Benutzeranleitung / Produktwartung 4.10ESi des Produzenten Alto-Shaam
Zur Seite of 28
MN-29805 • 08/12 printed i n u . s . a . Combitherm ® Combination Oven / Steamer CT EXPRESS™ 4•10es i 4•10esiVH • InstallatIon W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA PHONE: 262.251.
i Delivery .................................. 1 Unpacking ................................ 1 Safety Procedures and Precautions ............. 2 Installation Site Installation .......................... 3 Ventilation Requirements ................... 3 Positioning on Site .
INSTALLATION MANUAL • 1. DELIVERY This Alto-Shaam appliance has been thoroughly tested and inspected to ensure only the highest quality unit is provided. Upon receipt, check for any possible shipping damage and report it at once to the delivering carrier.
INSTALLATION MANUAL • 2. CAUTION Used to indicate the presence of a hazard that can or will cause minor personal injury, property damage, or a potential unsafe practice if the warning included with this symbol is ignored.
INSTALLATION MANUAL • 3. SITE INSTALLATION INSTALLATION DANGER IMPROPER INSTALLATION, ALTERATION, ADJUSTMENT, SERVICE, OR MAINTENANCE COULD RESULT IN SEVERE INJURY, DEATH, OR CAUSE PROPERTY DAMAGE.
INSTALLATION MANUAL • 4. NOTE: Note dimensions required for doorways and aisles for access of the oven and pallet to the installation site. Transport the oven in an upright and level position only. Do not tilt the oven.
INSTALLATION MANUAL • 5. LIFTING INSTRUCTIONS INSTALLATION Remove banding before lifting. Lift the unit from either side of the unit, never from the front o r back . Adjust the forks so that they do not damage any of the components under the unit.
INSTALLATION MANUAL • 6. SITE INSTALLATION INSTALLATION EXHAUST VENT 18" (46cm) 4" (102mm) 4" (102mm) 20" (50cm) MINIMUM 20" (50cm) POSITIO.
INSTALLATION MANUAL • 7. ACCESSORIES CombiClean® Tablets — CE-28892 s P E c i a l l y F O r M u l a t E d FOr cOMbitHErM OvENs ➥ t w O (2) c O N t a i N E r s .
INSTALLATION MANUAL • 8. WATER REQUIREMENTS WATER QUALITY MINIMUM STANDARDS ONE (1) COLD W A TER INLETS - DRINKING QUALITY ONE (1) W A TER INLET : 3/4" G* LI NE PR ES SU RE: 30 to 90 psi 2.
INSTALLATION MANUAL • 9. WATER REQUIREMENTS WATER QUALITY MINIMUM STANDARDS ONE (1) COLD W A TER INLETS - DRINKING QUALITY ONE (1) W A TER INLET : 3/4" G* LI NE PR ES SU RE: 30 to 90 psi 2.
INSTALLATION MANUAL • ELECTRICAL CONNECTION INSTALLATION DANGER ENSURE POWER SOURCE MATCHES VOLTAGE IDENTIFIED ON APPLIANCE RATING TAG.
INSTALLATION MANUAL • 11. ELECTRICAL CONNECTION INSTALLATION DANGER ELECTRICAL CONNECTIONS MUST BE MADE BY A QUALIFIED SERVICE TECHNICIAN IN ACCORDANCE WITH APPLICABLE ELECTRICAL CODES.
INSTALLATION MANUAL • 12. MOBILE EQUIPMENT RESTRAINT INSTALLATION Any appliance that is not furnished with a power supply cord but includes a set of casters, stand with casters, or a stacked configuration must be installed with a tether.
INSTALLATION MANUAL • 13. INSTALLATION WATER QUALITY REQUIREMENT WARNING TO PREVENT WATER PIPES FROM BURSTING, INCOMING WATER SUPPLY SHOULD BE TURNED OFF WHEN THE APPLIANCE IS NOT IN USE. WARNING WATER SUPPLY MUST BE OPEN WHEN CLEANING PROGRAM IS ACTIVATED.
INSTALLATION MANUAL • 14. INSTALLATION WATER CONNECTIONS WATER SUPPLY & INSTALLATION WATER REQUIREMENTS ONE (1) COLD WATER INLET - DRINKING QUALITY ONE (1) TREATED WATER INLET: 3/4" G LINE PRESSURE: 30 to 90 psi 2.
INSTALLATION MANUAL • 15. INSTALLATION OPTIONAL HAND HELD SPRAY HOSE V alve bracket INSTALLATION 1 Using the valve bracket as a template for placement, and a #28 drill bit (0.14" diameter), drill two holes at the lower rear side of the unit (same side as door opening).
INSTALLATION MANUAL • 16. INSTALLATION WATER VALVE WATER DRAINAGE NOTE: THE SHUT-OFF VALVE MUST BE IN THE OPEN POSITION WHEN THE OVEN IS BEING USED. The oven must discharge through an indirect waste pipe by means of an air gap.
INSTALLATION MANUAL • 17. INDICATOR LIGHT If the indicator light does not illuminate, the filters may be missing or not properly aligned. Check them for proper positioning. Ventless hood and oven will not operate unless the hood is closed properly.
INSTALLATION MANUAL • 18. INSTALLATION VENTLESS HOOD MODEL TOP EXHAUST VENT 1 Charcoal Filter: The charcoal filter should be inspected for contaminant's on a regular basis.
INSTALLATION MANUAL • 19. INSTALLATION CT EXPRESS™ CHECKLIST Use this list as a nal check of oven installation conformance. Damage directly attributed to improper set up, installation, or cleaning can invalidate warranty claims.
INSTALLATION MANUAL • continued on next page ERROR CODES This section is provided for the assistance of qualified technicians only and is not intended for use by untrained or unauthorized service personnel.
INSTALLATION MANUAL • 21. continued on next page ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E13 .
INSTALLATION MANUAL • 22. ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E34 Steam Generator Drain .
INSTALLATION MANUAL • 23. ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E57 No Rinse Water During rinse no water .
INSTALLATION MANUAL • 24. ERROR CODES When the oven malfunctions, an error code will appear in the display . PRESS THE ST AR T ICON TO ACKNOWLEDGE THE ERROR. The icons that begin to flash repr esent operational modes that are still usable.
INSTALLATION MANUAL • 25. ORIGINAL EQUIPMENT LIMITED WARRANTY Alto-Shaam, Inc. warrants to the original purchaser that any original part that is found to be defective in material or workmanship will, at Alto-Shaam’s option, subject to provisions hereinafter stated, be replaced with a new or rebuilt part.
TRANSPORTATION DAMAGE AND CLAIMS All Alto-Shaam equipment is sold F.O.B. shipping point, and when accepted by the carrier, such shipments become the property of the consignee. Should damage occur in shipment, it is a matter between the carrier and the consignee.
Ein wichtiger Punkt beim Kauf des Geräts Alto-Shaam 4.10ESi (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Alto-Shaam 4.10ESi noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Alto-Shaam 4.10ESi - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Alto-Shaam 4.10ESi reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Alto-Shaam 4.10ESi erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Alto-Shaam 4.10ESi besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Alto-Shaam 4.10ESi verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Alto-Shaam 4.10ESi. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Alto-Shaam 4.10ESi gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
