Benutzeranleitung / Produktwartung TDL13 des Produzenten Hotpoint
Zur Seite of 24
USER HANDBOOK MODELS TDL12 TDL13 TDL32 TDL34 T VM35 Y ou must read these instructions prior to using the appliance and retain them f or future ref erence.
Contents P age F or your saf ety 3-4 Electrical Requirements 5 F eatures - Get to know the main par ts of your Dryer 6 Where to put and v ent your Dryer 7-8 How to use y our Dr yer 9 Sor ting your lau.
3 For y our saf ety NEVER ● Allow children to play with or otherwise interfere with the dryer. NEVER ● Allow the air inlet at the back of the dryer, the air outlet or vent hose to be obstructed. NEVER ● Direct the vent hose outlet towards the air intake at the back of the machine.
4 For y our saf ety ALWAYS ● When the dryer is not in use, switch off at the wall, remove plug and close the door. ALWAYS ● Comply with the specified electrical requirements. ALWAYS ● Ensure that your dryer is installed correctly and has adequate ventilation.
5 Electrical Requirements Supply Changing the fuse Moulded plug Changing the plug Rewirable plug Changing the mains cable WARNING: This appliance must be earthed! REFER TO THE RATING PLATE FOR VOLTAGE AND CURRENT REQUIREMENTS. (see diagram for location.
6 Features - Get to kno w the main par ts of y our dryer Model and serial numbers NOTE: if your dryer is new wipe out the inside of the drum before you first use it to remove any dust which may have accumulated during transit. NOTE: When the dryer is in use, avoid touching the back of the machine as it may be hot.
7 Where to put and vent y our dryer Your Tumble Dryer should NOT be located adjacent to a gas hob cooker, heater, or eye level grill as flames from the burners could cause damage to your machine. When the dryer is fitted under a work surface allow space for air to enter the rear grille, 10mm above the dryer minimum.
8 Where to put and vent y our dryer In conjunction with the vent hose we recommend the use of a Wall/Window Vent Kit. These are available from your retailer or nearest Spares Centre. Fitting instructions are supplied with the kits, which can be mounted through a wall or window.
9 Ho w to use y our dr yer 1. Plug in, switch on electricity. 2. Sort your laundry (see section “Sorting Your Laundry”) 3. Open the door. Check that the fluff filter is clean (see section “How to remove and clean the fluff filter”).
10 Sor ting y our laundry 1. Always separate laundry into the correct fabric groups before washing and drying. 2. See that all zips are closed, hooks and eyes are fastened and belt, strings etc. are tied loosely in bows, you will normally have done this for each item before the washing stage.
11 W ash Care Labels Most of today’s fabrics can be tumble dried in your Dryer with no trouble at all, but there are certain fabric finishes which should be dried away from direct heat. The majority of garments now have wash-care labels on them, giving full washing and drying instructions.
12 Items requiring special attention The drying requirements of blankets and bedspreads will, of course, vary tremendously according to size and weight. Some, however are simply too big. if you have difficulty getting them into the Dryer, the machine will have difficulty drying them properly.
13 Ho w to remo ve and c lean the fluff filter Position of filter To remove the filter A very important part of your dryer is the fluff filter at the front edge of the drum. It’s there to trap the particles of lint and fluff which are normally blown away when clothes are dried on the washing-line.
14 TDL12 TDL13 Heat Selection TDL12 and TDL13 The ‘Cool Tumble’ phase TDL12 and TDL13 The Contr ols - TDL12 and TDL13 Heat Switch (OUT low heat, IN high heat) Timer Knob Turn the timer clockwise to select the required drying time. The timer controls the drying time for both heat settings.
15 The Contr ols - TDL32 Timer control Heat Selection The ‘Cool Tumble’ phase Heat Switch (OUT low heat, IN high heat) Indicator Turn the timer clockwise to select the required drying time. The timer controls the drying time for both heat settings.
16 The Contr ols - TDL34 and TVM35 Setting Delayed Start Programme Setting Programme Options (i) Automatic Drying Note: Heat Switch (OUT low heat, IN high heat) Alarm Switch (IN on) Drying Light Auto Light When using the Time Delay, select the number of delay hours you require before selecting the drying time.
17 The Contr ols - TDL34 and TVM35 (contin ued) (ii) Easy Iron Cycle (iii) Timed Drying (iv) Cool Tumble Phase Auto dry Light Drying Light Heat Selection Alarm (Buzzer) Selection This is a short programme of approximately 10 minutes to condition previously dried clothes.
Please note that the Drying Times stated below and on appliance control panel are a GUIDE only and drying times are affected by : Items such as towelling retain a lot of water after spinning, also the suggested wash programme for small items such as T-Shirts may sometimes incorporate a low spin speed which has the same effect.
19 Easy Ir on Pr ogramme - Selected Models When to use ‘Easy Iron’ Important! Audio Signal ‘Easy Iron’ provides a short programme consisting of approximately 7.
20 When finished After each load As necessary Lubrication Caring f or y our Dr y er Your tumble dryer needs very little attention. The following simple steps will keep it performing well. Switch off electricity and remove plug. Always clean the filter and turn the drum by hand to check that small items like handkerchiefs do not get missed.
Problem ‘It won’t start’ ‘It is taking a long time to dry’ Auto Programmes Any other problem First, don’t panic! There may be nothing wrong at all.
22 If it still w on’t w ork... Spare par ts Disposal of y our pr oduct if something is still wrong with your machine after you’ve been through the check-list on the previous page: 1. Switch off and unplug your machine from the mains. 2. Call your nearest Service Office or local importer (outside the UK).
.
General Domestic Appliances Ltd, Peterborough, PE2 9JB. PRINTED BY SIMLEX FOUR ASHES, WOLVERHAMPTON. June 2002 Part No. 0766200088-01 K e y Contacts Service Hotpoint has the largest appliance manufacturer’s service team in Europe, trained specialists directly employed by us to ensure your complete confidence.
Ein wichtiger Punkt beim Kauf des Geräts Hotpoint TDL13 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Hotpoint TDL13 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Hotpoint TDL13 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Hotpoint TDL13 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Hotpoint TDL13 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Hotpoint TDL13 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Hotpoint TDL13 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Hotpoint TDL13. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Hotpoint TDL13 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
