Benutzeranleitung / Produktwartung MCPA des Produzenten Bunn
Zur Seite of 20
USE AND CARE OF YOUR My Café ™ T ea & Coffee Pod Brewer P2896 Model MCP A COMMERCIAL AND HOUSEHOLD TYPE The Bunn logo is a registered trademark of Bunn-O-Matic Corporation.
2 Hazardous Voltage! Can Cause Fire Or Electrical Shock! Do Not Disassemble The Brewer! There Are No User Serviceable Parts Inside! The only user replacement parts are shown on page 19. Repair Should Be Done By Authorized Service Personnel! T ABLE OF CONTENTS WARNINGS .
3 USER NOTICES Carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices on the equipment should be kept in good condition. Replace any unreadable or damaged labels by visiting our web site at www .
4 IMPOR T ANT SAFEGUARDS Follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • Read all instructions. • Do not touch hot surfaces. Use handles or knobs. • T o protect against electric shock, do not place cord, plug, or brewer in water or liquid.
5 • Use CAUTION when dispensing hot water from the brewer . The water from your BUNN ® Pod brewer is approximately 93°C (200°F). This is approximately 10°C (50°F) hotter than the hot water from your faucet and must be handled with care.
6 FIG 1. Exploded View FIG 2. Control Panel WA TER RESERVOIR SLIDE LID POD HOLDER RELEASE BUTTON POD HOLDER INSERT POD HOLDER DRIP TRA Y GRA TE DRIP TRA Y POWER SWITCH CONTROL P ANEL VOLUME CONTROL SL.
7 DEFINITIONS COMPONENTS • WA TER RESERVOIR - Holds reserve water for brewing. The reser voir can be removed and filled separately at a sink or other clean water source or by pouring water through the slide lid. (Holds 1.7 L (46 oz.) to the maximum line.
8 • HEA TING INDICA TOR - This light indicates that the heater is bringing water up to temperature. A brew cycle cannot be started until the indicator has gone out. (During a brew cycle, this light will come on indicating the tank heater is warming the new water entering the tank.
9 INITIAL BREWER SET -UP 1. Remove the lid and water reservoir . (CAUTION: Do not place the brewer in a sink or other water source.) 8. Place a mug or bowl that will hold at least 414 ml (14 fl. oz.) onto the drip tray grate. 4. Replace the reservoir and lid and close the slide lid.
10 BREWING DELICIOUS COFFEE OR TEA (CAUTION: Do not place brewer in sink or other water source.) (NOTE: Minimum volume is approx. 118 ml (4 oz.) Maximum is approx. 355 ml (12 oz.) Settings are in 30 ml (1 oz.) increments.) 5. Place a mug, larger than the volume selected, on the drip tray grate below the pod holder outlet.
11 HOT W A TER The same basic steps used to brew coffee or tea can be used to obtain hot water by leaving the coffee pod or tea bag/pod out of the pod holder . CAUTION: The water from your BUNN ® Pod brewer is approximately 93°C (200°F). This is hotter than the hot water from your faucet and must be handled with care.
12 ROUTINE CLEANING Before beginning any cleaning procedure, unplug the brewer to avoid the accidental start of a brew cycle. Clean the pod holder , drip tray and drip tray grate after each use, using a damp cloth and mild detergent and rinse.
13 8) When the cycle has finished, empty the cup. Repeat step 7 at least two more times to remove the solution from the tank. 9) Clean the pod holder with a mild detergent and rinse thoroughly . 10) Proceed to the “Cleaning The Sprayhead/Seal” section.
14 INSPECTING THE SPRA YHEAD SEAL When disassembling your brewer for cleaning, inspect the sprayhead seal for cracks, tears and holes. Although the seal should last for an extended period of time, damage can occur through handling. CAUTION: The seal confines the hot liquid to the pod holder .
15 TROUBLESHOOTING SITUA TION EXPLANA TION Nothing happens when the COFFEE BUTTON or TEA BUTTON is pressed. This is the first time you have used your brewer . The Initial Brewer Set-up procedure must be performed first. Please follow the directions on page 9 before attempting to run a brew cycle.
16 SITUA TION EXPLANA TION The REFILL WA TER INDICA TOR has come on. The POD HOLDER INDICA TOR has come on. The water shuts off and comes back on again when brewing. The WA TER RESERVOIR has run low on water . Slide the lid open and pour additional water into the reservoir , or remove the reser voir and fill it at a sink, or other water source.
17 TROUBLESHOOTING (Cont.) SITUA TION EXPLANA TION The Pod Holder will not come out of the brewer . Water is appearing on the counter around the base of the brewer . Water leaks out around the sprayhead. The pod in the POD HOLDER may have swelled to a point where the holder does not slide out easily .
18 SITUA TION EXPLANA TION The BUNN ® (POD HOLDER RELEASE BUTTON) indicator is not on all of the time. The HEA TING INDICA TOR comes on when the COFFEE or TEA button is pressed.
19 BUNN ® REPLACEMENT P ARTS SLIDING LID Dishwasher Safe. POD HOLDER Dishwasher safe. WA TER RESERVOIR Holds 1.7 L (46 oz.) of fresh water for quick brewing. Dishwasher safe. DRIP TRA Y AND GRA TE Dishwasher safe. Catches up to 177 ml (6 oz.) of liquid.
20 LIMITED W ARRANTY Bunn-O-Matic Corporation (“Bunn” or “we”) warrants to the original user (the “buyer” or “you”) of this Pod Brewer that the Pod Brewer is free from defects in material and workmanship existing at the time of manufacture and appearing within two years of the date of original purchase of the Pod Brewer .
Ein wichtiger Punkt beim Kauf des Geräts Bunn MCPA (oder sogar vor seinem Kauf) ist das durchlesen seiner Bedienungsanleitung. Dies sollten wir wegen ein paar einfacher Gründe machen:
Wenn Sie Bunn MCPA noch nicht gekauft haben, ist jetzt ein guter Moment, um sich mit den grundliegenden Daten des Produkts bekannt zu machen. Schauen Sie zuerst die ersten Seiten der Anleitung durch, die Sie oben finden. Dort finden Sie die wichtigsten technischen Daten für Bunn MCPA - auf diese Weise prüfen Sie, ob das Gerät Ihren Wünschen entspricht. Wenn Sie tiefer in die Benutzeranleitung von Bunn MCPA reinschauen, lernen Sie alle zugänglichen Produktfunktionen kennen, sowie erhalten Informationen über die Nutzung. Die Informationen, die Sie über Bunn MCPA erhalten, werden Ihnen bestimmt bei der Kaufentscheidung helfen.
Wenn Sie aber schon Bunn MCPA besitzen, und noch keine Gelegenheit dazu hatten, die Bedienungsanleitung zu lesen, sollten Sie es aufgrund der oben beschriebenen Gründe machen. Sie erfahren dann, ob Sie die zugänglichen Funktionen richtig genutzt haben, aber auch, ob Sie keine Fehler begangen haben, die den Nutzungszeitraum von Bunn MCPA verkürzen könnten.
Jedoch ist die eine der wichtigsten Rollen, die eine Bedienungsanleitung für den Nutzer spielt, die Hilfe bei der Lösung von Problemen mit Bunn MCPA. Sie finden dort fast immer Troubleshooting, also die am häufigsten auftauchenden Störungen und Mängel bei Bunn MCPA gemeinsam mit Hinweisen bezüglich der Arten ihrer Lösung. Sogar wenn es Ihnen nicht gelingen sollte das Problem alleine zu bewältigen, die Anleitung zeigt Ihnen die weitere Vorgehensweise – den Kontakt zur Kundenberatung oder dem naheliegenden Service.
