Benutzeranleitung / Produktwartung 120-2155 des Produzenten Optimus
Zur Seite of 27
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Features Faxback Doc. # 48528 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
Programming stations in each band (AM and FM) into a separate travel memory so you can quickly find local stations while traveling. Seek Tuning - searching forward or backward to the next strong station in the selected band. This makes finding a station quick and easy.
The CD player in this stereo system is made and tested to meet exacting safety standards. It meets FCC requirements and complies with safety performance standards of the U.S. Department of Health and Human Service. WARNINGS: This system employs a laser light beam.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Installation Faxback Doc. # 48529 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
it is mounted. Be sure to avoid obstructions behind the mounting surface. Routing Speaker Wires If you install speakers, avoid routing the speaker wires near moving parts or sharp edges. You can usually route them along the wiring channel beneath the vehicle's door facings by carefully removing the molding that holds the carpet in place.
4 Ohms. Your local RadioShack store carries a full line of speakers. You must connect the GROUND, +12V TO IGNITION, and +12V TO BATTERY wires first, then make all other connections as described in the following sections before you plug the harness with the 14-pin connector into the stereo.
(Black) - Ground (Red) - + 12V to Ignition (Yellow) - + 12V to Battery (Blue/White) - AMP Remote Turn on 500 mA MAX 1. Disconnect the cable from your vehicle's negative (-) battery terminal. 2. Connect the black ground wire to a chassis ground, such as a metal screw attached to a metal part of the vehicle's frame.
Connecting Two Pairs of Speakers If you are using both front and rear speakers, follow these steps to connect the harness with the 14-pin connector to the speakers. 12-2154 Only: Before connecting the speakers, remove the tape that holds the mounting sleeve in place and slide the sleeve off of the stereo.
(White) - Left Speaker (+) (White/Black) - Left Speaker (-) (Gray) - Right Speaker (+) (Gray/Black) - Right Speaker (-) (Green) - | (Green/Black) - |___ Do Not Connect (Violet) - |// (Violet/Black) - .
Make sure you have securely made all other connections, then plug the harness' connector into the stereo's 14-pin wiring socket. Reconnect the cable to the vehicle's negative (-) battery terminal.
7. Reconnect the wire harness and the antenna. 8. Slide the stereo into the sleeve until it locks into place. 9. If you are securing the stereo in an existing mounting hole in the dash, push the supplied rubber mounting grommet onto the mounting bolt.
Note: The keys are labeled to show their top edges. 5. Remove the keys from the slots. 6. Disconnect the wire harness and the antenna. 7. If you are mailing or shipping the stereo, use a Phillips screwdriver to reinstall the shipping screw in the top of the stereo.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Control Panel Faxback Doc. # 48530 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Operation Faxback Doc. # 48531 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
number appear. WARNING: To protect your hearing, do not listen at high volume levels. Slowly increase the volume to a comfortable listening level. AUDIO CONTROL SEL - Repeatedly press until bAS, TRE, .
1. Repeatedly press FSM until FSM I or FSM II appears. 2. Adjust the volume, bass, treble, balance and fader using the information in "Adjusting the Sound" above. Note: FSM I or FSM II blinks while you adjust the controls. 3. When you finish adjusting the stereo's settings, hold down FSM until the stereo beeps twice.
Seek Tuning: Hold down TUNE/SEEK TRACK - or + for about 1 second to tune to the next lower or higher station. 4. Press AUDIO CONTROL SEL + or - to increase or decrease the volume as desired.
memory. Note: If the stereo could not find any stations, P - 1 - - - appears on the display. Press BND or select another station to listen to the radio.
As the radio scans each memory channel, P- and the channel number flash and the frequency is displayed. After scanning all memory channels, the stereo returns to the original station. To stop scanning when the radio pauses at a station you want to listen to, press BND again during the pause.
resume play, press CD again. Note: If you pause a CD for more then 5 minutes, the stereo turns off. 5. To remove a CD from the CD player, press (symbol). EJ cd appears. Notes: If you eject a CD while it is playing and do not remove it from the CD player, the stereo automatically draws the CD back in and starts playing again after about 5 seconds.
To repeat a track, press RPT/2 during play. RPT appears during repeat play. When the track ends, it automatically repeats. To stop repeating the track and resume normal play, press RPT/2.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Troubleshooting Faxback Doc. # 48532 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Care and Maintenance Faxback Doc. # 48533 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
CD CARE TIPS Even though a CD is very durable, you should handle it with care. We recommend the following precautions. Keep the CD in its protective case or sleeve when you are not playing it. Handle a CD by its edges to avoid fingerprints which can prevent the CD player's laser beam from accurately reading the CD.
3. If the fuse is brown, replace it. Use only the supplied 1-1/4 inch fuse or a replacement fuse with the proper rating (such as Cat. No. 270-1005). The fuse must be 1 amp. 4. Reassemble the fuse holder by inserting the fuse into the longer of the fuse holder's ends, and pushing together and twisting the two parts until they latch together.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Specifications Faxback Doc. # 48534 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
Sampling Frequency: .............................................. 8 times Pick-Up System: ......................................... Optional Pick-Up Optical Source: .................................................... Laser Wavelength: ..............
Ein wichtiger Punkt beim Kauf des Geräts Optimus 120-2155 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Optimus 120-2155 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Optimus 120-2155 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Optimus 120-2155 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Optimus 120-2155 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Optimus 120-2155 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Optimus 120-2155 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Optimus 120-2155. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Optimus 120-2155 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
