Benutzeranleitung / Produktwartung 413 des Produzenten Directed Electronics
Zur Seite of 28
Model 413 Remote Start Owner’ s Guide © 2009 Directed Electronics, Vista, CA G4103P 2009-07.
.
i © 2009 Directed Electronics. All rights reserved. Contents Government Regulations .................................................................................... ii W arning! Safety first .......................................................
ii © 2009 Directed Electronics. All rights reserved. Government Regulations This device complies with Par t 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device ma.
iii © 2009 Directed Electronics. All rights reserved. W arning! Safety first The following safety warnings must be obser ved at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer .
iv © 2009 Directed Electronics. All rights reserved. to have him or her test the remote star t module by per forming the Safety Check outlined in the product installation guide. If the vehicle star ts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed.
1 © 2009 Directed Electronics. All rights reserved. What is Included The control module • An HX Plus receiver/antenna • T wo 4 - button remote controls (P/N 474P) • A push-button V alet switch .
2 © 2009 Directed Electronics. All rights reserved. Remote Control Functions The receiver uses a computer-based learn routine to learn the remote control buttons.
3 © 2009 Directed Electronics. All rights reserved. Using Y our System ➢ Locking Pressing for one second locks the system. (if the door locks are con- nected). The horn honks (if connected) and the parking lights flash once to confirm locking of the system.
4 © 2009 Directed Electronics. All rights reserved. ➢ Panic Mode If you are threatened in or near your vehicle, you can attract attention by trig ger ing the system with your remote control. Press for 1.5 seconds to enter Panic Mode.
5 © 2009 Directed Electronics. All rights reserved. When you are ready to drive the vehicle: Insert the ignition key and tur n i t to the ON ( no t th e ST AR T) 1. po sition. Press the brake pedal. The remote star t system shuts down and the 2. motor continues to run because the ignition has been turned on.
6 © 2009 Directed Electronics. All rights reserved. T o turn the rear defogger On: Simultaneously press & release the 1. + + buttons on the remote control. The lights flash 3 times. 2. The rear defogger activates when the vehicle is remote started.
7 © 2009 Directed Electronics. All rights reserved. ➢ Car finder Car finder allows you to locate your vehicle, by having the system flash the parking lights on your vehicle.. T o activate: Press and release the 1. and buttons at the same time.
8 © 2009 Directed Electronics. All rights reserved. ➢ Starter Anti-Grind Circuitry Whenever the vehicle is remote star ted, advanced anti-grind circuitr y prevents the star ter from engaging, even if the key is tur ned to the star t position.
9 © 2009 Directed Electronics. All rights reserved. ➢ Ignition Controlled Door Locks If power door locks have been connected to your system, the vehicle's doors will lock three seconds after the ignition has been turned On and unlock when the ignition is turned Off.
10 © 2009 Directed Electronics. All rights reserved. Rapid Resume Logic This Directed Electronics system will store its current state to non-volatile memor y . If power is lost and then reconnected the system will recall the stored state from memor y .
11 © 2009 Directed Electronics. All rights reserved. Programming Options Programming options control your system's normal, operational set- up. Mos t opt ions do no t requir e addit ion al parts, bu t som e may require ad- ditional installation labor .
12 © 2009 Directed Electronics. All rights reserved. Glossar y of T erms Control Unit: The “brain” of your system. Usually hidden under neath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all system functions.
13 © 2009 Directed Electronics. All rights reserved. Convenience Expansions Listed below are some of the many expansion options available for use with your system. Some options may require additional par ts and/ or labor . Please consult with your dealer for a complete list of options available for use with this system.
.
15 © 2009 Directed Electronics. All rights reserved. Quick Reference Guide T o lock using your remote T o lock the system press • for one second. The doors lock (if con- nected). The ve hi cle’ s horn (if connected) honks and the parking lights flash once to confirm locking.
16 © 2009 Directed Electronics. All rights reserved. T o disable the remote start system T o disable the remote star t, move the shutdown toggle switch to • the OFF position. Location of Shutdown Switch____________________________ V alet T akeover Press and release • on the remote control one time while the vehicle is running.
17 © 2009 Directed Electronics. All rights reserved. Limited Lifetime Consumer W arranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’.
18 © 2009 Directed Electronics. All rights reserved. W ARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOV AL OR REINST ALLA TION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOL VING DIRECTED OR ITS SUBSIDIARY , THE VENUE SHALL BE SAN DIEGO COUNTY IN THE ST A TE OF CALIFORNIA.
19 © 2009 Directed Electronics. All rights reserved. Notes.
20 © 2009 Directed Electronics. All rights reserved. Notes.
.
G4103P 2009-07 Vista, CA 92081 www .directed.com © 2009 Directed Electronics—All rights reser ved The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available.
Ein wichtiger Punkt beim Kauf des Geräts Directed Electronics 413 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Directed Electronics 413 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Directed Electronics 413 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Directed Electronics 413 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Directed Electronics 413 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Directed Electronics 413 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Directed Electronics 413 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Directed Electronics 413. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Directed Electronics 413 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
