Benutzeranleitung / Produktwartung DVD-22T des Produzenten Farenheit Technologies
Zur Seite of 25
D VD -22/ D VD -22T Single-DIN A/V Multimedia Source Touch Sensor DVD/CD/MP3/MP4 AM/FM Radio Built-in TV tuner Owner’s Manual Take the time to read thro ugh this ow ner’s manual. Familiarity with installation and operati on pr ocedures will help you obtain the best Performance from your new DVD-receiver.
Page- 1 Table of Contents Table of Contents.......... .......................... ......................... ................................. ................ ..... .... 1 Important Safeguards ............. ............. ............. .................
Page -2 Important Safeguards z Using the device at temperature below -10 may cause the breakage of the device. BEFORE ℃ USING PLEASE HEAT UP TH E PASSENGER COMPARTMENT T O THE RECOMMENDED TEMPERATURE! z Read carefully through this manual to familiarize yourself with this high-qualit y sound system.
Page- 3 Accessories Package contains the following accessories for instal lation and operation of the unit. (1) W asher , S pring W asher , M5 Nut 1 each (2) Mounting S trap 1 (3) Screw (4) Bolt 1 4 (.
Page -4 Installation/Un-Installation First complete the electric al connections, and then check them for correctness. Installation This unit can be installed in any dashboard hav ing an opening as shown on the pic ture. The dashboard should be 4.75 – 5.
Page- 5 Wiring Connections Make sure you have good chassis ground. A good ground connection will eliminate most electrical noise problems. A good chassis ground requires a tight connection to the vehicle’s metal chassis.
Page -6 Caution: Do not interchange the connection of the wiring!!! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit.
Page- 7 Panel Controls 1. Power/Mute 2. BAND 3. PREVIOUS 4. VOL + 5. NEXT 6. DISP 7. AS/PS 8. LCD 9. IR sensor 10. OPEN 11.MODE. 12.OK 13.VOL- 14. PRESET 1/play pause 15. PRESET 2./RPT 16. PRESET 3./INT 17. PRESET 4/RDM 18. PRESET 5/STOP 19. PRESET 6/MENU 20.
Page -8 IR Remote Control REPLACIN G THE BATTERY Remote Control comes with a CR-2025 Lithium Battery included. 1. Remove the Battery Holder from the back of the Remote Control. 2. Insert a CR-2025 Lithium battery with the positive (+) mark upward. Insert the Battery Holder into the back of the Remote Control.
Page- 9 General Ope rations Reset the Unit In case the unit is malfunctioned or need to reset to factory default setting, press RESET button in inner panel then the unit will be reset. Power on/of f Press POWER key button to turn on the unit. Long press POWER key on front panel or press PO WER button on RC to power off the unit.
Page -10 Digital Tuner Band selection Press MODE button to select the RADIO mode. Press the BAND button to select the desired band: FM1=> FM2 => FM3 => AM1=>AM2 STEREO/MONO In FM mode, press SETREO /MONO button on remote control to select stereo or mono sound reception.
Page- 1 1 SD/MMC Cards & USB Operations USB Flas h Memory To play MP3/ MP4/ WMA files from a USB flash memory, insert a USB flash memory into the USB port on the right side of the unit. The unit will start playing MP3/MP4/ WMA files on the USB flash memory automatically.
Page -12 Repeat Press the RPT button on remote control or the panel for RPT1 (repeat the current playing file) => RPT ALL (repeat all folders) => RPT folder (repeat curr ent folder) => RPT OFF. Repeat A-B Functi on 1. Press A-B button on the r emote at the starting point of the section you want to repeat (point A).
Page- 13 Discs operations Glossary PBC (Play Back Control) Play Back Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image.
Page -14 Playing/pausing To ensure good system performance, wait until the unit f inishes reading the disc information before proceeding. Press the PLAY/ PAUSE button to start/ pause the playback. In pause mode press it again to resume the playback. Stop During playback press the STOP button on the RC or on the panel.
Page- 15 PBC (Playback Co ntrol) function (for VCD only) If you insert a VCD with PBC, playback starts fr om the beginning of the 1st track automatically. 1. Long press PBC/STOP button to activate interactive menu on screen during playback. 2. If the menu consists of titles, you can select a desired one using the digit 0-9 buttons.
Page -16 MP3 overview Notes on MP3: z MP3 is short for MPEG Audio Layer 3 and refers to an audio compression tec hnology standard. z This product allows playback of MP3 files on CD-ROM, CD-R or CD-RW discs. z The unit can read MP3 files written in the format compliant with ISO 9660.
Page- 17 Setup Menu • Press SETUP button to enter the system settings main menu; • Press cursor / buttons to move along icons on the t op navigation bar on settings main menu.
Page -18 Dolby settings Menu entry Dual mono With this menu item you can select the ty pe of Left and Right channel audio output. Stereo is normal Stereo, Mono L is all sound on the Left Audio output, Mono R is all sound on the Right channel. The “Mix Mono” function only works when a DVD is being played in DTS 5.
Page- 19 Preference settings Menu entry Function TV T ype This setting enables the selection of the appropriate TV standard. P A L is the customary standard in Europe. NTSC is the customary st andard in the US and Japan. Only select the MUL TI option if your TV can play back both formats.
Page -20 Note: If you have forgotten your changed password, you can set a new one at any time by entering the factory default password 1369 .. Factory default setti ngs (“RESET“) By using the reset function, the device can be changed back to the factory default settings.
Page- 21 Other Functions Subwoo fer Connect the subwoofer to the unit using sub output (see electrical diagram). Press SEL button, choose expert and set subwoof er ON to enable subwoofer. Anti-thef t system Remov e th e pane l 1. Press the PWR button to turn the power off .
Page -22 Note on Discs Only use groundless loudspeakers. Use only louds peakers of minimal 40 W att, using fewer watts may result in damaging your loud speakers at higher volumes. Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit.
Page- 23 T r oubleshooting guide Symptom Cause Solution General No power The car igniti on is not on. The fuse is blown. If the power supply is properly connected to the car accessory switch the ignition key to “ACC”. Replace the fuse. Disc Disc cannot be loaded.
Page -24 Specification General Power supply: 12 V DC Current consumption: max. 10 A Maximum power output: 40W x 4 channels Compatible forma ts: DVD/SVCD/VC D/HD CD/M P3/MP4/WMA/CDDA/Picture-CD/JPE G/ CD-R/ -RW/DVD±R/± RW playback Dimensions (W x D x H) / weight: 178 x 175 x 50 mm / 1.
Ein wichtiger Punkt beim Kauf des Geräts Farenheit Technologies DVD-22T (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Farenheit Technologies DVD-22T noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Farenheit Technologies DVD-22T - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Farenheit Technologies DVD-22T reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Farenheit Technologies DVD-22T erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Farenheit Technologies DVD-22T besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Farenheit Technologies DVD-22T verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Farenheit Technologies DVD-22T. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Farenheit Technologies DVD-22T gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
