Benutzeranleitung / Produktwartung 17LD4220 LCD TV des Produzenten Hitachi
Zur Seite of 34
NL GB DK D Gebruiksaanwijzing Instructions for use Instruktionsbog Bedienungsanleitung 17LD4220.
- 34 - Contents Remote Control Buttons ....................... 3 5 Control Panel Buttons .......................... 3 6 Preparation ........................................... 3 7 Installation of the TFT TV to the wall .. 3 7 Features ................
- 35 - Remote Control Buttons = S t and B y = Cursor Up = Cursor Right OK = Store = Info (Program Menu) 0 - 9 = Direct Program -/-- = Double Digit =Previous Programme P/CH + = Programme Up + = V olume.
- 36 - Control Panel Buttons 2-ENG-1700W-1547UK-17 INCH TFT-WM-17LD4220.p65 01.12.2004, 14:19 36.
- 37 - Preparation Install Display on solid horizontal surface such as a table or desk. For ventilation, leave a space of at least 10 cm free all around the set. To prevent any fault and unsafe situations, please do not place any objects on top of the set.
- 38 - 2-ENG-1700W-1547UK-17 INCH TFT-WM-17LD4220.p65 01.12.2004, 14:19 38.
- 39 - Panel Features High resolution (1280 x 768) , 17 -inch TFT LCD display . High contrast ratio ( 400:1 T ypical) Brightness: 450 cd/m 2. High-speed response time < 25 msec. Wide viewing angle (typical) 140 ° (horizontal) and 11 0 ° (vertical).
- 40 - 1. Power Source The TV set is designed to operate on 12 V DC. The adaptor should be operated from a 220-240V AC, 50 Hz. outlet. Ensure you se- lect the correct voltage setting for your conve- nience.
- 41 - 8. Servicing Please refer all servicing to qualified per- sonnel. Do not remove cover as this may re- sult in electric shock. 9. Naked Flame Sources Do not place naked flame sources on the apparatus. WARNING: When the device is not in use for a long time, disconnect from power.
- 42 - Before Switching on your TV Power connection IMPORTANT: The TV set is designed to op- erate on 12 V DC. For this, an adaptor is used which gives 12V DC voltage.
- 43 - In either case the TV will switch on and di- minishes the brightness of the led. To switch the TV off NOTE: To switch the TV off completely re- move the mains plug from the socket.
- 44 - V olume Setting Press + button to increase volume. Press - button to decrease volume. A volume level scale (slider) will be displayed at the middle of the bottom on the screen. Programme Selecting (Previous or next programme) Press -P/CH button to select the previous programme.
- 45 - Menu button has two functions; first is open- ing or closing the main menu, and the sec- ond is closing the sub-menu and then open- ing its parent menu. Menu does not disappear automatically if it is left on the screen. Press key on the remote control unit to remove menu.
- 46 - sound system is Mono and the sound effect is set ON , then the sound will be heard as if it is Stereo . If the current sound system is Stereo , switching this effect on will give a more spatial sound. T o Change H.Phone/Line Out Settings Using or button select H.
- 47 - In Mode item there are five predefined and one user defined options. These are User, Classic, Jazz, Rock, Pop and Flat. The pre- defined options can not be changed by the user. If you want to change one of the fre- quency values of the predefined options, the Mode must be switched to User option.
- 48 - Press button to increase brightness. Press button to decrease brightness. Setting Contrast Using or button select Contrast. Press button to increase contrast level. Press button to decrease contrast level.
- 49 - Setting Hue (During Playback NTSC system, this will ap- pear in AV mode only when NTSC video source is applied. Otherwise, HUE option is invisible in Picture menu.): Using or button select Hue. Press button to increase hue level.
- 50 - handset. In this case the control panel but- tons except " " button on the right side of the TV will not work. Selecting Menu Language Menu language can be chosen by pressing or button on Language item. Av-2 Output From Av-2 Output; TV, AV-1 or AV-3 can be given.
- 51 - Selecting Band Band, can be chosen either, C or S by or button. Selecting Channel Channel can be changed by or but- ton, by Digit Buttons or by the Double Digit button with digit buttons. For band C, 01 - 83, WEST EUROPE.
- 52 - By moving the cursor in four directions, you can reach 20 programmes in the same page. By scrolling the pages up or down by pressing the navigation buttons you can se- lect all the programmes in TV mode (except the AV mode). By cursor action, programme selection is done automatically.
- 53 - Blue button cancels the activated Delete process. Autostore: To enter Autostore menu, press the blue button. To learn the features of this function see " Autostore " below. Autostore, searches and stores all channels automatically on your TV, according to the transmission of programme systems in your area.
- 54 - Double-digit (- / - -) This OSD is displayed when the "Double- Digit" button pressed in place of the pro- gramme number indicator. In order to enter a two digit programme number you must push both numbers within 3 seconds. If the second number is not en- tered within 3 secs the display will disap- pear.
- 55 - No-Signal Detection (TV) If no valid signal detected, it takes 5 minutes for the set to switch to Standby mode unless a signal is detected or a command is re- ceived from the remote control.
- 56 - Sound Menu In the main menu select Sound using or button then enter the Sound menu pressing , or OK buttons.
- 57 - PC SOUND MODE: This item selects the sound source for PC mode. But when the PIP is displayed and highlighted in green border, sound switches to whatever is displayed in the PIP. When- ever you close the PIP or make the PIP bor- der blue again by disselecting the PIP, sound switches back to PC Sound Mode.
- 58 - To select a page of Teletext Press the appropriate digit buttons for the required T eletext page number . The selected page number is displayed at the top left corner of the screen. The Teletext page counter searches until the selected page number is located, so that the desired page is displayed on the screen.
- 59 - Fastext Y our CTV support s the 7 p age T eletext sys- tem. When the page number of any of the 7 pages in memory is entered, the system will not search for the requested page; instead it will display the p age automatically . Press P/CH + button to move the T eletext screen forward one page at a time.
- 60 - Peripheral Equipment Connections 2-ENG-1700W-1547UK-17 INCH TFT-WM-17LD4220.p65 01.12.2004, 14:19 60.
- 61 - Peripheral Equipment Connections DECODER FOR SATELLITE RECEIVER VIDEO HEADPHONE AUDIO AERIAL Connections 2-ENG-1700W-1547UK-17 INCH TFT-WM-17LD4220.
- 62 - If the VCR is connected via aerial input it is suggested that you use the Programme 0. Decoder Cable TV offers you a wide choice of programmes. Most of them are free, others are to be paid for by the viewer. This means that you will need to subscribe to the broad- casting organisation whose programmes you wish to receive.
- 63 - PC INPUT TYPICAL DISPLA Y MODES The display has a maximum resolution of 1280 x 768 , vertical sync. frequency range of 50-75 Hz and a horizontal sync. frequency range of 30-69 KHz. The following table is an illustration of some of the typical video display modes.
- 64 - Tips Care of the Screen Clean the screen with a slightly damp, soft cloth. Do not use abrasive solvents as they may damage the TV screen coating layer Colours of image on screen are abnormal Fo.
- 65 - NUMBER OF PRESET CHANNELS 1 0 0 CHANNEL INDICA TOR On Screen Display RF AERIAL INPUT 75 Ohm (unbalanced) OPERA TING VOL T AG E For adaptor: 220-240 V AC, 50 Hz. For TV : 12 V DC AUDIO German + Nicam Stereo AUDIO OUTPUT POWER 2 x 3 W RMS. (%10 THD) POWER CONSUMPTION (W) (max.
Hitachi, Ltd. Tokyo, Japan International Sales Division THE HITACHI ATAGO BUILDING, No. 15 – 12 Nishi Shinbashi, 2 – Chome, Minato – Ku, Tokyo 105 - 8430, Japan.
Ein wichtiger Punkt beim Kauf des Geräts Hitachi 17LD4220 LCD TV (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Hitachi 17LD4220 LCD TV noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Hitachi 17LD4220 LCD TV - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Hitachi 17LD4220 LCD TV reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Hitachi 17LD4220 LCD TV erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Hitachi 17LD4220 LCD TV besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Hitachi 17LD4220 LCD TV verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Hitachi 17LD4220 LCD TV. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Hitachi 17LD4220 LCD TV gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
