Benutzeranleitung / Produktwartung COMMAND20=25HP des Produzenten Kohler
Zur Seite of 20
0 WNER 's MANUAL COMMAND 20=25 HP HOREONUL CRANKSHAFT LP Gas Fueled or Dual-Fueled (LP Gas - Gasoline) -- RUN'".
Safety Precautions To insure safe operations please read the following statements and understand their meaning. Also refer to your equipment owner's manual for other important safety information. This manual contains safety precautions which are explained below.
Safefy Precautions (Conf.) GasoEne is extremely flammable and its vapors can explode if ignited. Store gasoline only in approved containers, in well ventilated, unoccupied buildings, a way from sparks or flames.
Air Cleaner Dipstick , ! tric / si :igure I, Typical Command Horizontal Shaft LP Gas Fueled Engine, Oil Recommendations Using the proper type and weight of oil in the crankcase is extremely important. So is checking oil daily and changing oil regularly.
LPG Engines LPG Fuel Recommendations Liquefied Petroleum Gas (LPG) from an appropriate LP fuel tank (supplied separately) is required to operate this engine. a WARNING: Pressurized LPG! Fuel tanks are filled under pressure and should be handled with care.
Engine Identification Numbers When ordering parts, or in any communication involving an engine, always give the Model, Specification, and Serial Numbers of the engine. CARB The engine identification numbers appear on a decal affixed to the engine shrouding.
Starting 1. Place the throttle control in the idle position. Place the choke control into the “on”position. See Figure 5. On dual-fueled engines, place the three- position fuel control switch in t.
Battery A 12 volt battery is normally used. Refer to the operating instructions of the equipment this engine powers for specific battery requirements. If the battery charge is not sufficient to crank the engine, recharge the battery (see page 12). Operating Angle of Operation This engine will operate continuously at angles up to 25".
Maintenance Schedule These required maintenance procedures should be performed at the frequency stated in the table. They should also be included as part of any seasonal tune-up. Every 100 Hours I Frequency I Maintenance Required Change Oil. Remove cooling shrouds and clean cooling areas’.
Oil SentryTM Some engines are equipped with an optional Oil Sentry’” oil pressure switch. If the oil pressure decreases below an acceptable level, the Oil Sentry’” will either shut off the engine or activate a warning signal, depending on the application.
8. Test run the engine to check for leaks. Stop the engine, allow a minute for the oil to drain down, and recheck the level on the dipstick. Add more oil as necessary so the oil level is up to but not over the "F" mark on the dipstick.
7. When element replacement is necessary order genuine Kohler parts. I CH20-22 I CH25 I I 47083034 I 2408303-S I Clean Air Intake/Cooling Areas To ensure proper cooling, make sure the flywheel screen, cooling fins, and other external surfaces of the engine are kept clean at all times.
Fuel Filter The filter of the LP fuel system is an integral part within the lock-off/filter assembly. All service relating to the lock-off/filter is to be performed by an authorized Kohler Engine Service Dealer or qualified LP personnel only. Servicing of filter is recommended every 500 hours.
4. Reinstall plug using Teflon@ pipe sealant (not Teflon@ tape) on threads and tighten securely. If required, a replacement plug is available as Kohler Part No. X-75-23-S. All Regulators Every 1500 Hours: Complete cleaning (disassembling, servicing, and resetting) of regulator at 1500 hour intervals is recommended.
Storage When the engine is not in use, use the following storage procedure. Federal, state, or local laws governing LPG fuel tank storage may also apply. Follow the applicable storage laws. 1. Clean the exterior surfaces of the engine. 2. Change the oil and filter while the engine is still warm from operation.
LIMITED 2 YEAR COMMAND ENGINE WARRANTY We warrant to the original consumer that each new Command engine sold by us will be free from manufacturing defects in materials or workmanship in normal service for a period of two (2) years from date of purchase, provided it is operated and maintained in accordance with Kohler Co.
(c) For warranty repairs, the engine must be presented to a Kohler Co. service center as soon as a problem exists. Call 1-800-544-2444 or access our website at www.kohlerengines.com, for the names of the nearest setvice centers. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.
.
.
FOR SALES AND SERVICE INFORMATION IN US. AND CANADA, CALL 1-800-544-2444 60- 110 RUN'" ENGINE DIVISION, KOHLER CO., KOHLER, WISCONSIN 53044 I FORM NO.
Ein wichtiger Punkt beim Kauf des Geräts Kohler COMMAND20=25HP (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Kohler COMMAND20=25HP noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Kohler COMMAND20=25HP - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Kohler COMMAND20=25HP reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Kohler COMMAND20=25HP erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Kohler COMMAND20=25HP besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Kohler COMMAND20=25HP verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Kohler COMMAND20=25HP. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Kohler COMMAND20=25HP gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
