Benutzeranleitung / Produktwartung PAV80 des Produzenten PS Engineering
Zur Seite of 36
9800 Martel Road Lenoir City, TN 37772 P P A A V V 8 8 0 0 High-fidelity Audio-Video In-Flight Entertainment System With DVD/MP3/CD Player and Radio Receiver STC-PMA Document P/N 200-800-0101 Revision 5 February 2004 Installation and Operation Manual PS Engineering, Inc.
Table of Contents SECTION I GENERAL INFORMATION ........................................................................ 1-1 1.1 INTRODUCTIO N ........................................................................................................... 1-1 1.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page ii Rev. 5 Feb. 2004 3.5 D ISPLAY D IMMING (7) ..................................................................................................... 3-5 SECTION IV- WARRANT Y AND SERVICE .
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 1-1 Rev. 5 Feb. 2004 Section I GENERAL INFORMA TION 1.1 INTRODUCTION Quality cockpit and cabin entertainmen t has long been an elusive dream in general aviation.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 1-2 Rev. 5 Feb. 2004 Operation is subject to the following con ditions: This device may not cause harmful i nterference. This device must accept any interference received, in cluding interference that may cause undesired opera- tion.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 1-3 Rev. 5 Feb. 2004 PVT801 Video Terminal Unit FAA-TSO COMPLIANCE APPLICABLE DOCUMENTS: SAE AS8034 RTCA/D.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 1-4 Rev. 5 Feb. 2004 Model Part Number Description PAV80 050-800-0100 DVD-IFE System with AM/FM CD MP3 PVT801 050-801-0100 LCD Video Display, 5.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 1-5 Rev. 5 Feb. 2004 1.8 APPROVED AUDIO SYSTEMS This is a list of audio system that th e PAV80 should interface with adequately. Approved Audio Systems, PAV80 Certified interface is approved only for a udio systems that are FAA-TSO approved.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 2-1 Rev 2 Sept. 2003 Section II - Inst allation 2.1 GENERAL INFORMATION 2.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 2-2 Rev 2 Sept. 2003 2.00” 6.31” 2.3.3 Mounting Rack Installation Remove the unit from the m ounting tray by unscrewing the 3/32" hex-head screw that is near the l eft edge of the u nit.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 2-3 Rev 2 Sept. 2003 Pa n e l O p en in g Saw a nd file us ed to remo ve exis tin g instrument panel from this location Figure 2-3 Completed panel opening (Typi cal) Figure 2-4 Completed panel installa tion 2.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 2-4 Rev 2 Sept. 2003 B A C 120-425-4402 Connector 475-440-0007 (2 plcs) Screws F r o n t o f t r a y Rear of tray 475-632-0007 Screw (x2) Washer 475-632-0001 Nut 475-632-0005 430-730-0025 Tray Shield Figure 2-5 -Tray Assembly 2.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 2-5 Rev 2 Sept. 2003 2.4.2 Pow er The PAV80-Series units are compatible with both 14 and 28 Volt DC systems. A five (5) Am p PULL-TYPE breaker is required. Power and ground wires m ust be a t wisted #18 AWG pair.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 2-6 Rev 2 Sept. 2003 2.4.5 Aux Entertainment Audio and AUX Enable Besides the disc and AM/FM, the PAV8 0 has the ability to act as a switching control for an add itional en- tertainm ent input, both audi o and video.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 2-7 Rev 2 Sept. 2003 Figure 2-8 PVA802 Dist. Amp Circuit breaker location (Typical) Connect the PVA802 to a 5-amp PULL TYPE circui t br eaker. The unit connector is a cri mp type, however, we recomme nd soldering the small conductors from the RG179 coax.
PS Engineering PAV80 Series IFE System Installation and Operator’s Manual 200-800-0101 Page 2-8 Rev 2 Sept. 2003 b. Evaluate the audio perform ance c.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Page 3-1 Rev. 5 Feb. 2004 Section III OPERA TION GENERAL INFORMATION 3.1 SCOPE This section describes the operati on of the PAV80 In-Flight Entertai nment syst em. Operating controls consi st of two rotary knobs with push-push switches, and four but tons.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Page 3-2 Rev. 5 Feb. 2004 3.2.4 The ►► Button (4) In disc mode, a short press of this button will advan ce to the next track. A longer press will put the disc into fast forward mode.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Page 3-3 Rev. 5 Feb. 2004 Table 1-PAV80 Functions Action Disc Result Radio Result ▲ short press Stop ▲ long press Eject (also.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Page 3-4 Rev. 5 Feb. 2004 3.4 Remote Operation The remote suppli ed is used to control vari ous functions of the secondary audio out put.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Page 3-5 Rev. 5 Feb. 2004 3.5 Display Dimming The display can be adjusted for am bient light conditions by the connecti on to the aircraft dim mer bus. At mini mum bus voltage (or no lighti ng present) the display is set at m aximum .
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Page 4-1 Rev. 5 Feb. 2004 Section IV - W arranty and Service 4.1 Warranty In order for the factory warranty to be valid, the installations in a certif ied aircraft must be accomplished by an FAA-certified avionics shop and authorized PS Engineeri ng dealer.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix A Rev. 5 Feb. 2004 Appendix A – MP3 Creation 5.1 Creating M P3s from an Audio CD 1. Start MusicMatch JukeBox.( www.musicmatch.com ) Press the reco rder button, which is the small red dot located in the top right corner.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix B Rev. 5 Feb. 2004 Appendix B – Installation Drawings PAV80 Unit AUTOPILOT XPNDR AUDIO PANEL NAV/COM PIPER PN 101271-013 COPILOT'S PANEL ASSY.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix B Rev. 5 Feb. 2004 Intercom Jacks (existing) Video Jack (new) Typical, 1 each side 13 12 1110 9 4321 Located PVA802 1 GLP 7-11-03 12345 14 15 16 17 18 6789 19 20 21 22 10 23 24 11 12 25 13 Video Monitor Cable Video Monitor Cable PVA802 Distrib.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix B Rev. 5 Feb. 2004 Washer 475-632-0001 & Nut 475-632-0005 475-632-0007 (2 plcs) Screws Tray Shield 07 09 03 GLP 3 Add t b k h ll hi l Detail A A Rear of tray Front of tray 0.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix B Rev. 5 Feb. 2004 PVT801 Display Interface View from solder cup 1= Video Ground 2= Display Power 3= Power Ground 4= Video Signal 5= No Connection 1 2 3 45 Figure 6-4 Display connector layout 1.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix B Rev. 5 Feb. 2004 VIEWED FROM REAR Cable Exit 4.5 in 5.13 in Ø0.185 in (4 plcs) 6.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix B Rev. 5 Feb. 2004 RSH 07-09-03 NEW RELEASE CAGE CODE NONE IFE Breaker Location 0 A CHECKED BY: APPROVAL: SCALE ACTIVITY.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix B Rev. 5 Feb. 2004 Ø0.136 (4 plcs) 1.250 3.500 4.000 5.470 4.725 Figure 6-9 PVA802 Video Distribution Ampli fier Installation (Dwg.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix C Rev. 5 Feb. 2004 Appendix C Connector Interconnect 7.1 Single Display System Entertainment Output connected to audio p.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix C Rev. 5 Feb. 2004 Multiple Display System Wiring E n t e r t a i n m e n t O u t p u t c o n n e c t e d t o a u d i o .
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix D Rev. 5, Feb. 2004 Appendix D- STC information and instructi ons for continuing airworthiness 8.1 Instructions for FAA Form 337, PAV80s The STC was developed using an Approve d Model List (AML).
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix D Rev. 5, Feb. 2004 8.3 M aster Drawing List The following drawings are contained on the FAA-A pproved Master Drawing List, Document Number 002-800-1000: Title In this manual Part Number Revision Date Installation Manual X 002-800-0101 2 Sept.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix D Rev. 5, Feb. 2004.
PS Engineering PAV80 Installation and Operator’s Manual 200-800-0101 Appendix E Rev. 5 Feb. 2004 Appendix E RTCA DO160D/EUROCAE ED-14D Enviro nmental Qualification Form Part Number: 050-800-(-xxx) M.
Ein wichtiger Punkt beim Kauf des Geräts PS Engineering PAV80 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie PS Engineering PAV80 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für PS Engineering PAV80 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von PS Engineering PAV80 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über PS Engineering PAV80 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon PS Engineering PAV80 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von PS Engineering PAV80 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit PS Engineering PAV80. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei PS Engineering PAV80 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
