Benutzeranleitung / Produktwartung 60830 des Produzenten Electrolux
Zur Seite of 52
FAVORIT 60830 Dishwasher User Instructions.
2 Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of thes e use r i nst ru ctio ns ! Please keep these us er ins tru cti ons for later reference. Pass them on to any subsequent owner o f the a ppl ia nce .
Contents 3 CONTENTS Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal . . . . . . . .
Contents 4 Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 Cleaning the Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 What to do, if ... .
Operating Instructions 5 OPERATING INSTRUCTIONS 1 Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law.
Operating Instructions 6 • Never place the dishwasher in ope ration if the mains cable, water inlet or drain hose is damaged; or the control panel, work top or plinth area is damaged such that the inside of the appliance is freely accessible.
Operating Instructions 7 • In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. 2 Disposal Disposing of the Pa ckaging Material Dispose of the dishwasher packaging material correctly.
Operating Instructions 8 Appliance Features and Control Panel Top Spray Arm Container for Salt Rating Plate Container for Rinse Aid Filters Rubber Seal for Connecting the Water Feed to the Spray Arm S.
Operating Instructions 9 Control Panel The control panel consists of the ON/OFF button and the programme buttons with LED displays. Function buttons: In addition to the stated wash programme the fol- lowing functions can also be set using these buttons: The Multi- Display can display, – the hardness setting to whic h the water softener is set.
Operating Instructions 10 Control Indicators have the following significance: 3 The [ indicator is intended to remind you to check the filters in the dishwasher from time to time and, if necessary, to clean it. The indica- tor illuminates at regular intervals, independent of the amount of soil- ing of the filters.
Operating Instructions 11 Setting the water softener To avoid scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft water, i.
Operating Instructions 12 Setting the water softener Using the table as a guide, adjust th e water softener to that which cor- responds to the hardness of the water in your area: 0 The dishwasher must be switched off. Manual setting: 1. Open the dishwasher door.
Operating Instructions 13 Special salt for the water softener 3 If the water hardness in your area is less than 4 °d, then the water in your dishwasher does not need to be softened and you do not need to use special salt or salt substitute.
Operating Instructions 14 3 If the water softener is electronically set at “1” for the purpose of using detergent that includes special salt, the special s alt indicator is deacti - vated.
Operating Instructions 15 Rinse Aid Rinse aid ensures thorough rinsing, spot and streak free drying of dishes and glassware. Rinse aid can be added in on e of two ways: • If you are using dishwasher detergent that already contains rinse aid, the detergent including the rinse aid is put into the dete rgent compartment.
Operating Instructions 16 The multi-display will indicate the current setting: 4. Pressing function button 2 changes the setting. 5. Once the multi-display is indicating the required setting, press the ON/OFF button.
Operating Instructions 17 4. Fill with rinse aid exactly up to the level marked “max”; this corresponds to a quantity of approx. 140 ml. 5. Close the lid and press until it locks into place. 6. Wipe up any spilt rinse aid with a cloth. Otherwise too much foam will be formed during the wash.
Operating Instructions 18 In Daily Use • Check the salt and rinse aid leve ls. • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable.
Operating Instructions 19 – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery 1 Long bladed knives stored in an up right position are a potential hazard . 1 Long and/or sharp items of cutlery su ch as carving knives must be posi- tioned horizontally in the upper basket.
Operating Instructions 20 On some models of dishwasher it is possible to open the cutlery basket. 1 To ensure that the cutlery basket cannot open on removal from the appliance, you should always hold both parts of the two part handle. 0 1. Place the cutlery basket on a table or work surface 2.
Operating Instructions 21 Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower basket (Plates up to 29cm in diameter).
Operating Instructions 22 Type 3: The right-hand plate inserts in the lower basket can be folded across one another 3 To ease the loading of large items, the two right-hand plate inserts in the lower basket can be folded across one another.
Operating Instructions 23 Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper basket. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items.
Operating Instructions 24 Adjusting the Height of the Upper Basket 3 The height of the basket can also be adjusted when it is loaded. Lowering the Upper Basket: 0 1. Pull the upper basket out completely. 2. Holding the upper basket at the rear right, lift it as far as it will go and then lower it vertically.
Operating Instructions 25 Filling with Detergent 1 Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme).
Operating Instructions 26 Use of "3 in 1"/ Co mbi Detergent Tablets General Advice These products are tablets with combined detergent/rinse-aid and salt functions.
Operating Instructions 27 Concentrated Detergent Based on their chemical compositio n, dishwasher detergents can be split into two basic types: – conventional , alkaline detergents with caustic components –l o w a l k a l i n e concentrated detergents with natural enzymes.
Operating Instructions 28 Selecting the Wash Progr amme (Programme Table) Choose the most suitable wash program me with the aid of this table: Type of Dishes Dinner Service and Cooking Ute nsils Dishe.
Operating Instructions 29 Type of Dishes Dinner Service and Cooking Utensils Dessert Dishes and Coffee Service All Types of Di shes In Addition w ith non-temperature re sist- ant dishes with delicate .
Operating Instructions 30 Starting a programme 0 1. Check that the dishes and cutlery are stacked in the dish washer in such a way that the spray arms are free to rotate. 2. Turn on the water tap fully. 3. Close the door. 4. Press the ON/OFF button. The LED in the ON/OFF button will illuminate.
Operating Instructions 31 Interrupting the programme by opening the dishwasher door 1 Hot steam may escape when the door is opened. There is a risk of scald- ing. Open the door carefully. 0 1. Open the door of the dishwasher. The programme will stop. 2.
Operating Instructions 32 5. Press the relevant button for the cycle required (see ”Cycle Table”). The selected cycle will begin after approximately 3 seconds. The function can no lon ger be chan ged after the cycle has begun. In this case the dishwashing cycle mu st be aborted by pressing RESET, and must then be reselected.
Operating Instructions 33 Changing the programme after the start delay has been set: As long as the programme has not started, you can still change the start delay set by pressing a programme button. 0 1. Press the button for the new programme and hold it down.
Operating Instructions 34 Care and Cleaning 1 Do not under any circumstances use fu rniture care products or aggres- sive cleaners. • If necessary, clean the controls only with a soft cloth and pure warm water. • O ccasionally check the internal cont ainers, door seal, and water inlet for soiling, clean if necessary.
Operating Instructions 35 7. Put the flat filter back in the base of the washing compartment 8. Place the coarse/fine filter in the microfilter and press together. 9. Put the filter combination in place and lock by turning the handle clock- wise to the stop.
Operating Instructions 36 What to do, if ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.
Operating Instructions 37 After remedying the FILTER error, shut the door. After rectifying an Å1 0 or Å2 0 error, press the button for the pro- gramme that has been started. The programme will continue. If the fault is displayed again, please contact Service force.
Operating Instructions 38 ...there are problems with th e operation of the dish- washer. ...the wash results are not satisfactory. The dishes are still dirty. – The wrong wash programme was selected. – The dishes were loaded is such a way that the wash waster did not reach all items.
Operating Instructions 39 There are streaks, milky spots or a bluish coating on glasses and dishes. – Lower rinse aid dosing. There are dried water drops on the glasses and dishes. – Increase rinse aid dosing. – The detergent may be the cause. Contact the detergent manufac- turer’s customer advisor.
Operating Instructions 40 Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table).
Installation and Connection Instru ctions 41 INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level.
Installation and Connectio n Instructions 42 If the dishwasher is installed underneath a kitchen work surface, the original work surface of the dishwa sher is to be removed as follows: 0 1. Unscrew the screws from the posi- tioning plates on the back (1).
Installation and Connection Instru ctions 43 Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations.
Installation and Connectio n Instructions 44 3 The following section is only applicable to dishwashers that have a safety valve on the threaded hose fitting for the tap: Water inlet hose with safety valve After connecting the double-walled wate r inlet hose, the safety valve is next to the tap.
Installation and Connection Instru ctions 45 Water drain Drain hose 1 The drain hose must not be kinked, crushed or entangled. • Connecting the drain hose : – Maximum permitted height: 1 metre. – Minimum required height 40 cm above the lower edge of the machine.
Installation and Connectio n Instructions 46 Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve in the appliance immediately interrupts the in flow of water and th e drain pump is activated.
Installation and Connection Instru ctions 47 Electrical Connection Any electrical work required to inst all this appliance should be car- ried out by a qualified elec tr ician or competent person. 1 WARNING - This appliance must be earthed. The manufacturer declines any resp onsibility should these safety measures not be observed.
Installation and Connectio n Instructions 48 Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installa tion example given below can only be regarded as a recommendation.
Guarantee Conditions 49 GUARANTEE CONDITIONS Standard guaran tee conditions We, AEG, undertake that if within 12 mont hs of the dat e of the purchase this AE G appliance or any part thereof is proved .
50.
Service and Spare parts 51 SERVICE AND SPARE PARTS In the event of your appliance requir ing service, or if you wish to pur- chase spare parts, please contac t Service Force by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area.
From the El ectrolu x Group . The world´s No.1 choice. The Electrolux Gr oup is the world´s largest producer of po wered ap pliances for ki tchen, cleaning and outdoor use.
Ein wichtiger Punkt beim Kauf des Geräts Electrolux 60830 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Electrolux 60830 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Electrolux 60830 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Electrolux 60830 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Electrolux 60830 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Electrolux 60830 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Electrolux 60830 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Electrolux 60830. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Electrolux 60830 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
