Benutzeranleitung / Produktwartung 119.1643301 des Produzenten Kenmore
Zur Seite of 31
Use & Care Guide ® Liquid Propane Gas Grill Sears Model No: 119.16433010 Safety Parts Use and Care Assembly Espa_ol, Pg. 30 This Grill is for Outdoor Use Only • Read and follow all Safety, Assembly, and Use & Care Instructions in this Guide before assembling and cooking with this grill.
Primary Safety Warnings. .................................. 1-3 Warranty Information ............................................ 2 Pre-Assembly instructions .................................... 3 Part Diagram and Lists ...............................
DO NOT light this grill without first reading the Lighting Instructions. DO NOT light this grill without checking the burner tubes for blockage that could have occurred during shipment.
A Phillips Head Bolt M6×35mm Qty: 4 pcs F Phillips Head Screwdriver Qty: 1 pc lm B Phillips Head Bolt M6x16mm Qty: 24 pcs Battery Size AA Qty: 1 pc G C Phillips Head Bolt M6xl0mm Qty: 4 pcs Cabinet D.
Key Qty Part No. Description A1 1 *ASMA0085-01 Hood Assembly A2 2 *ASMA0014-03 Hood Bolt Assembly A3 1 CA0046-001 Hood Handle Seat Assebmly A4 2 FLPP0114 Hood Handle Heat Insulator A5 1 SE0213 Thermom.
Key Qty Part No. C2 1 $7004-042D-001 C3 1 $7001-042D-017 C4 1 *ASMD0085-01 C5 1 *ASMD0085-02 C6 1 PLABS0090-001 C7 1 PLABS0103-001 C8 1 S7005-F00B-026 C9 1 *ASMC0012-08 C10 1 SE0084-012 Cll 1 *ASMD008.
_----(.
Remove Firebox from Cabinet [] Cut fastening straps on Cabinet Toe Plate. Remove the Toe Plate and set aside. Cut fastening straps securing regulator and hose to cabinet. [] Unscrew and discard the 8 Phillips Head Bolts (M6x35mm) and 8 Washers (M6) from the corner holes of the cabinet.
Install Cabinet Toe Plate [] Attach the Cabinet Toe Plate to the Cabinet Bottom Panel using 4 Phillips Head Bolts (M6xl0mm), [] Place cabinet in upright position on casters, Phillips Head Bolt M6xl0mm.
Hang Condiment Basket and attach Cabinet Door Stop [] Attach the Cabinet Door Stop to the front of cabinet bottom using 2 Phillips Head Bolts (M4x8mm), [] Hang Condiment Basket on the inside of Cabinet Right Door, Phillips Head Bolt M4x8mm Qty: 2 Cabinet Door Stop Qty: 1 /.
Install Grease Tray [] Insert the Grease Tray along two sides of the Firebox from the back underneath the firebox. Insert tray with the grease drain hole positioned as shown. Be careful when sliding the tray past wires and fuel line. Slide tray fully in until it locks into place behind stops.
Install Side Shelf Upper and Lower Front Panels [] Attach the Side Shelf Upper Front Panel to Side Shelf Frame using 3 Phillips Head Bolts (M4xSmm), [] Attach the Side Shelf Lower Front Panel to Side .
Znstall Side Burner Upper and Lower Control Panels [] Attach the Side Burner Upper Control Panel to Side Burner Frame using 3 Phillips Head Bolts (M4xSmm), [] Attach the Side Burner Lower Control Pane.
Install Side Shelf Frame to Firebox [] Unscrew the 2 Phillips Head bolts ¼ inch from the upper left and right corner holes in the right side of the firebox as shown in Inset 1. The bolts extending out of the firebox sides are to attach the side shelf frame.
Install Side Burner Frame to Firebox [] Unscrew the 2 Phillips Head bolts 1/4 inch from the upper left and right corner holes in the left side of the firebox as shown in Inset 1. The bolts extending out of the firebox sides are to attach the side Burner frame.
Install Side Burner Valve [] Detach side burner ignition wire from the regulator hose. Feed side burner valve and igniter wire through hole in left side of cabinet. [] Open side burner lid and cut tie wrap securing grate to pan. On underside of pan, remove the 2 screws holding the side burner in place.
Install Heat Diffusers, Cooking Grates, Warming Rack [] Insert the heat diffusers into the firebox by placing them into the indentations in the front and back of the firebox. See Inset 1. [] Place the Cooking Grates into the firebox. The grate bottoms have a small knob on each corner.
Install Battery [] Unscrew the electronic ignition button. Place the AA Battery into the ignition with the positive (+) end facing out. Screw the electronic ignition button back into place. Battery Size AA Qty: 1 Congratulations - Assembly is now complete! [] Remove any additional labels or packing material from the grill except the CSA label.
CORRECT LP GAS TANK USE • LP gas grill models are designed for use with a standard 20lb. (9.1kg) Liquid Propane Gas (LP Gas) tank, which is not included with the grill.
Notes about LP Gas Tank Exchange Programs Many retailers that sell grills offer you the option of replacing your empty LP gas tank through an exchange service. Use only those reputable exchange companies that inspect, precision fill, test and certify their tanks.
Flow Limiting Valves on LP Gas Tanks Check all connections for LP Gas Leaks Your LP gas tank is equipped with a flow limiting valve that will restrict the flow of gas due to a sudden change in pressure.
Grill Lighting Instructions 1. Before each use, check all hoses for cracks, nicks, cuts, or abrasions. If a hose is damaged in any way, do not use your grill before replacing the hose with an authorized part from the Parts List. Also make sure all gas supply connections are securely tightened.
MANUALLY LIGHTING THE BURNERS WITH THE MATCH HOLDER MANUALLY LIGHTING THE SIDE BURNER OR THE ROTISSERIE BURNER 1. Open the lid 1. Open the grill lid or side burner cover. 2. Ensure all burners are in the "OFF" position. 3. Slowly turn on the gas at the LP cylinder valve if it is not already on.
Troubleshooting If the grill fails to light: 1. Turn gas off at source and turn control knobs to "OFF". Wait at least 5 minutes for gas to clear, and then retry 2.
Proper care and maintenance will keep your grill in good operating condition and prolong its life. Follow these cleaning procedures on a timely basis and your grill will stay clean and operate with minimum effort. CAUTION: Be sure your grill is off and cool before cleaning, and always wear protective gloves when cleaning your grill.
Toreduce the chance of FLASHBACK FTRE you must clean the burner tubes as follows periodically in summer and fall, wherever spiders are active in your area, and if your grill has not been used for an extended period of time. 1. Turn all burner control knobs to the "OFF" position.
Burn-Off Some of the new parts of your grill could have residual oils. We recommend you ignite the burners, turn to "Hi", and lower the lid for 3 to 5 minutes to burn any oils off before grilling for the first time.
Question: Can I convert my gas grill from one fuel type to another, such as LP to NG (natural gas) or vice versa? Answer: No, your gas grill is manufactured to specific standards developed by CSA and ANSI for your safety and is certified for one type of gas only.
Question: Where do I use my grill for safer operation and better performance? Answer: Strong winds and low temperatures can affect the heating and performance of your gas grill so factor in these elements when positioning your grill outdoors for cooking.
Congratulations on making a smartpurchase. Your new Kenmore <R_ product is designed and manufactured for years of dependable operation. But likeall products, it may require repair fromtime to time. That's when having a Repair Protection Agreement can save you money andaggravation.
Your Home For exped troubleshooting and home solutions advice: ++++++++++++++++++++ a n a 9 ÷ www,managemyhome,com For repair- in your home- of al! major brand appliances, lawn and garden equipment, .
Ein wichtiger Punkt beim Kauf des Geräts Kenmore 119.1643301 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Kenmore 119.1643301 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Kenmore 119.1643301 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Kenmore 119.1643301 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Kenmore 119.1643301 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Kenmore 119.1643301 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Kenmore 119.1643301 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Kenmore 119.1643301. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Kenmore 119.1643301 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
