Benutzeranleitung / Produktwartung HDT18PA des Produzenten Haier
Zur Seite of 26
Table Top Dishwasher User Manual Model # HDT18P A ON OFF OPEN CLOSE Rinse Hold Normal Heavy Vented Dry HDT18PA.
GB IMPORT ANT SAFETY INSTRUCTIONS 1. Read all instructions before using the appliance. 2. Use this appliance only for its intended purpose as described in this use andcare guide. 3. Use only detergents recommended for use in this appliance and keep them out of the reach of children.
2 faucets and let the hot water run for a few minutes. This will let the trapped hydrogen escape. During this process do not turn on an electric appliance,smoke, light a match/ lighter or use a flame to avoid an accident, as hydrogen gas is flammable and can explode.
SAFETY INSTRUCTIONS ........................................................................... 1 OPERATING INSTRUCTIONS ...................................................................4 P arts and Features..........................................
OPERA TING INSTRUCTIONS 4 Parts and Features 1 2 3 4 5 6 1. on/off button 2. dr y indicator light 3. wash cycle select buttons (normal / heavy / rinse et hold) 4.
5 3 2 1 1. exhaut vent 2. power cord (115V -60Hz) ) 3. water inlet tube 4. drain hose 4 GB.
6 8 9 1 1. water inlet 2. door seal 3. upper spray arm 4. lower spray arm 5. filter -located at the bottom of lower rack (not shown) 6. detergent dispenser 7.
7 Push the button in to have power "ON". Push the button out to have the power "OFF". OPERA TIONS Power Button: When V ented dr y cycle is selected, the light comes onindicating that it is now dr ying. At the end of the cycle,the buzzer will beep indicating that dr y cycle is completed.
8 Y our machine is equipped with automatic fault detection system. This convenience feature informs you of any faults during the operation. When fault occurs, the wash indicator light will flash and the buzzer will beep.
9 T o get maximum cleaning result, follow the recommendations below before you start the dishwasher: Loading the lower & Upper half rack: Note: Do not wash any heat sensitive or any other items that are not designed for automatic dishwasher.
Use proper recommended amount of detergent for your wash loads. Pour in detergent into open compartment that is located on the inside of the door . Pouring Dishwasher Detergent: The amount of detergent to use depends on the type of water in your living area whether it is hard or soft and whether items are lightly or heavily soiled.
11 Note: Use only manufacturer's recommended "Automatic Dishwasher Detergent" only for your dishwasher. Other types of detergents that are not for dishwasher use may cause oversudsing and foaming. Do not use detergents that are dried, caked or moist.
This cycle is used for rinsing partial loads that will be washed later . The total wash time for "Wash Only" cycle is approximately 6 minutes. Note: Do not use detergent with this cycle. Vented Dry (On/Off): Y ou can select this option at the beginning of the wash cycle to dr y your dishware items.
13 Y ou incoming water must be between at least 120 Degree F / 49 Degree C and most 150 Degree F / 66 Degree C but no more than 150 Degree F / 66 Degree C in order to have effective cleaning and prevent damage to your dishware.
The following suggestions are recommended to prevent stains and films from dishware and utensils items: Tips to avoid stains and films: 14 Y ou must rinse all dishware, silverware, glassware and food containers right a way after use.
15 Do not use abrasive, harsh cleaners, solvents, concentrated detergents or metal scouring pads to clean the inside of dishwasher. Use warm soapy water with soft brush or piece of cloth to clean the interior of a tub. Clean around the tub gasket with a damp cloth.
Y ou must protect your dishwasher if it is lef t in an unheated place during the winter . Preventing Your Dishwasher from Freezing: Y ou must store the dishwasher at room temperature. Do not install or operate your dishwasher where the temperature is below freezing.
17 Check if the unit is plugged in. The plug may have come loose. Check if the electrical wall receptacle is of proper voltage. Check if circuit breaker needs to be reset or if the fuse needs to be replaced. Check if the unit is on "Off" mode.
This is due to poor loading or overloading. Y ou need to be careful when loading. Do not overload. Y ou need to place glassware securely against pins. Make sure delicate items are on the side rack. We recommend that fine chinaware or cr ystalitems should be hand washed.
19 T oo much detergent used. Use the appropriate amount of detergent. Reduce amount of detergent used per load. The water temperature is too hot. Y ou need to lower water temperature. Use of old detergent. Avoid using old detergent. R ead expiration date.
Drain hose may be removed from the back of the back of the unit. Check if the drain hose is removed.If may have come loose and need tk be tightened. Check the lecel of the drain hose.The drain hose should be positioned above the drain in order to drain properly.
21 Scissors Phillips Screwdriver Standard Screwdriver Pliers Wrench T ape Measure Gloves Level Unpacking Your Dishwasher Tools and Materials Required Remove all packing materials including all adhesive tape holding the accessories inside and outside. Inspect and remove any remains of packing, tape or printed materials before using the dishwasher.
Read install instructions carefully before installation . Caution: If , af ter completing these steps, you are unsure that unit is properly installed, contact a qualified installer . T o ensure that your appliance is properly in stalled it is recommended that it be installed by a cer tified installer .
23 Y our dishwasher is equipped with a gravity drain system. The drain hose should be positioned above the drain in order to drain properly. If the drain hose is bent or shrunken , it may affect water draining. If water can not be drained out smoothly, the dishwasher operation will be disturbedand it may stop in the middle of the cycle.
Carry-In Service For 12 months from the date of original retail purchase, Haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship.
IMPORTANT Do not Return This product To The Store If you have a problem with this product, please contact the “Haier Customer Satisfaction Center” At 1-877-337-3639. DATED PROOF OF PURCHASE REQUIRED FOR WARRANTY SERVICE 115V, 60Hz Made in China Haier America Trading, L.
Ein wichtiger Punkt beim Kauf des Geräts Haier HDT18PA (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Haier HDT18PA noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Haier HDT18PA - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Haier HDT18PA reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Haier HDT18PA erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Haier HDT18PA besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Haier HDT18PA verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Haier HDT18PA. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Haier HDT18PA gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
