SETTING THE RINGER VO L U M E To adjust the ringer volume on the cord- ed base phone, slid e the switch on the right side of t he base to RINGER OFF , LOW or HI .
13 Listening Safely To protect your hearing , follow these guidelines when yo u use the headset. • Set the volume to th e lowest setting before you beg in listening. Afte r you begin listening, adjust the volume to a comforta ble level. • Do not listen at ext remely high vol- ume levels.
14 OPERATION MAKING AND ANSWERING CALLS Using the Handset To make a call, p ick up the handset an d dial normally. The IN USE indicator flashes when you receive a ca ll and lights while the phone is in use. Pick up the ha ndset to answer a call and place the handset on the base to end a call.
15 To switch from th e headset to the ha nd- set, press HOLD on the infrared remote dial card. The IN USE/BATT. LOW indi- cator flashe s. Pick up the handset to a n- swer the call. The headset sounds a tone if the hand set is not picked up wi th- in about 3 0 se conds.
16 USING REDIAL You can quickly dial the la st number di- aled. Wh en you heard a dial tone, press REDIAL on the corded pho ne, or on the infrared remote dial card if you want to use the headset fo r dialing. Note: The base co rded phone a nd the headset record th eir own last nu mber d i- aled.
17 USING HOLD To put a caller on hold, press HOLD . The HOLD indicator on the corded phone flashes and you can hang up the hand- set without disconnectin g the call.
18 3. Enter the numb er you want to store (up to 20 digit s can be stored ), including any pause or to ne entries (see “Entering a Pause in a Memory Number” on Pa ge 18 or “Usin g T one Service on a Pulse Lin e” on Page 17). 4. Press MEMOR Y on the base.
19 Chain-Dialing For quick recall of numbers for special services (such as b ank-by-phone or al- ternate long-dista nce), you can stor e each group of numbe rs in its own mem- ory location. Then, when calling special services, dia l the service's main number first.
20 T ROUBLESHOOTING We do not expect you to have an y problems with your p hone, but if you do, the follo w- ing suggestions might help. If you still have problems, take the phone to your local RadioShack store for assist ance. Problem Suggestion Interference is severe .
21 If you still have problems, disconnect the phone. If other phones on the s ame line work properly, t he fault is in this ph one or its installat ion. If you ca nnot find the pr ob- lem, take the phone to yo ur local RadioShack store fo r assistance.
22 CARE To enjoy your RadioSha ck ET-007 900 MHz Handsfree Cordless Headset Sys- tem for a long time: • Keep the ET-007 dr y . If it gets wet, wipe it dry immediately . • Use and store the ET-00 7 only in normal temperature environments. • Handle the ET-007 g ently and care- fully .
23 NOTES 43-007.fm Page 23 Wednesday, M arch 22, 2000 11:24 AM.
RadioShack A Division of T andy Corporation Fort W orth, T exas 76102 03A00 Printed in China Limited One-Y ear W arranty This product is warranted by RadioShack against manufactu ring defects in mater.
Ein wichtiger Punkt beim Kauf des Geräts Radio Shack ET-007 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Radio Shack ET-007 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Radio Shack ET-007 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Radio Shack ET-007 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Radio Shack ET-007 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Radio Shack ET-007 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Radio Shack ET-007 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Radio Shack ET-007. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Radio Shack ET-007 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
