Benutzeranleitung / Produktwartung PLD43MU des Produzenten PYLE Audio
Zur Seite of 35
OWNER's MANUAL Mobile V ideo System Detachable Panel Motorized Slide Down And 4.3 Inch Wide Color T ouch Screen Monitor CAR DVD/VCD/CD/MP3 Player AM/FM Digital PLL T uning Radio MPEG4 Player USB .
Contents 1 Preautions ..................................... Safety Information......................... Disc Notes .................................... Installation .................................... Electric Connection ...................... Remote Control .
2 Precautions THANK YOU FOR PURCHASING THIS CAR DVD PLA YER . Before operating the unit, read this manual thoroughly and keep it handy for future reference . T o avoid injury or accident , read the following precautions before installing and operating the unit .
3 Safety Information CAUTION: W ARNING: REGION MANAGEMENT INFORMA TION: THIS DVD PLA YER IS A CLASS I LASER PRODUCT . HOWEVER THIS DVD PLA YER USES A VISIBLE/INVISIBLE LASER BEAM WHICH COULD CAUSE . HAZARDOUS RADIA TION EXPOSURE IF DIRECTED. BE SURE TO OPERA TE THE DVD PLA YER CORRECTL Y AS INSTRUCTED.
Disc Notes Preparing New Discs with Spots Rough A new disc may have rough edges on i ts inside and outside edges.If a disc with rough edges is used, the proper setting will not be performed and the player will no t play the disc.Therefore, remove the rough edges in advance by using a ball point pen or pencil as shown on the right.
Choose the mounting location where the unit will not interfere with the normal driving function of the driver . Before finally installing the unit, connect the wiring temporarily and make sure all connected up properly and the unit and the system work properly .
Installation 6 If you want to take CHASSIS out of the SLIDE BRACKET HOUSING, first remove the PLASTIC COVER of the both sides away , then insert the two KEY PLA TE into left and right side of chassis as above illustration.
7 Installation FIG.4 FIG.3 PROTECTIVE CASE FRONT P ANEL FIG.2 FRONT P ANEL FIG.1 FRONT P ANEL RELEASE BUTTON How T o Remove And Install The Front Panel When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder .
Panel Angle Adjustment 8 Caution: Do not insert your finger behind the control panel. Angle 3 Angle 4 Angle 1 Angle 2 When you want to change the viewing angle of the operating unit to play , you can .
Electric Connection WIRING CONNECTION 9 Note: the earth connection cable (parking brake B-) must be connected in order for DVD pictures to be played back to the monitor . If the cable has not been correctly connected, the message “P ARKING BRAKE” appears on the monitor .
Remote Control 10 1. CLK 2. MODE 3. STOP 4. SETUP 5. MO/ST(AUDIO) 6. SUBTITLE LO/DX 7. REPEA T 8. GOTO 9. / 10. SEL 1 1. VOL+/VOL- 12. / / / 13.MENU SUB WOOFER 14.BAND(OSD) 15.POWER 16.PLA Y/P AUSE 17.MUTE 18.TITLE/PBC (A/P) 19. 20.ANGLE 21.EQ 22. / 23.
Remote Control 11 Using the Remote Control Face the remote control towards the player front face IR mark (remote control signal receiver), make sure there is no obstacle in between . Operation angle: About 30 degree in each the direction of the front of the IR mark.
1 9 3 13 16 10 2 17 6 7 4 11 5 12 14 8 15 18 TOUCH SCREEN REL RESET VOL- VOL+ AUX IN IR EQ SEL BND CAR DVD/VCD/CD/MP3 PLAYER WITH MPEG4 A P S D I S P I MU CH 1-6 MOD Control Panel T ouch Panel Key Functions 12 SWF LUD DSP CLK MOD VOLUME- SEL VOLUME+ T ouch Screen Key : 1.
13 Unit Keys : 2. (POWER On/Off )BUTTON Press this button to switch the device on. WELCOME appears in the display . Press it again to switch the device off. SEE YOU appears in the display . 1.REL BUTTON Press this button to release the front panel for removal .
14 7. APS, DISPLA Y FUNCTIONS (using the SELECT knob) In Radio mode, swing the SEL knob briefly in the APS/DISP direction , the radio briefly plays all the preset stations of the frequency band . In Radio mode, swing the SEL knob in direction of the APS/DISP for approximately 2 seconds to active automatic station storage.
15 12. MODE BUTTON Use this button to select an input mode by pressing repeatedly until the proper one is found: AUX IN > RADIO > DISC If you are in USB Playback mode and want to select DISC mode, press the STOP button and then the GO T O button.
16 Basic Operation Setting The Buzzer ON/OFF Buzzer T ouch the SEL section on the touch screen to select the BUZZER item, and then touch the VOL+/- (or rotate the vol+ /vol-) to switch the BUZZER ON/OFF . Press it button on front panel or on the remote to switch the device ON or OFF .
17 TFT Monitor Adjustment SEL During DISC playback, use your finger touch briefly the SEL section on the screen (or press SEL knob on the front panel mode ) to across the Picture selection menu, by repeatedly touch the SEL section, and then touch the VOL+/- (or rotate the VOL+/-) to adjust the selected mode .
Basic Operation Setting Audio Modes It`s depend on your habit to select the Audio mode . SWF LUD DSP CLK MOD VOLUME- SEL VOLUME+ ROCK touch to select POP FLA T ROCK CLASSIC JAZZ T ouch the screen the DSP range (or press the EQ button on the front panel ) to select one of the preset sound modes DSP (Rock/Pop/Jazz/Classic/Flat) .
Radio Operation 12 3 MOD 6 4 5 BND ST DX DISC-IN CH 6 SWF POP 11:08 AM FM1 98.10 MHZ Setting Memory Press the /CH 1-6 button repeatedly on the front panel to preset stations at radio mode .
Radio Operation Automatic Memory Storing & Program Scanning Loud Function T ouch the LUD section on the touch screen to switch the LOUND ON or OFF .
DISC Operation Stopping Play T ouch the screen the range (or press the button on remote control .) T o stop the unit playback. T ouch the section or press button on front panel to start play . NOTE : 1. In DVD mode, touch the section continually twice to back one track .
DVD 1 1-0:44:36 ENT Above these operation cursor buttons for DVD setup. T ouch it for previous . 1). Repeat Function Selecting The Play Modes FOR DVD : T ouch the screen “ RPT ” section (or press .
During DISC playback, T ouch the RDM section ( press the 4/RDM button longer on remote control to play in random. Each playing, the order is different . (depend on the disc used for VCD). 2). RDM(RANDOM) Function RDM NOTE : The 3/INT button is not available.
24 E. T ouch or Press for fifth time: The message on the screen will be cleared. OSD TITLE ELAPSED TT 01/01 CH 01/38 0:02:06 TITLE REMAIN TT 01/01 CH 01/38 3:24:36 CHAPTER ELAPSED TT 01/01 CH 01/38 0:02:56 CHAPTER REMAIN TT 01/01 CH 01/38 0:04:32 E.T ouch or Press for the fifth time: The message on the screen will be cleared for SVCD and VCD.
DVD/VCD Special Function MONO LEFT MONO RIGHT STEREO MIX-MONO For VCD/CD: AUDIO AUDIO during playback, touch the section of the touch screen or Press on the remote . It is possible to switch the sound between monaural and stereo sound. During DVD playback.
Setup 26 USING THE MENU TV Display Angle Mar k OSD Lang Spdif Output Captions Screen Saver Last Memor y DOLBY ....GENERAL SETUP P AGE.... Set TV Display Mode TV Display Nor mal/PS Nor mal/LB W ide Nor mal/LB GENERAL SETUP 1.TV DISPLA Y SETUP This is to select the appropriate TV aspect (4:3 or 16:9) according to the connected TV set.
27 Setup 5.CAPTIONS SETUP Activate the CAPTIONS feature by selecting ON. And release this feat- ure by selecting OFF . 2. ANGLE MARK DISPLA Y SETUP If it is set to ON, when the multi-angle DVD disc is playing, (the angle mark) will appears on the screen; if is set to OFF , the mark will not appear .
Setup 6.SCR SA VER SETUP Select the SCR SA VER output ON/OFF . 7.LAST MEMORY SETUP Select the LAST MEMORY output ON/OFF . SPEAKER SETUP This is to activate the audio output from DOLBY AC3 5.1 DOWNMIX to 2 channel mode. Select the preferred SPEAKER connection by using the cursor buttons.
Setup OSD Lang Prefer red Audio Language English F rench Ger man Spanish Italian Portuguese English TV Type Audio Subtitle Disc Menu Parental Pass word Default DOLBY ....Preference Page.... Audio --- PREFERENCES P AGE --- 1.TV TYPE SETUP This player can play discs recorded in either P AL or NTSC format.
Setup 5.P ARENT AL Select suitable parental guidance by the cursor buttons and conformed by pressing ENTER button. 6.P ASSWORD Select the change and press ENTER button. T ype the old password (The initial factory code is ) and key in 4 characters password now you want to use, and retype again to confirm key in correctly .
Other Main Operation Important Note: T o prevent damage to the USB device, do not remove or disconnect it during playback. it is also a good practice to remove the USB drive during disc playback.
Other Main Operation REP-ONE: Play the same song over and over again. 1.When inserting an MP3/WMA/JPEG/MPEG4 disc. Ex: When MP3 file is detected. 00:56 04:07 003/1 12 Repeat one Mp3 Mp3 Mp3 ....... ....... K P woman 1 new ton 1 2 3 4 56 .Current track(file)(highlighted bar) .
Supply V oltage: 12V DC (1 1V -15V) Current Consumption: Less than10 A Signal System: Compositive video 1.0Vp-p 75 Discs Played: (1) DVD-VIDEO Disc 5"(12 cm) single-sided, single-layer 5"(12.
Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer .
Ein wichtiger Punkt beim Kauf des Geräts PYLE Audio PLD43MU (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie PYLE Audio PLD43MU noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für PYLE Audio PLD43MU - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von PYLE Audio PLD43MU reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über PYLE Audio PLD43MU erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon PYLE Audio PLD43MU besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von PYLE Audio PLD43MU verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit PYLE Audio PLD43MU. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei PYLE Audio PLD43MU gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
