Benutzeranleitung / Produktwartung GR-SXM367 des Produzenten JVC
Zur Seite of 32
1 INSTR UCTIONS ENGLISH L YT1100-001B AUTOMA TIC DEMONSTRA TION Automatic Demonstration takes place when “DEMO MODE” is set to “ON” (factory-preset). • Available when the Power Switch @ is set to “ ” or “ ” while pressing down the Lock Button ! located on the switch.
2 PROVIDED ACCESSORIES • A C Adapter • Battery Pac k BN-V11U • Lens Cap • Cassette Adapter C-P7U • AA (R6) Battery (for Cassette Adapter) NO TE: In order to maintain optimum performance of the camcorder , provided cables may be equipped with one or more core filter .
3 PRECAUTIONS SAFETY PRECAUTIONS NOTES: ● The rating plate (serial number plate) and safety caution are on the bottom and/or the back of the main unit. ● The rating information and safety caution of the AC Adapter are on its upper and lower sides.
4 When the equipment is installed in a cabinet or on a shelf, make sure that it has sufficient space on all sides to allow for ventilation (10 cm (3-15/16") or more on both sides, on top and at the rear). Do not block the ventilation holes. (If the ventilation holes are blocked by a newspaper , or cloth etc.
5 INDEX A AC Adapter ................................................................. pg. 6 Animation Recording .......................................... pg. 21, 26 Audio Dubbing ......................................................... pg. 27 Auto Date Record .
6 Viewfinder on 80 85 90 (45) (45) (50) 80 85 90 (45) (45) (50) 135 140 145 (75) (80) (80) 315 330 350 (165) (195) (205) GETTING ST ARTED Hook on. Push in.
7 Y M D T . E O A I E A N Y M X R T E I H T DA T E T I ME 2 8 0 J : 0 U 2 2 2 N 8 0 PM 1 @ ! ST ORE BA TTER Y : Be sure to fully discharge a battery pack by performing the following steps before storing it for a long period of time, otherwise the battery performance will be reduced.
8 Q t PAUSE 180 ° 180 ° i @ ! 3 0 ( u Grip Adjustment 1) Separate the V elcro strip. 2) Pass your right hand through the loop and grasp the grip. 3) Adjust so that your thumb and fingers can easily operate the Recording Start/Stop Button 0 and Power Zoom Lever 3 .
9 1 R 4 2 B 2 E 4 5 5 R 0 C 4 M . I M I C 1 G I S N O 2 H N P N . T S G 0 – R 2 – L V P A A I H A T – G S U U – H S L – S T R E A – – E T – E C I 1 – T O 1 – N : 6 1 S 4 – T + M .
10 1 • MENU Wheel [ – , +] ........................................... pg. 18 • BRIGHT Wheel [ – , +]* 1 .................................................................. pg. 1 1 • Speaker V olume Control [VOL.]* 1 .................
11 RECORDING Set REC MODE, S-VHS (S-VHS ET), T APE LENGTH and DA TE/TIME in SYSTEM MENU. ( pg. 18 – 22, “ MENU SETTINGS ” ) 1 Remove the lens cap. Set the Power Switch @ to “ ” or “ ” while pressing down the Lock Button ! located on the switch.
12 BASIC FEA TURES Snapshot (GR-SXM967, GR-SXM367 only) Y ou can record still images that look like photo- graphs onto a tape. 1) Perform step 1) of “ RECORDING ” ( pg. 1 1). 2) Press SNAPSHOT 2 . • There is a momentary camera shutter-type blackout together with the sound effect of a shutter closing.
13 D ANGER • The video light can become extremely hot. Do not touch it either while in operation or soon after turning it off, otherwise serious injury may result. • Do not place the camcorder into the carrying case immediately after using the video light, since it remains extremely hot for some time.
14 T racking Eliminates noise bars that appear on-screen during playback. T o activate Manual T racking: 1) Press the TRACKING Wheel 1 for approx. 2 seconds. “ MT ” p appears. 2) Rotate the TRACKING Wheel 1 so that the noise bars disappear . • T o return to Auto T racking, press the TRACKING Wheel 1 for approx.
15 Connections T o A TV/VCR 1) Make sure all units are turned off. 2) Connect the camcorder to a TV or VCR using optional video and audio cables. If using both TV and VCR, connect the VCR output to the TV input. 3) T urn on all units. Set the VCR to its AUX input mode, and set the TV to its VIDEO mode.
16 Using The Cassette Adapter Use this to play back an S-VHS-C/VHS-C video cassette recorded with this camcorder on a S-VHS/ VHS VCR. 1) Slide the battery cover up to remove it, install one “ AA (R6) ” size battery , then reattach the cover .
17 INSTR UCTIONS 1 R 4 2 B 2 E 4 5 5 R 0 C 4 M . I M I C 1 G I S N O 2 H N P N . T S G 0 – R 2 – L V P A A I H A T – G S U U – H S L – S T R E A – – E T – E C I 1 – T O 1 – N : 6 1.
18 . E S M T T . T X T . I I R O P A W T T E O B . L L T S S I B E E U C Y U L . R A S R I S N M T E Z E E E E T R M R U A P M M E A O A H E N U N U A N U T T P U O O .
19 M.W .B. If the white balance is correct, all other colours will be accurately reproduced. AU T O : White balance is adjusted automatically . FINE : Outdoors on a sunny day . CLOUD : Outdoors on a cloudy day . HALOGEN : A video light or similar type of lighting is used.
20 SYSTEM MENU This Menu Screen cannot be accessed while recording. REC MODE Allows you to set the recording mode. “ EP ” (Extended Play) is more economical, providing three times the recording time. • If the recording mode is switched during recording, the playback picture will be blurred at the switching point.
21 T APE LENGTH Allows you to set the tape length depending on the tape used: T20=20 minutes, T30=30 minutes, T35=35 minutes, T40=40 minutes. • T ape remaining time 1 is correct only if the correct tape length has been selected. DISPLA Y FULL: Makes all of the indications appear on the LCD monitor*/viewfinder during playback or recording.
22 DEMO MODE Demonstrates certain functions automatically . Available when the Power Switch @ is set to “ ” or “ ” and “ DEMO MODE ” is set to “ ON ” (factory- preset). Performing any operation during the demonstration stops the demonstration temporarily .
23 ADV ANCED FEA TURES Night-Alive (GR-SXM967, GR-SXM367 only) Makes dark subjects or areas even brighter than they would be under good natural lighting. 1) Set the Power Switch @ to “ ” or “ ” while pressing down the Lock Button ! located on the switch.
24 Programme AE With Special Ef fects 1) Set the Power Switch @ to “ ” while pressing down the Lock Button ! located on the switch. 2) Press P .AE ^ repeatedly until the desired mode appears. • T o cancel the effect, press P .AE ^ repeatedly until “ OFF ” appears.
25 W E R T U Y I O P a s d Buttons W Infrared beam transmitting window E ZOOM (T/W) Buttons R PLA Y Button T REW Button Y ST OP Button U INSERT Button I REC TIME Button ANIM. Button O ST ART/STOP Button P FF Button a P AUSE Button s A.DUB Button d INT .
26 Playback Zoom T o magnify the recorded image up to 10X at any time during playback. Make sure that the TBC mode is activated. 1) Press PLA Y R to find the scene of interest. 2) Press ZOOM ( T/W ) E . Pressing T zooms in. T o end zoom press and hold W until magnification returns to normal.
27 Audio Dubbing Y ou can record a new soundtrack on a prere- corded tape (normal audio only). The sound is recorded from the built-in microphone. Perform steps 1) and 2) of the Insert Editing procedure ( pg.
28 TROUBLESHOOTING Before consulting your JVC dealer , please check the following to see if you can correct the problem yourself. V er tical white lines appear when shooting a very bright object. • This sometimes occurs when the contrast between the back-ground and the object is great.
29 2. T o prevent damage and prolong service life . . . .... do not subject to unnecessary shock. .... avoid repeated charging without fully discharging. .... charge in an environment where temperatures are within the tolerances shown in the chart below .
30 About moisture condensation . . . • Y ou may have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass ’ outer surface.
31 SPECIFICA TIONS Camcorder General Format : S-VHS/VHS NTSC standard P o wer sour ce : DC 1 1 V (Using AC Adapter) DC 6 V (Using battery pack) P o wer consumption Viewfinder on : 4.5 W (GR-SXM967/SXM767 only) 4.3 W (GR-SXM367/SXM267 only) 4.1 W (GR-SX897 only) LCD monitor * on : 5.
32 Some accessories are not available in some areas. Please consult your nearest JVC dealer for details on accessories and their availability . Specifications shown are f or SP mode unless otherwise indicated. E & O.E. Design and specifications subject to change without notice.
Ein wichtiger Punkt beim Kauf des Geräts JVC GR-SXM367 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie JVC GR-SXM367 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für JVC GR-SXM367 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von JVC GR-SXM367 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über JVC GR-SXM367 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon JVC GR-SXM367 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von JVC GR-SXM367 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit JVC GR-SXM367. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei JVC GR-SXM367 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
