Benutzeranleitung / Produktwartung 463240804 des Produzenten Char-Broil
Zur Seite of 28
463240804 • 80000327 • 10-16-03.
2 • 463240804 FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2. An LP t ank not connected for use shall not be stored in the vicinity of this or any other appliance.
T ABLE OF CONTENTS W ARRANTY For Y our Safety ......................................2 Grill Service Center ...................................2 Product Record Information ............................2 Installation Safety Precautions ..................
P ARTS LIST – Model No. 463240804 Key Qty Description Part # 1 Grill Lid Assembly ............... 80000301 A 1 Lid Insert ........................ 80000302 B 1 Lid End Cap - Left ................ 80000303 C 1 Lid End Cap - Right ............... 80000304 D 1 Lid Handle .
P ARTS DIAGRAM – Model No. 463240804 463240804 • 5 A B C D E F G H I J K K K L M N O P P Q R S T U V W X Y Z AA AA AA AA BB CC DD EE FF HH II JJ KK KK LL LL MM NN OO PP QQ P RR SS TT UU GG.
ASSEMBL Y – Model No. 463240804 1 2 Rear view Door brace First 4.2X10mm , remove door brace from rear legs. Place door brace onto front legs as shown. T abs on brace fit inside legs. Secure brace to back of front legs using one self-tap screw on each side.
3 4 This step requires two people to lift and position grill head onto cart. Carefully lower the grill head onto the cart between the two braces. Align the two holes on each side of the grill head with the two holes on each brace. Make sure the regulator hose is hanging outside the cart.
5 6 Place side shelf over right cart legs. Lip of shelf should fit between grill bottom and leg brace. Secure shelf brackets to cart legs using one screw , lock washer , and flat washer on each bracket. 1/4-20x3/4” (XX) 7mm (YY) 7mm (ZZ) YY ZZ Repeat on front bracket Place sideburner shelf over left cart legs.
7 8 Remove the two screws (M4x10mm) and washers (4mm) from the sideburner valve bracket. Place sideburner valve under front of sideburner control panel so that valve stem comes through large hole. Place sideburner bezel over valve stem. Secure bezel to panel and valve using the two screws and washers you removed from the valve bracket.
9 10 Insert valve clip into small hole in bottom of burner , then snap other end of clip over sideburner valve. Beneath sideburner shelf, attach sideburner ignitor wire to electrode. Place brass top on sideburner , then place sideburner grate onto shelf.
11 12 T o assemble SwingAway , first insert pivot wire into holes in side of grill lid. Second, insert leg wires into holes in sides of grill bottom. Insert bottom door pin into hole in bottom shelf. Press the top door pin down, align with hole in door brace, release door pin.
13 14 Slide condiment baskets into brackets on back of both doors. Smaller basket on left door, larger basket on right door. Hang the match-lighting stick and chain from the small hook on the right side panel.
15 16 Slide grease tray into back of grill. Place grease cup into grease clip. Hang grease clip from bottom of grease tray . • Failure to install can in clip will cause hot grease to drip from bottom of grill with risk of fire or property damage.
17 18 See Use & Care manual to perform the “Burner Flame Check” and for important safety instructions before using. Tank valve facing front. Tank valve must face to front of cart once tank is attached. Failure to install tank correctly may allow gas hose to be damaged in operation, resulting in the risk of fire.
463240804 • 15 19 Unscrew ignitor cap and place AA battery into ignitor slot with positive end (+) facing outward. Screw ignitor cap onto ignitor . + – AA Battery.
16 • 463240804 D ANGER USE AND CARE • Never fill the cylinder beyond 80% full. An overfilled spare LP tank is hazardous due to possible gas released from the safety relief valve. • The safety relief valve on the LP tank could activate, releasing gas, and cause an intense fire with risk of property damage, serious injury or death.
463240804 • 17 WARNING If “growing” bubbles appear do not use or move the LP tank. Contact an LP gas supplier or your fire department! Connecting Regulator To The LP Tank 1. 2. 3. full stop 4. LP tank must be properly secured onto grill. (Refer to assembly section.
18 • 463240804 6. An additional one-half to three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools. NOTE: do not use this regulator! T urn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP tank valve, resulting in some resistance.
463240804 • 19 WARNING Safety Tips s s s s s s s s s s Before opening LP tank valve, check the coupling nut for tightness. When grill is not in use, turn off all control knobs and LP tank valve. Never move grill while in operation or still hot. Use long-handled barbecue utensils and oven mitts to avoid burns and splatters.
20 • 463240804 CA UTION If burner does not light, turn knobs to , wait 5 minutes, and try again. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury. OFF Burner Flame Check • Remove cooking grates.
463240804 • 21 CA UTION FACT: Sometimes spiders and other small insects climb into the burner tubes attached to the burners. The spiders spin webs, build nests and lay eggs. The webs or nests can be very small, but they are very strong and can block the flow of gas.
22 • 463240804 Indirect Cooking Indirect Cooking Instructions Poultry and large cuts of meat cook slowly to perfection on the grill by indirect heat. The heat from selected burners circulates gently throughout the grill, cooking meat or poultry without the touch of a direct flame.
463240804 • 23 Troubleshooting Problem Burner(s) will not light using ignitor . Burner(s) will not match light. Sudden drop in gas flow or low flame. Flames blow out. Flare-up. Persistent grease fire. Flashback... (fire in burner tube(s)). Unable to fill LP tank.
24 • 463240804 Troubleshooting - Electronic Ignition Problem No sparks appear at any electrodes when ignition button is pushed; no noise can be heard from spark module. No sparks appear at any electrodes when ignition switch is pushed; noise can be heard from spark module.
463240804 • 25.
26 • 463240804.
463240804 • 27.
A Division of W .C. Bradley Co. • Columbus, GA 31902.
Ein wichtiger Punkt beim Kauf des Geräts Char-Broil 463240804 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Char-Broil 463240804 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Char-Broil 463240804 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Char-Broil 463240804 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Char-Broil 463240804 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Char-Broil 463240804 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Char-Broil 463240804 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Char-Broil 463240804. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Char-Broil 463240804 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
