Benutzeranleitung / Produktwartung Aux2Car des Produzenten Peripheral Electronics
Zur Seite of 24
Aux2Car Interface Instruction Manual Peripheral Electronics®, a division of AAMP of America™ 13160 56th Court Clearwater , Florida 33760 727-572-9255 or interface@peripheral-aamp.
T able of Contents CHAPTER 1 Pages Installation Preparation (All V ehicles) 1-2 CHAPTER 2 Dip-Switch Ov er view (REQUIRED) 3 Acura 4 Audi 5 F or d (F or d, Lincoln, Mercur y) 6-7 GM (Buick, Cadillac, .
VEHICLE INST ALLA TION Intr o Thank you for purchasing the Aux2Car interface. This interface will allow you to connect a line level audio input to you vehicle’s factory radio without the use of a noisy RF modulator .
2.
CHAPTER 2 V ehic le Installation In this chapter you will learn how to install the Aux2Car adaptor in specifi c vehicles. Aux2Car adaptor in specifi c vehicles. Aux2Car The Aux2Car adaptor connects to your car radio using a vehicle specifi c cable harness.
VEHICLE INST ALLA TION Acura Before connecting any cables to the Aux2Car you must set the dip switches to the Aux2Car you must set the dip switches to the Aux2Car correct position. If you set the dip-switches after you have connected cables to the interface, you must disconnect and reconnect them for the Aux2Car to operate.
VEHICLE INST ALLA TION OPERA TION Once you connect the Aux2Car adaptor, turn on your radio. A CD icon will appear on the Aux2Car adaptor, turn on your radio. A CD icon will appear on the Aux2Car display of your radio showing that the Aux2Car adaptor is ready to use.
F or d (F or d, Lincoln, Mercur y) Before connecting any cables to the Aux2Car you must set the dip switches to the Aux2Car you must set the dip switches to the Aux2Car correct position. If you set the dip-switches after you have connected cables to the interface, you must disconnect and reconnect them for the Aux2Car to operate.
Model Y ear(s) IPOD Location and Notes Ford Crown Victoria 1995-1997 PXHFD2 connector behind Radio. Premium Audio System Crown Victoria 1995-1997 PXHFD1 (Rear Control Unit) in the trunk. JBL / Luxury System Crown Victoria 1998-2003 PXHFD3 connector behind Radio.
GM (Buick, Cadillac, Che vy , GMC , P ontiac, Satur n) *PLEASE READ* *1995-1999 Radios with built in CD player (Except Corvette) are NOT compatible with the Aux2Car ADAPTER. Aux2Car ADAPTER. Aux2Car *2000-2004 Radios with built in CD player ARE compatible.
Model Y ear(s) IPOD Location and Notes Buick Notes for Buick:Requires GM factory CD data cable part # 12344003 if not pre-wired in trunk. Century 1997-2003 PXHGM2 Cable in trunk.Protocol: E&C Le Sabre 2000- 2002 PXHGM2 Cable in trunk.Protocol: Class 2 Le Sabre 1995-1999 PXHGM2 Cable in trunk.
Model Y ear(s) IPOD Location and Notes Oldsmobile Requires GM factory data cable Part # 12344003 if not pre- wired in trunk. Achieva 1996-1998 PXHGM3 Cable in trunk.Protocol: E&C Alero 1999-2000 PXHGM2 Cable in trunk.Protocol: E&C Alero 2003-2004 PXHGM3 Cable behind HeadunitPro- tocol: XM Aurora 1995-1999 PXHGM2 Cable in trunk.
Chr ysler (Chr ysler , Jeep , Dodge, Plym- outh, Eag le) Make sure the Aux2Car adaptor is compatible with your vehicle, Check for “Disc ^” printed on Aux2Car adaptor is compatible with your vehicle, Check for “Disc ^” printed on Aux2Car preset button “1”.
VEHICLE INST ALLA TION Honda – All Honda e xcept P asspor t Before connecting any cables to the Aux2Car you must set the dip switches to the Aux2Car you must set the dip switches to the Aux2Car correct position.
VEHICLE INST ALLA TION T o yota / Scion / Isuzu / Honda-P asspor t Before connecting any cables to the Aux2Car you must set the dip switches to the Aux2Car you must set the dip switches to the Aux2Car correct position.
TROUBLE SHOO TING V olksw agen Make sure you have your radio’s theft protection code before you attempt installation. When you reconnect power to the battery , you will need to enter this code. Information about the theft protection code can be found in your vehicle’s audio operation manual.
TROUBLE SHOO TING CHAPTER 3 Symptom Cause Remedy No Power Blown fuse Replace fuse with same amp. Rating. If the fuse blows again, call tech support. No Power Bad connection Check cable connection. Alternator noise is heard (Changes with gas) Wrong wiring creates ground loop.
War ranty and War ning One Y ear Limited Warranty The quality controls used in the manufacture of this product will ensure your satisfaction. This warranty applies only to the original purchaser of this product from an authorized dealer .
Caution 1. Use of headphones while operating an automobile or moving vehicle is not recommend- ed and is unlawful in some countries and areas. 2. Be careful and attentive on the road. Stop operation of the Aux2Car adaptor if you fi nd it Aux2Car adaptor if you fi nd it Aux2Car disruptive or distracting while driving.
FORD Appendix Aux2 Car Adaptor Connection Car Adaptor Connection Car 2004 - T own Car , Grand Marquis, Marauder , LS and Ford Crown Vic. 1. Preparing the Ford-12pin Cable T ake the PXHFD4 cable and cut off the black 12-pin plug. Y ou will use only the cable and big White 22 pin connector (connects to the iPod2car).
GM Appendix 1 Corvette Aux2car Adaptor Connection to Chevrolet Corvette Most Corvettes are pre-wired to the trunk. In case you can’t fi nd the connector in the trunk, please do the following: 1. Preparing the GM-A Cable T ake the PXHGM1 cable and cut off the Black and Red plug.
GM Appendix 2 Cadillac; Oldsmobile; Buick that use E&C protocol (1995 – 1999 ) - Cable in trunk can’t be found Most 1995 – 1999 Cadillac’ s, Oldsmobile’ s & Buick’s are pre-wired to the trunk. In case you can’t fi nd the connector in the trunk, please do the following: 1.
21.
Peripheral Electronics®, a division of AAMP of America™ 13160 56th Court Clearwater , Florida 33760 727-572-9255 or interface@peripheral-aamp.com ©2005 AAMP™ of Florida, Inc.
Ein wichtiger Punkt beim Kauf des Geräts Peripheral Electronics Aux2Car (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Peripheral Electronics Aux2Car noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Peripheral Electronics Aux2Car - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Peripheral Electronics Aux2Car reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Peripheral Electronics Aux2Car erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Peripheral Electronics Aux2Car besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Peripheral Electronics Aux2Car verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Peripheral Electronics Aux2Car. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Peripheral Electronics Aux2Car gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
