Benutzeranleitung / Produktwartung 318 200 635 (0606) Rev. A des Produzenten Electrolux
Zur Seite of 26
3 18 200 635 (0606) Rev . A Dishwasher Use & Care Guide Electric Cooktop.
2 Finding Information MAKE A RECORD FOR FUTURE USE Brand_______________________________________________________________ Purchase Date______________________________________________________ Model Number.
3 Finding Information TABLE OF CONTENTS Finding Information .......................................... 2-3 Make a Record for Future use ................................. 2 Questions? ............................................................... 2 Safety .
4 Safety IMPORT ANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Save these instructions for future reference. • Remove all tape and packaging wrap before using the appliance. Destroy the carton and plastic bags after unpacking the appliance.
5 Safety • Do not leave children alone. Children should not be left alone or unattended in the area where an appliance is in use. They should never be allowed to sit or stand on any part of the appliance. • DO NOT TOUCH SURF ACE UNITS OR AREAS NEAR THESE UNITS.
6 Safety • Utensil Handles Should Be Turned Inward and Not Extend Over Adjacent Surface Units . To reduce the risk of burns, ignition of flammable materials, and spillage due to unintentional contact with the utensil. • Never Leave Surface Units Unattended.
7 COOKT OP FEA TURES CA CA CA CA CA UTION UTION UTION UTION UTION The Cooking Zones may appear to be cool while turned ON and after they have been turned OFF. The glass surface may be HOT form residual heat transfered from the cookware and burns may occur.
8 6. Left Rear Element Control Pads 7. Left Front Element Control Pads 8. Right Rear Element Control Pads 9. Right Front Element Control Pads 10. Main Cooktop Controls 1 1. Center Front Element Control Pads (36” model only) 12. Cooktop Power Key Pad 13.
9 Setting Surface Controls ABOUT THE CERAMIC GLASS COOKTOP The ceramic cooktop has radiant surface elements located below the surface of the glass. The design of the ceramic cooktop outlines the area of the surface element underneath. Make sure the diameter of the pan matches the diameter of the element outline on the cooktop (See Figs.
10 Setting Surface Controls LOCA TIONS OF THE SURF ACE RADIANT ELEMENTS Your cooktop is equipped with radiant surface burners with different wattage ratings. The ability to heat food quicker and in larger volumes increases as the element wattage increases.
11 LED MESSAGES OR LIGHT INDICA TORS DISPLA YED BY MAIN CONTROL CONTROLS LOCK - This feature allows the cooktop to be locked at anytime. T ouch and hold the LOCK key pad for few seconds. If the cooktop is in use it will automati- cally shut off the cooktop to enter in the lock mode.
12 Setting Surface Controls The available ESEC Window Display Settings The ESEC control will display heat levels ranging from Hi (Figure 1) to Lo (Figure 6) and OFF (Figure 7). The settings between 9.0 (Figure 2) and 3.0 (Figure 3) decrease or increase in increment of .
13 Setting Surface Controls OPERA TING THE SINGLE SURF ACE RADIANT ELEMENTS CA CA CA CA CA UTION UTION UTION UTION UTION Radiant surface elements may appear to have cooled after they have been turned OFF. HE (Hot Element) message will turn ON and will continue to glow until the glass cooktop has cooled down to a moderate level.
14 Setting Surface Controls OPERA TING THE DUAL SURF ACE RADIANT ELEMENT Both the 30” and 36” cooktops are equipped with dual radiant surface element located as shown in Figs. 1 & 2. A touch key pad on the element controls is used to select one of the 2 positions of the element.
15 Setting Surface Controls OPERA TING THE TRIPLE SURF ACE RADIANT ELEMENT Both the 30” and 36” cooktops are equipped with “Triple” surface radiant elements located as shown in Figs. 1 & 2. A touch key pad on the element controls is used to select one of the 3 positions of the element.
16 Setting Surface Controls KEEP W ARM FEA TURE The Warm feature may be used with any of the Cooking Elements. To Turn the Keep Warm Feature ON: 1. To select the Keep Warm feature for any Cooking Element touch the On/Off key pad for the corresponding Cooking Element.
17 LOCKING THE CONTROLS Setting Surface Controls When the Sabbath feature is ON, all electronic surface element control displays show “ Sb ” (Fig. 1).
18 Setting Surface Controls SURF ACE COOKING UTENSILS POOR.
19 CARE & CLEANING TABLE General Care & Cleaning Surfaces Aluminum & Vinyl Painted and Plastic Control Knobs Stainless Steel , Chrome Control Panel, Decorative Trim How to Clean Use hot, soapy water and a cloth. Dry with a clean cloth. Using a soft cloth, clean with mild dish detergent and water or a 50/50 solution of vinegar and water.
20 Consistent and proper cleaning is essential to maintaining your ceramic glass cooktop CA CA CA CA CA UTION UTION UTION UTION UTION Before cleaning the cooktop, be sure the controls are turned to OFF and the cooktop is COOL. WARNING WARNING WARNING WARNING WARNING DO NOT use a cooktop cleaner on a hot cooktop.
21 General Care & Cleaning CLEANING RECOMMENDA TIONS FOR THE CERAMIC GLASS COOKTOP (CONTINUED) Plastic or foods with a high sugar content: These types of soils must be removed immediately if spilled or melted onto the ceramic cooktop surface. Permanent damage (such as pitting of the cooktop surface) may occur if not removed immediately .
22 Solutions to Common Problems ENTIRE COOKT OP DOES NOT OPERA TE • House fuse has blown or circuit breaker has tripped. Check/reset breaker or replace fuse. If the problem is a circuit overload, have this situation corrected by a qualified electrician.
23 Solutions to Common Problems FOOD NOT HEA TING EVENL Y • Improper cookware. Select flat-bottomed cookware of a proper size to fit element. • Incorrect control setting. Raise or lower setting until proper amount of heat is obtained. POOR COOKING RESUL TS • Many factors affect cooking result s.
24 Solutions to Common Problems BROWN STREAKS AND SPECKS ON CERAMIC GLASS COOKTOP SURF ACE • Boilovers have cooked onto surface. Use razor blade scraper to remove soil. See instructions under General Care & Cleaning. • Cleaning materials not recommended for ceramic-glass cooktop have been used.
25 Notes.
26 W arranty Information COOKTOP W ARRANTY Y our cooktop is protected by this warranty In the U.S.A. , your appliance is warranted by Electrolux Home Products North America, a division of White Consolidated Industries, Inc. We authorize no person to change or add to any of our obligations under this warranty .
Ein wichtiger Punkt beim Kauf des Geräts Electrolux 318 200 635 (0606) Rev. A (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Electrolux 318 200 635 (0606) Rev. A noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Electrolux 318 200 635 (0606) Rev. A - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Electrolux 318 200 635 (0606) Rev. A reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Electrolux 318 200 635 (0606) Rev. A erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Electrolux 318 200 635 (0606) Rev. A besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Electrolux 318 200 635 (0606) Rev. A verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Electrolux 318 200 635 (0606) Rev. A. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Electrolux 318 200 635 (0606) Rev. A gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
