Benutzeranleitung / Produktwartung BD42 des Produzenten Hotpoint
Zur Seite of 40
T o the Installer Before installation fill in the product details on the back co ver of this booklet. The information can be found on the r ating plate . T o the User Y ou must read the instructions prior to installing and using th e appliance and then retain them for future r eferenc e.
2 PLEASE READ THIS BOOKLET CAREFULL Y . C onten ts P age Introduction 3 Safety Information - Always 4 Never 5 The main parts of your Double O ven 6 The cooking systems in your Double Oven 7 T emperatu.
3 Introduction This appliance conforms to the following EEC Directives: Electromagnetic Compatibility Low Voltage Equipment 89/336/EEC 73/23/EEC 92/31/EEC 93/68/EEC 93/68/EEC To minimise the risk of injury to children please dispose of your product carefully and safely.
4 Always ● Always make sure you remove all packaging and literature from inside the oven and grill compartments before switching on for the first time.
5 Nev er ● Never leave children unsupervised where a cooking appliance is installed as all cooking surfaces will be hot during and after use. ● Never allow anyone to sit or stand on any part of the appliance . ● Never store items above the appliance that children may attempt to reach.
6 The main parts of your Double Oven WARNING: DO NOT TOUCH THE GLASS DOORS WHEN THE OVEN IS IN USE AS THESE AREAS CAN BECOME HOT. Main Oven Temperature Selector Timer Grill/top oven element Oven Light.
7 The C ook ing S ystems in y our Double O v en Your new oven is equipped with three different cooking systems: 1. Conventional Heating (Top Oven ) - with upper and lower heat. This system is particularly suitable for roasting and baking on one shelf only.
8 T empera ture C onv ersion Char t The chart below gives details of comparisons of oven settings for gas conventional ovens and fan oven in degrees ˚F and ˚C CONVENTIONAL OVEN ˚F ˚C 250 120 275 1.
9 Cooling Fan: A gentle flow of air will be blown below the control panel when any selector switch is used. Note: Whenever the appliance has been used, the cooling fan may run on or restart itself after all the controls have been turned off. This indicates that the appliance is still warm.
10 Oven T imer Operation A UTOMA TIC COOKING The Top Oven and Main Oven can be controlled by the automatic timer. When the timer control has been set for one oven, it is possible to use the other oven only during the same automatic cooking programme. HINTS ON A UTOMA TIC C OOKING 1.
Know Y our Timer 11 CL OCKF ACE The timer incorporates a 24 hour clock. Ensure the correct time of day is always set, before using you cooker. SYMBOLS A ‘bell’ symbol will light up when you select a Minute Minder Period and will remain lit for the period set.
Elec tronic Clock & A utomatic Oven Timer Operation 12 SETTING THE TIME OF DA Y Step 1 Make sure all oven controls are turned Off. Step 2 Check the electricity supply to the cooker is turned on. Step 3 When switched on the display will show 0.00 and the Auto symbol , flashing intermittently.
Elec tronic Clock & A utomatic Oven Timer Operation 13 Step 3 Press and hold in the Cook Period button. The display will read 0.00 with the ‘cookpot’ symbol lit. Step 4 With the Cook Period button still held in, set the required Cook Period using the “+” and “–” buttons.
Elec tronic Clock & A utomatic Oven Timer Operation 14 Step 4 Press & hold in the Cook Period button, the display will read 0.00 and the ‘cookpot’ symbol will light up. With the Cook Period button still held in set the required Cook Period using the “+” and “–” buttons.
Elec tronic Clock & A utomatic Oven Timer Operation 15 OTHER NOTES ON TIMER OPERATION 1. When cooking Automatically the Cook Period can be checked at any time simply by pressing the Cook Period button. 2. When cooking Automatically the End Time can be checked at any time by simply pressing the End Time button.
The grill pan handle is detachable from the pan, to facilitate cleaning and storage. The grill pan handle can be fixed as follows: Step 1 Remove the screw and washers from the grill pan bracket (a). Step 2 Tilt the handle over the recess (b). Step 3 Slide it towards the centre of the pan (c).
Step 1 Ensure oven timer is set to manual. Place the shelf in the correct position (see Grilling Guide). Place the food/grill pan on the shelf, positioned centrally under the grill element. Leave the top oven door fully open. Step 2 Turn knob (B) clockwise to select grill function setting: Set to: For Half Grill (Left hand side only).
18 Guide to Grilling FOOD Toasting of Bread Products Small cuts of meat, Sausage, Bacon Chops etc. Gammon steaks Fish: Whole Fillets Fingers Setting 6 8 - 12 minutes 10 - 15 minutes 10 - 20 minutes Pre-cooked potato products Pizzas Browning of food eg.
19 The top oven should be used to cook small quantities of food. The oven is designed so that the grill element operates at a reduced heat output, this is combined with a heating element situated underneath the floor of the oven.
❍❍ ❍ 20 Step 1 Check that the timer is in manual. Step 2 Place the shelf in the correct position (see Oven Temperature Charts). Step 3 Select the required cooking temperature (100–220 o C) using control (B) (see Top Oven Temperature Charts).
Note: If soft margarine is used for cake making, temperatures recommended by the manufacturers should be followed. Temperatures recommended in this chart refer to cakes made with block margarine only. Oven T emperatur e Char ts – Baking 21 Scones Food Pre- heat Yes 210/220 10-15 Runner 1 from bottom of oven.
Oven T emperatur e Char ts – Meat Beef/ Lamb (slow roasting) Meat 170/180 35 mins per 450g (1 lb) + 35 mins over. Runner 1 from bottom of oven. 35-40 mins per 450g (1 lb) 40 mins per 450g (1 lb) + 4.
23 Using the Main Ov en for F an Cooking Step 1 Check that the timer is in manual. Step 2 Place the shelf/shelves in the correct position (see Main Oven Temperature Charts. Step 3 Place the food centrally on the shelf ensuring the oven door is fully closed.
24 Using the Main Ov en for O ther F unc tions F AN ONL Y SET TING DEFROSTING FROZEN MEAT & POULTRY Joints of meat and whole birds should be defrosted slowly, preferably in a refrigerator (allowing 5-6 hours per lb.) or at room temperature (allowing 2-3 hours per lb.
25 Using the Main Ov en for O ther F unc tions ‘S’ SL OW COOK SETTING This is used for slow cooking, keeping food warm and warming plates for short periods. Extra care should be taken when warming bone china, as it may be damaged in a hot oven. ADV ANT AGES OF SL OW COOKING ARE: The oven stays cleaner because there is less splashing.
Car e and Cleaning 26 1. “ST A Y CLEAN” OVEN LINERS ( T op O ven Sides , Main O ven Sides and Rear P anel) ( a) How "Stayclean" works. The surfaces of the "Stayclean" oven liners (Main Oven rear panel) are treated with a special vitreous enamel which absorbs cooking soils.
Car e and Cleaning 27 2. CLEANING GRILL, T OP OVEN AND MAIN O VEN (a) Base & Rear of Top Oven and Base of Main Oven. Wipe out the oven with a damp soapy cloth. For more stubborn stains on the base of the oven use a well soaped fine steel wool soap pad.
Car e and Cleaning 28 4. REPLACEMENT OF THE O VEN L AMP Open the oven door and remove the oven shelves. Using a thick cloth, grip the lamp lens, unscrew anti- clockwise and remove the lens. Carefully unscrew the bulb anti-clockwise. Fit replacement bulb (15W 300°C SES) and refit lens.
29 Car e and Cleaning Take particular care not to damage the inner surface of the door inner glass that is coated with a heat reflective layer. Do not use scouring pads, or abrasive powder, which will scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical blows.
30 Electric al Requirements For your own safety, we recommend that your cooker is installed by a competent person such as one who is registered with NICEIC (National Inspection Council for Electrical Installation Contracting). The cooker should be installed in accordance with the latest edition of the IEE Regulations.
31 Impor tant It is essential that the lower cupboard is constructed in the manner illustrated i.e. having side, back, and roof panels so joined as to provide no apertures which could permit access to the oven unit when installed.
32 T all Cabinet V entilation Ventilation Slot required here if cabinet does not fit to ceiling - 51mm x 457mm min. area 50mm Air Gap 50mm Air Gap Ventilation Slot required here if the cabinet does fit to the ceiling - 51mm x 457mm min. area Ventilation Slot required here 51mm x 457mm min.
33 577mm exc. handle knobs 887mm 597mm 560mm 560-574mm 875mm 887mm 878mm if cooker trim is to overlap top edge of shelf * excluding pipe work and other projections 4mm 2 Cable to Hob if fitted 4mm 2 Cable To Oven 6mm 2 Cable if hob fitted Connector Box Fig.
34 If something goes wrong ... Slight odour or small amount of smoke when grill / oven used first time This is normal and should cease after a short period. Nothing Works If you find that the timer display is blank, then it is likely that there is no electricity supply to your oven.
If something goes wrong ... Oven lamp does not work The oven lamp is not covered by the guarantee. The part is easily changed (see the section on oven lamp replacement) A new lamp may be obtained from our Genuine Parts & Accessories Hotline (see ‘Key Contacts’, back page).
Satisfaction Guaranteed or Your Money Back Hotpoint gives you a unique ‘Satisfaction Guaranteed’ promise – valid for ninety days after you have purchased your Hotpoint product. If there is a technical problem with your Hotpoint appliance, just call Hotpoint Service (see back page).
.
.
.
PRINTED BY SIMLEX . FOUR ASHES, WOLVERHAMPTON. March 2003 Part No. 4866200183-01 K ey Contacts Ser vice Hotpoint has the largest appliance manufacturer’s service team in Europe, trained specialists directly employed by us to ensure your complete confidence.
Ein wichtiger Punkt beim Kauf des Geräts Hotpoint BD42 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Hotpoint BD42 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Hotpoint BD42 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Hotpoint BD42 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Hotpoint BD42 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Hotpoint BD42 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Hotpoint BD42 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Hotpoint BD42. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Hotpoint BD42 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
