Benutzeranleitung / Produktwartung PM-1016AA des Produzenten Century
Zur Seite of 40
Instruction Manual English PM-1304AA 6/99 Do not use this product until you read and understand these instructions. limited DEDICA TED TO QUALITY.
IMPORT ANT INFORMA TION If you should have any problems with this product, call toll-free 1-800-837-4044 fr om anywhere in the U.S. or Canada or fax at 1-610-286-4555. Or write us at: Century Products P .O. Box 100 Elverson, P A. 19520-9974 Attention: Customer Service Department Please have the following information available.
Failure to follow all warnings and instructions could result in serious injury or death. • Never leave child unattended, even when sleeping. - Child may become entangled in harness straps and suffocate. - Stroller may roll away and crash even with brakes engaged.
1 Hold swivel wheel assembly upright ( Ta b pointing down). 2 Tilt stroller slightly back and push wheel assembly onto leg until it locks in place. Repeat steps 1 and 2 for opposite leg. CAUTION: After wheel assembly is complete, pull on wheels to check that they are locked in place.
4 ASSEMBL Y continued W ARNING Prevent a possible choking hazard, discard axle protectors and polybag which contained rear wheel parts. CAUTION: • Failure to install retainer cap may cause wheels to come off of stroller . • After wheel assembly is complete, pull on wheels to check that they are locked into place.
1 Set both rear brakes to prevent stroller from moving. 2 Position child’ s tray in up position: • Rotate child’ s tray over lower edge of seat. • Push child’ s tray into slots. • Pull on child’ s tray to be sure it is securely locked . 1 LOCKING : Push down on both brake levers.
6 Pull up on car seat to be sure it is locked in child’ s tray . NOTE: Car seat comes with a level indicator which is not applicable when car seat is used in stroller frame. 1 Set both rear brakes to prevent stroller from moving. 2 Be sure handle is locked in upright carrying position.
1 LOCKING : Push down on both brake levers. 2 UNLOCKING : Push up on both brake levers. Stroller may be used with Arm Bar up or down. 1 For up position: • Rotate arm bar over lower edge of seat. • Push arm bar into slots. • Pull on arm bar to be sure it is securely locked .
STROLLER USE continued W ARNING Avoid serious injury from falling or sliding out: • Always use waist and tummy pad to restrain child, even when sleeping. • T o prevent child from standing or sliding out of stroller , be sure waist and tummy pad are SNUG and do not slip loose.
IMPORT ANT : • When folding stroller , turn stroller front wheels to straddle frame. • DO NOT allow front wheels to rest on frame. Doing so will cause wheels to warp and they will not roll correctly . 6 Engage latch on side of stroller to retain stroller in locked position.
10 MAINTENANCE T o remove cup holder , pull one end up, rotate over to opposite side and pull other end up. W ash cup holder in warm water and mild soap. DO NOT USE abrasives, solvents, strong detergents, or household cleaners: they can weaken plastic.
A. Front Wheel Assembly US $ 11.00 x _____ = $ ______ (11-93X) B. Rear Wheel Kit Including US $ 5.00 x _____ = $ ______ Retainer and Cap (11-93X) C. Hub Cap Set (2) (11-93X) US $ 1.00 x _____ = $ ______ D. Seat Pad (11-93X) US $ 16.00 x _____ = $ ______ E.
Cardholder’ s Name: Card Number: Card Exp. Date: Check enclosed for $ SHIP TO: Name: Address: City: State: Zip: T elephone No.:( ) Please make checks payable in U.
.
Remember W e are here to help you! For immediate help, call our Customer Service Department at 1-800-837-4044 from anywhere in the U.S. or Canada or fax at 1-610-286-4555.
Visit us at our W eb site: www .centuryproducts.com .
Instruction Manual Para instrucciones en Español, llamar al: 1-800-837-4044 A void injur y or death - Read and understand this manual! Use rear-facing only!.
T ABLE OF CONTENTS Important Information..................................... 1 W arnings......................................................... 2 Basic Information............................................ . 4 V ehicle Seat Belts.................
IMPORT ANT INFORMA TION No car seat can guarantee protection fr om injury in every situation, but proper use helps reduce the risk of serious injury or death. Child restraints (car seats) could be recalled for safety reasons. Y ou must register this restraint to be reached in a recall.
W ARNINGS DO NOT use rear-facing child restraint in a vehicle seating position equipped with an air bag. Child’ s head and neck may be seriously injured when an inflating air bag hits back of child restraint. Never put a car seat in a front vehicle seat unless recommended by vehicle owner’ s manual.
3 DO NOT use car seat if it is damaged or missing parts. DO NOT use accessories or parts supplied by other manufacturers. Their use could alter the performance of the car seat and cause serious injury or death. Car seat must be properly leveled: • T oo reclined can result in injury or ejection.
DO NOT use after date shown on back of car seat due to changing requirements and normal wear and tear . Look for: BASIC INFORMA TION This car seat meets or exceeds all applicable requirements of Federal Motor V ehicle Safety Standard 213 for use in motor vehicles and aircraft.
This car seat is designed for rear-facing use only by an infant whose: • W eight is less than 20 lbs. (9 kg) and; • Height is 27 inches (69 cm) or less HEIGHT & WEIGHT LIMITS A preterm or low birth weight infant may be at special risk in a vehicle or aircraft.
Place base rear-facing on vehicle seat. Thread vehicle lap belt through base belt T abs and buckle belt. NOTE: V ehicle shoulder belt must NOT be placed under belt T abs . Press down firmly on base to compress vehicle seat cushion while tightening vehicle lap belt (fig.
Place car seat rear-facing on vehicle seat. Thread vehicle lap belt through car seat Slots and buckle belt. NOTE: V ehicle shoulder belt must NOT be placed through car seat Slots . Press down firmly on car seat to compress vehicle seat cushion while tightening vehicle lap belt (fig.
Place child in car seat with child’ s back flat against back of car seat. Place harness straps over child’ s shoulders and lock buckle. Pull up on buckle to be sure it is locked. Close harness tie: • Position harness tie at mid-chest, about 3 inches (8 cm) below child’ s chin.
9 2 3 2 3 3-Point Models 5-Point Models (fig. a) (fig. b).
Buckle: 3-Point Models • T o buckle: Push buckle down on tongue. Pull up on buckle to be sure it is locked. • T o unbuckle: Press red button and pull buckle off tongue. 5-Point Models • T o buckle: Insert both tongues into buckle. Pull up on tongues to be sure they are locked.
11 3-Point Models (fig. a) (fig. b) 5-Point Models (fig. c) Handle Foot 1 2 3 4 5 1 2 3 4 5.
OPERA TIONS and ADJUSTMENTS continued 12 Changing Harness Strap Slots (fig. d) : Harness straps must be through slots at or just below shoulders. • Press Ta b to release metal Rod and lift Rod out of side Pockets . • Slide metal Rod out of Loops of harness straps.
Loops Ta b 13 Rod Openings Clip Pockets 5-Point Models (fig. d) (fig. e) Slots.
VEHICLE SEA T BEL TS 14 T o provide the most secure installation of the car seat: • Read the vehicle owner’ s manual regarding car seat installation and seat belt use with car seat. • Follow all instruction labels on vehicle seat belt and car seat.
V ehicle seat belts located for ward of seat crease may not securely hold car seat. Check vehicle owner’ s manual or see vehicle dealer for car seat installation requirements. • If approved for use with car seat, install car seat and check for secure installation by pulling car seat front to back.
Lap belts with retractors may or may not hold a car seat securely . Follow these steps to determine if you have a retractor system that will hold car seat securely: a. Pull belt all the way out. b. Allow belt to retract about 6 inches (15 cm). c. Pull out on belt again.
17 DO NOT use with any car seat. ❃ Passive Restraint - Lap Belt with Motorized Shoulder Belt DO NOT use with any car seat. Belts will not stay tight while driving.
18 VEHICLE SEA T BEL TS continued Pull on latch plate (fig. a) . If belt slides freely through latch plate, a locking clip MUST be used (see Locking Clip section). Some combination lap/shoulder belts with sliding latch plates may be converted into an “automatic locking mode” that will allow use without a locking clip.
Re-buckle seat belt. T est installation to see if car seat is secure. If not secure, additional belt tightening may be required. Remove locking clip and repeat steps 1 through 5. HINT : Tighten vehicle seat belt by pressing base or car seat further down into vehicle seat cushion.
20 SHOPPING CART USE Prevent injuries from falls: • Make sure car seat locks onto cart. • Avoid tip over of cart. Use caution on turns and irregular and ramped surface. • Never leave child unattended. W ARNING Deep Basket Shopping Cart: Lower car seat into child seat area of shopping cart and position hook to lock over cart wire (fig.
21 ADDITIONAL INFORMA TION Century advises against loaning or passing along car seat. Prevent serious injury or death: • Buckle must be properly latched. • Periodically inspect and clean buckle to remove objects or debris that could prevent latching.
Store instruction manual behind these tabs. If a part is damaged, missing, or you need help or replacement parts, DO NOT return car seat to the store. CALL US FIRST Call toll-free 1-800-837-4044 or 330-963-2800 8:00 AM to 6:00 PM E.S.T . Monday through Friday .
Ein wichtiger Punkt beim Kauf des Geräts Century PM-1016AA (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Century PM-1016AA noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Century PM-1016AA - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Century PM-1016AA reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Century PM-1016AA erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Century PM-1016AA besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Century PM-1016AA verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Century PM-1016AA. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Century PM-1016AA gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
