Benutzeranleitung / Produktwartung Cobra 25 NW ST des Produzenten Cobra Electronics
Zur Seite of 22
Ho w to Us e Y ou r Co b r a 25 NW ST Contents Features ...........................................................................................1 The CB Stor y ..................................................................................A1 FCC Regulations FCC W arnings Included Accessories Controls & Indicators .
Installation Installation Location 3 2 Mounting and Connection Mounting and Connection H old the radio with the mounting bracket in the exact desired lo cation. If there is no in ter- ference , remov e the bracket and use it as a template to mark the lo ca tion for the moun t- ing screws.
Installation Installation 5 4 Note Before installing the CB radio , visually check the vehicle’ s battery connection to deter - mine which terminal, positive or negative, is grounded (pos- itive is the larger of the t wo) to the engine block (or chas - sis).
Ignition Noise Interference Antennas U se of a mobile receiver at low signal le vels is normally limited by the presence of electrical noise. The primary sour ce of noise in automobiles is from the alterna tor and ignition system. T ypically , when signal le vel is adequa te, the back- ground noise does not present a serious problem.
T he CB/PA button should be in the CB position. Operation 9 Operation T urning On Setting Channel Selector 8 T urning On Make sure the p ow er cor d, antenna and micro- phone are connec ted to their proper connec tors before starting.
Rotat e the On/Off V olume knob clockwise the green RT/TX LED will be illiumina ted. Operation 11 Operation 10 S-Meter S-Meter Swings proportionately to strength of incoming signal when receiving.
Operation Operation 13 12 Activating SoundTracker ™ Push and release the ST button. R ed LED is illuminated when SoundTracker™ is turned on. 1 The SoundT rack e r TM System While previous systems .
Operation Operation 15 14 RF Gain Control Dimmer Control RF Gain Control T he RF Gain is used to optimize reception in strong or weak signal areas . Dimmer Control Note The RF Gain is used to optimiz e reception in weak signal areas . Rotate the DIM knob clockwise for maximum brightness; counter-clockwise for minimum.
T o achie v e the Desired Squelch Setting (DSS), turn the Squelch control counterclockwise until you hear noise . Now turn the control clockwise just until the noise stops .
Setting Dynamike This controls the microphone sensitivit y (outgoing audio le vel). 19 18 Setting Dynamike Operation Operation 1 Initially , set fully clockwise so that maxi - mum voice volume is a vailable. Dynamike may hav e to be reduced in some conditions .
Set CB PA switch to PA position. 2 21 20 Operation Operation External Speaker External Speaker The external S peaker jack is used for remot e receiver monitoring . Note The external speaker should have 8-ohm impedance and b e r ated to handle at least 4.
Operation Operation 23 22 Push and hold microphone button and speak in a normal voic e . Y our voice will sound on the P A speaker . Adjust P A speaker volume with the Dynamike control. 3 4 ANL (Automatic Noise Limiter) Switch ANL (Automatic Noise Limiter) Switch When switched t o ANL the Automatic Noise Limiter is activ ated.
Home And Office Set-Up T emporary Mobile Set-Up 25 24 T emporar y Mobile Set-Up T emporary Mobile Operation F or temporary mobile oper ation you may want t o purchase an optional cigarette ligh ter adapter from your COBRA dealer. This adapter and a mag - netic mount an t enna allow you to quickly “install” your transceiver for temporary use .
How Y our CB Can Serve Y ou 27 Home And Office Set-Up 26 C onnect properly installed and ma tched base station antenna. Plug pow er cable in t o back of unit mar k ed “Pow er ” . Be sure to obser ve polarity mar kings. 2 3 1. Set to channel 9 for emergencies Be sure an t enna is properly connec ted.
How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 29 28 T he FCC gives these examples of permitted and prohibited messages for channel 9. These are only guidelines and not all-inclusive: P ermitted Example Message Y es “ T ornado sight ed six miles north of town.
Frequency Ranges How Y our CB Can Serve Y ou 31 30 Code Meaning 10-29 Time is up for contac t 10-30 Does not conform to FCC rules 10-33 Emergency traffic 10-34 Trouble at this station 10-35 Confidenti.
Limited Two Y ear W arranty 25 NW ST Specifications 33 32 GENERAL CHANNELS. . . . . . . . . . . . . . . . . . . . . . . CB - 40 CH FREQUENCY RANGE. . . . . . . . . . . . . . . CB - 26.965 T O 27.405 MHZ FREQUENCY T OLERANCE. . . . . . . . . . 0.005 % FREQUENCY CONTROL .
Y ou Can Find These Fine Accessories A t Y our Local C obra CB Dealer If you wish, you can order directly from Cobra. Order by phone Call 1.773.889.3087 (Pr ess 1 from the main menu) 8 a.m.-8 p.m. M-F CST . Order by mail or fax Please fill out order form on ne xt page, and mail/fax directly to Cobra.
Accessory Order Form 36 Tax Table Illinois residents add 7% Cook Co. residents add .75% (7.75% total) Chicago residents add 1% (8.75% total) Indiana residents add 5% For credit card orders fill out order for m and fax to: 1.773.622.2269 or call 1.773.
2 5 N W S T Cobra Electronics Corporation 6500 W est Cortland Street Chicago, IL60707 Cobra Electronics Corp.© 1999 Printed in China Part No. 480-205-P-001 CB Radio “Ing eniou s Pr o d u c ts for E as ier C o m m u n i c a t i o n .
The Citizens Band lies bet w een the shor tw a ve broadcast and 10-meter Ama teur radio bands , and was established by law in 1949. The Class D two-w ay communica tions service was opened in 1959.(CB also includes a Class A citizens band and Class C remote control frequencies.
T hank you for purchasing the Cobra 25 NW ST CB Radio. Properly used, this Cobra product will giv e y ou many years of reliable servic e. SoundT racke r TM “C uts noise coming in...strengthens signals going out.” This P atent pending technolog y dramatically improv es transmission and reception of CB signals.
Ein wichtiger Punkt beim Kauf des Geräts Cobra Electronics Cobra 25 NW ST (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Cobra Electronics Cobra 25 NW ST noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Cobra Electronics Cobra 25 NW ST - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Cobra Electronics Cobra 25 NW ST reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Cobra Electronics Cobra 25 NW ST erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Cobra Electronics Cobra 25 NW ST besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Cobra Electronics Cobra 25 NW ST verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Cobra Electronics Cobra 25 NW ST. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Cobra Electronics Cobra 25 NW ST gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
