Benutzeranleitung / Produktwartung 1055 GN des Produzenten Husqvarna
Zur Seite of 29
S E R V I C E O 070 7 904 2007-12 Manual No. 204839A Revision - (08/25/2007) 531 30 97-19 1055GN 5500 W att Portable Generator Husqvarna® is a registered trademark of Husqvarna AB and is used under license to Briggs & Stratton Power Products Group, LLC.
2 www.usa.husqvarna.com Thank you for purchasing this quality-built Husqvarna generator. We are pleased that you’ve placed your confidence in the Husqvarna brand. When operated and maintained according to the instructions in this manual, your Husqvarna generator will provide many years of dependable service.
3 Español Table of Contents O p e r a t o r S a f e t y .................................. 4 E q u i p m e n t D e s c r i p t i o n ........................................ 4 S a f e t y R u l e s ................................................ 4 A s s e m b l y .
4 www.usa.husqvarna.com Operator Safety Equipment Description Read this manual carefully and become familiar with your generator. Know its applications, its limitations and any hazards involved. The generator is an engine–driven, revolving field, alternating current (AC) generator.
5 WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. WARNING Generator produces hazardous voltage. Failure to isolate generator from power utility can result in death or injury to electric utility workers due to backfeed of electrical energy.
6 www.usa.husqvarna.com WARNING Contac t with muffler area can result in seriou s burns . Exhau st heat/gas es can ignite combus tibles , struc tures or damage fuel tank causi ng a fire. • DO NOT touch hot parts and AVOID hot exhaust gases. • Allow equip ment to cool before touchi ng.
7 Assembly Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended fuel and oil. If yo u have any pr obl ems with the ass em bly of your gene rat or , ple ase call the gen er ato r hel pli ne at (877 ) 2 24- 04 58 .
8 www.usa.husqvarna.com Add Engine Oil 1. Place generator on a flat, level surface. 2. Clean area around oil fill and remove yellow oil fill cap. NOTE: See the section Oil to review oil recommendations. Verify provided oil bottle is correct viscosity for current ambient temperature.
9 System Ground The generator has a system ground that connects the generator frame components to the ground terminals on the AC output receptacles. The system ground is connected to the AC neutral wire (the neutral is bonded to the generator frame).
10 www.usa.husqvarna.com A - 120 Volt AC, 20 Amp, Duplex Receptacles — May be used to supply electrical power for the operation of 120 Volt AC, 20 Amp, single phase, 60 Hz electrical, lighting, appliance, tool, and motor loads.
11 Cord Sets and Receptacles Use only high quality, well-insulated, grounded extension cords with the generator’s 120 Volt duplex receptacle. Inspect extension cords before each use.
12 www.usa.husqvarna.com Operation Starting the Engine Disconnect all electrical loads from the generator. Use the following start instructions: 1. Make sure unit is on a level surface. IMPORTANT: Failure to start and operate the unit on a level surface will cause the unit not to start or shut down during operation.
13 Connecting Electrical Loads 1. Let engine stabilize and warm up for a few minutes after starting. 2. Plug in and turn on the desired 120 and/or 240 Volt AC, single phase, 60 Hz electrical loads. NOTE: • DO NOT connect 240 Volt loads to the 120 Volt duplex receptacles.
14 www.usa.husqvarna.com Don’t Overload Generator Capacity You must make sure your generator can supply enough rated (running) and surge (starting) watts for the items you will power at the same time. Follow these simple steps: 1. Select the items you will power at the same time.
15 Maintenance Maintenance Schedule Follow the hourly or calendar intervals, whichever occurs first. More frequent service is required when operating in adverse conditions noted below.
16 www.usa.husqvarna.com Fuel Valve Maintenance The fuel valve is equipped with a fuel sediment cup, screen, retaining ring and o-ring that need to be cleaned every 100 hours or once a year (whichever occurs first). 1. Move fuel valve to “ Off ” position.
17 Changing Engine Oil Change the oil after the first 5 hours of operation. Change oil every 50 hours thereafter. If you are using your generator under extremely dirty or dusty conditions, or in extremely hot weather, change the oil more often. CAUTION Avoid prolonged or repeated skin contact with used motor oil.
18 www.usa.husqvarna.com WARNING Contac t with muffler area can result in seriou s burns . Exhau st heat/gas es can ignite combus tibles , struc tures or damage fuel tank causi ng a fire. • DO NOT touch hot parts and AVOID hot exhaust gases. • Allow equip ment to cool before touchi ng.
19 Storage The generator should be started at least once every seven days and allowed to run at least 30 minutes. If this cannot be done and you must store the unit for more than 30 days, use the following guidelines to prepare it for storage. Generator Storage • Clean the generator as outlined in Cleaning .
20 www.usa.husqvarna.com Troubleshooting Problem Cause Correction Engine is running, but no AC output is available. 1. One of the circuit breakers is open. 2. Fault in generator. 3. Poor connection or defective cord set. 4. Connected device is bad. 1.
21 Warranties Emissions Control System Warranty Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB) and the United States Environmental Protection Agency (U.
22 www.usa.husqvarna.com 2. Length of Coverage B&S warrants to the initial owner and each subsequent purchaser that the Warranted Parts shall be free from defects in materials and workmanship which caused the failure of the Warranted Parts for a period of two years from the date the engine is delivered to a retail purchaser.
23 HUSQVARNA® PORTABLE GENERATOR OWNER WARRANTY POLICY LIMITED WARRANTY Husqvarna® is a registered trademark of Husqvarna AB and is used under license to Briggs & Stratton Power Products.
24 www.usa.husqvarna.com Portable Generator Product Specifications Starting Wattage . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6,875 watts W a t t a g e .................................. 5 , 5 0 0 w a t t s AC Load Current: a t 1 2 0 V o l t s .
EXPLODED VIEW – MAIN UNIT Exploded View 2 www .usa.husqvarna.com Copyright © 2007 Briggs & Stratton Power Products Group, LLC. All rights reserved. No part of this material may be reproduced or transmitted in any form by any means without the express written permission of Briggs & Stratton Power Products Group, LLC.
Parts List Item Part # Description 1 M204097GS KIT , Cradle (Includes Items 20, 31 & 61) 2 194150GS KIT , Vibration Mount, 45° 3 67989GS NUT , M8 Flange Serrated 4 190220GS ADAPTER, Engine 5 NSP ASSY ., Alternator (see page 5) 6 * NUT , Hex M8 - 1.
Exploded View and Parts List EXPLODED VIEW AND P AR TS LIST – CONTROL P ANEL Item Part # Description 1 195112GS ASSY , Control Lid Panel 2 196506AGS CONTROL P ANEL, Compact 3 188890GS BOX, Rear Cove.
Exploded View and Parts List EXPLODED VIEW AND P AR TS LIST – AL TERNA TOR Item Part # Description 1 186059GS ADAPTER, Mounting, Alternator 2 190032GS ROTOR 3 190079AGS ST A TOR 4 186060GS RBC, with O-Ring (p/n 189197GS) 5 86308HGS HHCS, M6 - 1.0 x 140 SEMS 6 91825GS ASSEMBL Y , Holder , Rectifier/Brush 7 66849GS T APTITE, M5 - 0.
Exploded View and Parts List EXPLODED VIEW AND P AR TS LIST – WHEEL KIT Item Part # Description 1 B4966GS WHEEL 2 * WASHER, 5/8" 3 191267RGS AXLE 4 191265GS E-RING 5 * HHCS, M8 1.25 x 20 6 67989GS NUT , M8, Flange Serrated 7 203977GS ASSY , Support 8 198669GS GRIP 9 B193200GS ASSY , Handle w/Grip 10 * NUT , M8 - 1.
Ein wichtiger Punkt beim Kauf des Geräts Husqvarna 1055 GN (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Husqvarna 1055 GN noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Husqvarna 1055 GN - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Husqvarna 1055 GN reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Husqvarna 1055 GN erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Husqvarna 1055 GN besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Husqvarna 1055 GN verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Husqvarna 1055 GN. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Husqvarna 1055 GN gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
