Benutzeranleitung / Produktwartung 8353 des Produzenten Calphalon
Zur Seite of 25
FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. If odor continues, immediately call your gas supplier or your fire department. FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
2 IMPORTANT SAFEGUARDS FAILURE TO FOLLOW THESE SAFEGUARDS COULD RESULT IN DEATH, SERIOUS BODILY INJURY, AND/OR PROPERTY LOSS. READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY OR USE OF THE LP GAS GRILL. 1. WARNING! Read and follow all instructions.
7. WARNING! If your grill catches on fire: 8. Check the inside body of your grill for grease buildup. Remove excess grease to avoid a grease fire in the bowl.
— NOTICE — AMG STRIVES TO BE A QUALITY SUPPLIER OF CONSUMER PRODUCTS. IF WE INADVERTENTLY OMITTED ANY PARTS NEEDED FOR ASSEMBLY OR YOU NEED TROUBLESHOOTING INFORMATION, PLEASE CONTACT US USING OUR TOLL FREE NUMBER. THANK YOU FOR PURCHASING AN AMG PRODUCT.
GRILL PARTS LIST 5 1. 03.4074.00 Spacer, Body 8 ea. 2. 03.4100.00 Handle 1 ea. 3. 03.4101.00 Bolt M5X15mm 3 ea. 6. 03.4104.00 Wing Nut M8 1 ea. 5. 03.4103.00 Heat Indicator 1 ea. 4. 03.4102.00 Handle Spacer 1 ea. 10. 03.4111.00 L. Side End Cap 1 ea. 9.
NOTICE: Be careful and do not set the Grill Body on the Manifold Extension. Bending or damaging this connection can make the grill unusable. •Remove The contents from the grill. •Remove all packing materials from •Use the Packing Blocks to support the grill until ready to assemble.
7 •With Base upside down, screw Caster Assembly (Item 28) into Caster mounting hole. Rotate clockwise to tighten. •Place Base right side up. place with 2 M6 X15 bolts as shown. No nuts are required. •Assemble other half of Pedestal to Base. (Item 37) M6 X 15mm Actual Size 6 Pcs.
8 STEP 3 - Assemble the Grill Body •Place Body on Pedestal. Caution: Do not leave grill unattended until bolts are secured. •Attach Cylinder Retaining Wire (Item 26) through hole in back of Pedestal as shown in detail. Step 2 - Continued •Make sure contents of grill have been removed for easy lifting.
9 •From the inside of the grill, secure Body to Pedestal using 4 M6 X 15 screws through the holes as shown above in Fig. A , securing with 4 M6 nuts from below as shown to the right in Fig. B . Caution: Do not leave grill unattended until bolts are secured.
•Place Foil Pan (Item 32) in Grease Tray (Item 33) and slide Grease Tray all the way into brackets. STEP 5 - Install Grease Tray •With Handle (Item 2) positioned as shown, place felt Handle Spacer (Item 4) between Handle and Hood, then insert locating pin into top holes of Spacer and Hood.
11 11 Item 20 M6 X 30mm Actual Size 8 Pcs Item 29 M6 Nut Actual Size 8 Pcs Item 1 Body Spacer Actual Size 8 Pcs Notice: The control panel cover can be opened by gently pulling down on the top of the cover.
FIG. 6B Burner Locator Hole in lower shoulder of rear firewall Burner Peg FIG. 6A Item 27 COTTER PIN Item 34 BURNER Holes in Front Firewall Gas Nozzle Control Valve Gas Collector Plate and Electrode V.
13 COOKING GRIDS CERAMIC BRIQUETTES TRAYS STEP 8 - INSTALL CERAMIC BRIQUETTE TRAYS/ COOKING GRIDS •Remove plastic completely from two Ceramic Briquette Trays (Item 36). Place Briquette Trays side by side on middle shoulder of front and rear firewall over the Burners.
14 Step 10 - LEAK TESTING (TO BE PERFORMED IN A WELL-VENTILATED AREA) Supplies Needed for a Leak Test Clean paint brush, water, and dishwashing liquid detergent. How to perform a leak test Warning! Never use an open flame to test for gas leaks. 1) Mix one cup of water with one cup of dishwashing liquid detergent.
15 OPERATING AND MAINTAINING YOUR GAS GRILL GAS, CYLINDER, HOSE AND REGULATOR INFORMATION This LP gas grill was designed to use propane gas. Propane cylinders will supply gas all year round, even on cold winter days.
16 How to Connect your LP gas cylinder (See STEP 9 of Assembly Instructions for diagram) 1) Make sure all of the control panel knobs are turned to the “off” position and verify that the LP gas cylinder valve is closed by turning the handle on the LP gas cylinder valve clockwise until it stops.
17 · Always perform a leak test before each use. · Leak test must be performed in a well ventilated area. · Never perform a leak test on a grill while in use or hot. · If you detect a gas leak that cannot be corrected by using the leak test procedures below, do not use the LP gas grill.
· Wash the porcelain coated Cooking Grids with a mixture of hot water and soap. · Empty the foil pan and grease tray after each cook - ing session so excessive grease does not accumulate. Failure to remove grease may result in grease dripping onto the cart and/or a grease fire in the tray.
· Open Hood before lighting the grill to prevent an explosion from gas build-up. · Always inspect the gas hose and regulator assembly before each use. If the hose is cut, damaged, or showing signs of excessive abrasion or wear, do not use the LP gas grill.
Your burners have been preset by the manufacturer for optimal flame performance. A blue flame, possibly with a small yellow tip, is the result of the optimal air and LP gas mixture.
Regularly clean your LP gas grill between uses and espe - cially after extended periods of storage. Ensure the grill and its components are cool before cleaning.
TROUBLESHOOTING Problem Possible Cause Solution Burners will not light using the igniter Burners not assembled cor - rectly Not pausing long enough before clicking the control panel knob No spark LP g.
TROUBLESHOOTING Problem Flames blow out Flare up Persistent grease fire Unable to fill LP tank Humming or whistling from the regulator Possible Cause High or gusting winds Gas in LP cylinder is low Ex.
24 IMPORTANT NOTICE IMPORTANT NOTICE The Gas Grill is setup to operate with a LP Gas Cylinder equipped with an OPD (Overfilling Prevention Device). This is a secondary device to prevent the overfilling of your LP Gas cylinder. The proper methods for the filling of your LP Gas cylinder are by weight or volume, as described in NFPA 58.
Calphalon Grill LIMITED WARRANTY This product is warranted to the original consumer purchaser against defects in material and workman - ship under normal outdoor household use and correct assembly (if assembled by the consumer-pur - chaser).
Ein wichtiger Punkt beim Kauf des Geräts Calphalon 8353 (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Calphalon 8353 noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Calphalon 8353 - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Calphalon 8353 reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Calphalon 8353 erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Calphalon 8353 besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Calphalon 8353 verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Calphalon 8353. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Calphalon 8353 gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
