Benutzeranleitung / Produktwartung BB5L des Produzenten Pelco
Zur Seite of 20
Pelco • 300 W. Pontiac Way, Clovis • CA 93612-5699 USA • Pelco Online @ http://www.pelco.com In North America and Canada: Tel (800) 289-9100 or FAX (800) 289-9150 • DataFAX (800) 289-9108 Inte.
2 Pelco Manual C1488M-A (9/98) REVISION HISTOR Y Manual # Date Comments C1488M 6/98 Original version. C1488M-A 9/98 Rev A. Re vised the manual to incorporate Spectra™ Lite material. CONTENTS Section Page 1.0 GENERAL .................................
Pelco Manual C1488M-A (9/98) 3 1.0 GENERAL 1.1 IMPORT ANT SAFEGUARDS AND W ARNINGS Prior to installation and use of this product, the following W ARNINGS should be obser v ed. 1. Installation and servicing should only be done by qualified ser vice personnel and conform to all local codes.
4 Pelco Manual C1488M-A (9/98) 1.2 REGULA TOR Y NOTICES NOTE: This equipment has been tested and found to comply with the limits of a Class B digital de vice, pursuant to par t 15 of the FCC rules. These limits are de- signed to provide reasonab le protection against harmful interference in a residen- tial installation.
Pelco Manual C1488M-A (9/98) 5 Figure 1. Back Bo x P arts COMPASS TOOL SAFETY BRACKET CONDUIT FITTING & LOCK NUT T -RAIL CLIP 1.3 UNP ACKING INSTRUCTIONS Unpack and inspect all parts carefully . Be sure to sav e the shipping box and an y inser ts.
6 Pelco Manual C1488M-A (9/98) 2.0 DESCRIPTION The BB5A Series back bo xes are used with the SD5 Series of Spectra™ (Softw are V ersion 3.0) domes and SD5A Series of Spectra II™ domes. The BB5L Series back bo xes are used with the SD5L Series of Spectra™ Lite domes.
Pelco Manual C1488M-A (9/98) 7 3.0 INST ALLA TION FOR IN-CEILING MODELS This manual cov ers the installation of the BB5A-F , BB5A-PB , BB5A-PG, BB5A-PG-E, BB5L-F , BB5L-PG, and BB5L-PG-E back bo x es only . For complete installation and operating instructions f or the SD5 Series of Spectra™ (Software V ersion 3.
8 Pelco Manual C1488M-A (9/98) 3.1.2 Suspended Ceiling 1. Remov e the ceiling tile from the ceiling. 2. Locate the center point to drill a hole in the tile. 3. Drill a hole in the ceiling tile using a 3/32-inch drill bit. 4. Remov e the compass tool from the par ts bag (refer to Figure 2).
Pelco Manual C1488M-A (9/98) 9 Figure 4. Installing Back Bo x Figure 5. F astening Bac k Bo x HARD CEILING OR CEILING TILE T -RAIL CLIP FOR CEILING TILE HARD CEILING OR CEILING TILE T -RAIL CLIP FOR C.
10 Pelco Manual C1488M-A (9/98) Figure 6. Wiring Diagram f or Spectra™ (V er . 3.0) and Spectra II™ CONTROL (RS-422) 7 +5 to +24 VDC EXTERNAL RELA Y (WIRING EXAMPLE) CONTROL (RS-422) Figure 7.
Pelco Manual C1488M-A (9/98) 11 T able B. 24 V AC Wir ing Distances The follo wing are the recommended maximum distances f or 24 V AC with a 10- percent voltage drop . (T en percent is generally the maximum allo wable voltage drop for A C-po wered devices .
12 Pelco Manual C1488M-A (9/98) 3.3 BACK BOX INST ALLA TION 1. Suspended Ceiling Only (f or hard ceiling, go to step 2) – Install the ceiling tile with the bac k box. Attach a T -rail clip on each side of the ceiling tile as shown in Figure 5. The clips for the ceiling tile are supplied with the bac k bo x.
Pelco Manual C1488M-A (9/98) 13 3.4 BACK BOX CONNECTIONS Depending on the type of dome, ref er to either Figure 10 or 11 to attach the wiring to the interconnect circuit board inside the back bo x. Also refer to Figure 6 or 7 if necessary . 1. Earth Ground - Connect ear th ground to the middle connector on the po wer connector .
14 Pelco Manual C1488M-A (9/98) From contr oller T o 4-Wire terminal on circuit board RX- TX- RX+ TX+ TX- RX- TX+ RX+ NOTE: Connect only a low v olt- age de vice to the rela y output. Maximum current r ating of the re- la y contacts is two amperes. CAUTION: The maxi- mum output of A UX 2 is 150 mA.
Pelco Manual C1488M-A (9/98) 15 NOTE: If outdoors, apply Duct Seal inside the pipe por tion of the back bo x to pre vent moisture or cold air inside the mount from en- ter ing the unit and causing conden- sation on the dome. Duct Seal can be purchased through local elec- tr ical supply houses.
16 Pelco Manual C1488M-A (9/98) 5.0 TROUBLESHOOTING Symptom: LED does not light. If the red pow er LED on the door of the interconnect circuit board in the back bo x does not light: 1. T urn off power . 2. Open the door to the interconnect circuit board and check the fuse .
Pelco Manual C1488M-A (9/98) 17 6.0 SPECIFICA TIONS MECHANICAL Construction Back box: Aluminum Cable Entry In-Ceiling: .75" (1.91 cm) conduit fitting Pendant: Through 1.
18 Pelco Manual C1488M-A (9/98) Figure 12. SD5 Series Dimension Drawing 6.60 (16.76) 5.25 (13.34) 3.25 (8.26) 7.25 (18.13) 8.25 (20.96) 5.90 (14.99) In-Ceiling Dome Pendant Dome NO TE: V ALUES IN P ARENTHESES ARE CENTIMETERS , ALL OTHERS ARE INCHES . 5.
Pelco Manual C1488M-A (9/98) 19 NOTES.
20 Pelco Manual C1488M-A (9/98) 7.0 W ARRANTY AND RETURN INFORMA TION WARRANTY P elco will repair or replace, without charge , any merchandise prov ed def ective in material or workmanship for a period of one year after the date of shipment.
Ein wichtiger Punkt beim Kauf des Geräts Pelco BB5L (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Pelco BB5L noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Pelco BB5L - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Pelco BB5L reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Pelco BB5L erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Pelco BB5L besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Pelco BB5L verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Pelco BB5L. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Pelco BB5L gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.